F143 Determine the equivalent state of stres on anclement at the same point that represents the principal strewesat the point 1. Alsa, find the curresponding arlentation ofthe clement with respect to the eloment shown.30 kPa80 kPa

Given data To determine the equivalent state of stress of the element At the same point…

Answered: F143 Determine the equivalent state of…

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter9: Moments And Products Of Inertia Of Areas

Section: Chapter Questions

Problem 9.40P

See similar textbooks

Similar questions

Urgent Please...
The given system · has Jaccuracy.
.Find Momer 160 N 200 N 30- 100 200 min 30 150 N A
The pressure of the air in starting air vessel is 40 bar and the temperature is 24 oC. If a fire in the vicinity causes the temperature to rise to 65 oC, find the pressure of the air. Neglect any increase in the volume of the vessel.
I need the answer as soon as possible
In a reciprocating air compressor, high pressure air in the cylinder pushes the piston against the external load and expand to a lower pressure. In a test the following measurements were noted:Internal energy of air before expansion = 27 kJInternal energy of air after expansion = 8 kJHeat entering the cylinder during the process = 2 kJSHOW THE DIAGRAM USING THE GIVEN PROVIDED
i need the answer quickly
Find the mass of steel when it is added with 173 Kcal of heat and its temperature is raised to 150 0C.
(3) Show that the volume dependence of internal energy is written as Cp – Cy -p. | aV T
80 min 200 mm 11. The figure shows a high-pressure hand pump used for boosting oil pressure in a hydraulic line. When the handle is in equilibrium at theta=15 deg under the action of a force P-120 N, determine the oil pressure p which acts on the 46 mm diameter piston. (Pressure on the top of the piston is atmospheric). 200 mm piston. Ans: P=0.27 MPa mm
Determine R at point C in N
3.1 If y = and w is increasing by 2%, s is decreasing by 3% and d is increasing by 1%. calculate the maximum percentage eror in y. %3D 3.2 The volume of a certain figure is given by V = In(x sin z + y z). Evaluate the change in V at (x;y;z) = 10;5; given that x and z decrease by 0,03cm and 0,1 rads, respectively, and y increases by 0,01cm.

SEE MORE QUESTIONS

Recommended textbooks for you

International Edition---engineering Mechanics: St…

Mechanical Engineering

ISBN:

9781305501607

Author:

Andrew Pytel And Jaan Kiusalaas

Publisher:

CENGAGE L