F.1. Which of the following terms does not describe one of the uses of an MR lamp? A. Display lighting B. A narrow spot C. An extra wide flood D. Accent lighting F.2. If you operate a 130 V lamp in a 120 V service, the lamp life will A. immediately be terminated. B. increase. C. stay the same. D. decrease. F.3. Which of the following lamps does not require a ballast to operate? A. A mercury lamp B. An incandescent lamp C. A metal halide lamp D. A high-pressure sodium lamp

Q: Using spray arc transfer, amperes are used with a 0.045" (1.1mm) electrode to weld stainless steel.…

A: Spray arc are generally the droplets which are around the arc to the weld pool used to increase the…

Q: What is the purpose of shunt resistors in an ammeter? A. To shorten the range of the ammeter. B.…

A:

Q: 79. Which of the following formulas can be used with Ohm's law to determine the amount of voltage…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Refer to the circuits of Figure 5–69: a. Find the values of the unknown resistors. b. Calculate the…

A: In the equivalent circuit all the three resistor and the voltage source are in series with each…

Q: 3.a. In the event of an HID lamp outage, which of the following is the correctly ordered checklist…

A: 1) In the event of an HID lamp outage, which of the following is the correctly ordered checklist is…

Q: 21. What type of resistors can only have one ohmic value?   Select one: A. COMPOSITION B. FIXED…

A: Fixed type of resistor can have ohmic value and it has only single value resistance.

Q: 1.a. If an environment may contain moisture, you should use lamps with bases that are made of A.…

A: 1 a . Moisture in environment means metal can be corrosive . So we have to select the base which…

Q: in which part o NEC article 690 provides requirements for installation of disconnect in a…

A: NEC stands for National Electrical Code and NEC Article 690, Solar Photovoltaic Systems, provides…

Q: Identify and describe the operations of all major equipment used in substations

A:

Q: You have an LED night light without a photocell control with the following information: It draws…

A:

Q: A 14/2 type NM copper used for a general lighting branch circuit Ampacity : Maximum fuse or circuit…

A: Circuit breaker:- Circuit breakers are used for safety purpose in electrical equipment. It is used…

Q: 7.b. Which of the following is not a brand name of a high-pressure sodium lamp? A. Multi Vapor. B.…

A:

Q: 7.a. What size diameter is a T-12 fluorescent lamp? A. 6 inches B. ½ inch C. 3 inches D. 1½ inches

A: T 12 florescent lamp :  The T12 is  older generation fluorescent bulb that generates light using…

Q: H.a. What is the efficacy of a 1,000 W PAR-64 halogen lamp with rated lumens of 19,400? A. 303.1 B.…

A: H .a )  Given  Power = 1000 watt Luminous flux = 19400 lumen

Q: Question 27 To turn on all the LEDS with the instruction "OUT AL, 7B", AL should be first set to 7B…

A: Given OUTAL 7B So AL will assign 7B value

Q: Calculate the minimum main protection for 6 A/C air conditioners, their main conductors and the…

A: Step 1:

Q: Two 36 cell PV modules are connected in series. One is shaded and the other is fully illuminated,…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.