F11-5. Determine the minimum dimension b to the nearest mm of the beam's cross section to safely support the load. The wood has an allowable normal stress of oalow = 12 MPa and an allowable shear stress of 7allow = 1.5 MPa. 50 kN 5 kN-m 5 kN-m B 3b F11-5

Q: 13-43. The coefficient of static friction between the 200-kg crate and the flat bed of the truck is…

A: The coefficient of static friction is The mass of crate is The initial velocity is The final…

Q: if the basket at E weighs 3.5 N, determine the weight if crate f and the unstretched length of the…

A: Introduction In this problem we will calculate the weigth of the crate and the unstrength length of…

Q: Determine the stretch in spring AC for equilibrium of the 1.8 kg block. The springs are shown in the…

A: Given Data:- Mass of Block (m)=1.8 kg Spring Constant KAC =  20 N/m Spring Constant KAB = 30 N/m To…

Q: 5-9* Three bodies with masses of 2, 4, and 6 slugs are lo- cated at points (2, 3, 4), (3, -4, 5),…

A: Given Data: The mass of body 1 is m1 = 2 slug. The mass of body 2 is m2 = 4 slug. The mass of body…

Q: Determine the speed at B if A is pulled down with a velocity of V₁ = 14¹ S B VB? A

A: VA = 14 m/s

Q: A train follows the v-t diagram below. The train starts at rest atit-0. Determine the following A…

A: Given:The V-t diagram shown below:In V-t graph, the distance traveled is equal to the area under the…

Q: 8-30. The wheel is subjected to a torque of M = 50 N If the coefficient of 0 kinetic friction…

A: Draw FBD

Q: 10-128 Determine the second moments Ix and Iy for the shaded area shown in Fig. P10-128. y = 200x 40…

A: Consider the diagram shown below for the strip of the element in the shaded region.

Q: 16-66. Detefmine the Feactions at the suppolts A and B. El is constant M. -L-

A: The free-body diagram of the cantilever beam is as follows.

Q: 11-21 Two spheres are supported with slender rods as shown in Fig. P11-21. Determine the angle e for…

A: Given Data: The mass of sphere A is mA = 25 lb. The mass of sphere B is mB = 10 lb. The…

Q: 12-214. If the truck travels at a constant speed of VT = 6 ft/s, determine the speed of the crate…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.