Factory X prepares two (2) inductive coils to be used in a drilling operation. It’s goal is to use these two (2) coils to be connected in series as one coil cannot stand to operate alone. The coils when connected across 240 V takes a current separately with values 2 A and 3 A, respectively. When a wattmeter was connected across each coil during the testing, it has indicated 160 W and 500 W, respectively. Calculate for the total power.

Q: 1. 500 VA -120/240 -120/240-60HZ 1) Turns ratio (n) 2) Isec 37 I pr.

A: The apparent power, The voltage ratio, 120/240 VThe frequency,

Q: Quèstion 7 Mutual inductance between an infinite current filament placed along y -axis and…

A: Consider the formula for the mutual inductance for the given diagram is, M=Nμ02πylnx2x1 Here, x2 is…

Q: The hot water heater in our homes is an example of closed-loop system O Open-loop system none of the…

A:

Q: 100mH inductance is connected with a 200ohms resistor in series. If the voltage is 220volts, what is…

A:

Q: Calculate the value of RB in ohms. at VCC=17 V, IB=28 uA, and VC=7V and B=77

A: The given circuit diagram is shown below:

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,251 ohms R2 =…

A:

Q: In a resistive load, the current angle

A: In the question, The current angle when load is resistive type.

Q: A 60Hz voltage source of 35 V is applied to a circuit with a 257 ohm resistor, a 0 H inductance…

A:

Q: The ratio of % reactance at rated kVA to the % reactance at base kVA is equal to

A: We need to tell the correct option for the given blank in the given statement.

Q: Determine the required peak reverse voltage rating in the following circuit. R₁ 1 ΚΩ www Vs 200 Vpk…

A: Peak Reverse voltage:  Peak reverse or peak inverse voltage is the maximum voltage across the diode…

Q: Calculate average load voltage of the circuit if C=0 and a = 5 and RL= 470 ohms. 中 220V GOHZ DI C R…

A:

Q: 91 My two ears want current, resistance, inductance, and capacitance For a source voltage of 100 92…

A: The circuit diagrams,

Q: Question 11 An alternating current is given by 1 = 22sin222t. What is the time to generate 3 cycles…

A:

Q: A flux of 18 mWb links with a 1100 turns coil, when a current of 18 A passes through the coil. The…

A: Given that  Flux = 18 m Wb No. of turns = 1100 turns  Current  = 18 A  Energy stored in inductor can…

Q: Connecting an ammeter and voltmeter to a series Resistive Capacitive circuit powered by a 60 Hz line…

A: Resistance and capacitor circuit Connecting an ammeter and voltmeter powered by a 60 Hz line…

Q: Three inductors are connected in a 208-volt, 60 Hz circuit. The circuit current is 1.2 amperes.…

A: In the question  Three inductors are connected in a 208-volt, 60 Hz circuit. The circuit current is…

Q: What the voltage falling on the coil in the circuit shown in the figure

A: What is the voltage falling on the capacitor in the circuit shown in the figure?  This problem is…

Q: 1H 2H epece 0.5 H 2H Question: Detenmine tue cauivalent inductamce of he cincuit Show in above…

A: For the given Circuit with inductances, Equivalent inductance of the circuit is determine as shown…

Q: Vc RB RC Q1 NPN +88 8 Volts VC

A: From the above diagram, IB = (Vcc-VBE)/RB  => RB = (Vcc-VBE)/IB

Q: device may be used for extending the range of voltmeter . O shunts O series multiplier current…

A:

Q: 2) For the circuit shown in Figure (2): Calculate the total current Ir a) 90 A b) 75.5A 31A 15A e)…

A:

Q: A 100 kva load operates at 0.75 lagging power factor when connected to a 230v, 60hz AC source. The…

A: Given load is 100 kVA Power factor is 0.75 lagging. Power factor angle is 41.409 degrees.

Q: Calculate the value of RB in ohms. at VE=4V, RE=258 ohm, IB=11uA, RC=2318ohm and VCE=7V

A: Calculate the value of RB in ohms.   at VE=4V, RE=258 ohm, IB=11uA, RC=2318ohm and VCE=7V

Q: An inductance is connected to a 230 V, 40 Hz mains and takes a current of 4.5 A. What current will…

A:

Q: b- An alternating voltage is described by V(t) = 220 sin(500t) Volt. I-Draw the V(t), II- Find the…

A: Given data, An alternating voltage is given as, Vt=220sin500t V.

Q: direct current generator operates on the basis of   Lenz’s law   Ohm’s law   Faraday’s law of…

A: A dc current generator works as fallows: Whenever a conductor placed in fluctuating magnetic field…

Q: Full explain this question very fast solution sent me step by y The transformer has a turns ratio…

A: given that full wave bridge rectifier with input transformer input voltage  V = 120 V (rms)…

Q: The hot steam from the turbine is converted in to water in

A: The hot stream from turbine is converted in to water in condenser

Q: Vc RB RC Q1 NPN +88.8 RE Volts VE

A:

Q: Three coils each having resistance of 25 n are connected in star across 415 V, 50 Hz supply. Then…

A:

Q: What is the continuous time signal corresponding to the Fourier transform X(jw) = 3r[8(w-2)-8(w+2)]?…

A:

Q: 2. A series circuit consisting of a variable resistor in series with a capacitor of 80 μF capacitor…

A: The required parameters can be calculated by using the total impedance of the series connected…

Q: Using the formulas found in question 1, compute the amount of capacitive  current  needed in the…

A: Power Factor Correction is a technique that uses capacitors to reduce the reactive power component…

Q: Three coils each having resistance of 17 Q are connected in star across 415 V, 50 Hz supply. Then…

A: The power consumed in a 3 phase circuit is  P=3Vl2R=3Il2.R Vl = 440 volt R=17 ohm

Q: Three coils each having resistance of 14 N are connected in star across 407 V, 50 Hz supply. Then…

A: Given, Line voltage, VL= 407 V so, phase voltage, Vph= 234.98 V Resistance, R= 14 ohm

Q: Lesson: Alternating Current Circuit what is the total current with the following given currents:…

A: We need to select correct option for given currents .

Q: A circuit with a resistor and a capacitor in series takes 227.6 watts at a power factor of 0.513…

A: It is given that: P=227.6 Wcosϕ=0.513V=220Vf=50 Hz

Q: Calculate the value of RB in ohms. at VE=4V, RE=363 ohm, IB=13uA, RC=2176ohm and VCE=11V

A:

Q: The maximum value of an alternating voltage is 300 V. It takes 20 ms for one cycle. So write the…

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.