Explain with suitable example the relationship between co-channel reuse ratio, cluster size and signal to interference ratio.
Q: A laser resonator consisting of two mirrors with reflectivity R1=1 and R2=D0.95 respectively,…
A: Given: R1 =1 R2 = 0.95 effective medium length = 0.1 m spontaneous emission lifetime 10-6 sec A…
Q: Researcher S. Nakamura received the 2014 Nobel Prize in Physics for the development of the blue LED.…
A: Given: Wavelength : 430 nanometers Material : Gallium Nitride
Q: Given the following information about the Diamond; lattice constant 3.56 A. the speed of sound in…
A:
Q: What is the transparency coefficient for one-dimensional potential barrier and its formula?
A:
Q: What is the maximum filtering velocity for Carbon fumes in Pulse-Jet Baghouses?
A: Given: To define the maximum filtering velocity of the carbon fumes is given as,
Q:
A:
Q: An early LiDAR system was used to measure the distance to the moon. This system used a wavelength of…
A: (a) The time for the laser pulse to make a round trip can be calculated using the formula: time = 2…
Q: Calculate the percentage efficiency of a solar PV module whose length is 136 cm and width is 106 cm…
A: Area of solar panel = 1.36×1.06 m2 =1.4416 m2 Total solar energy received = 1115×1.4416 =…
Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz plz plz.
A:
Q: A communication system uses low noise front-end receiver as shown in the Figure below. The antenna…
A:
Q: Note: - You are attempting question 6 out ( Determine the attenuation of a fifth order Chebyshev…
A:
Q: A 16384-point discrete fourier transform is used to evaluate the power spectral density of a signal…
A: The frequency resolution is defined as Fs/N in FFT, Where Fs is sample frequency, N is number of…
Q: Q5) A satellite in geostationary orbit at (36000 km) has a (4 GHz) downlink transmitter which feeds…
A: Given Radius R = 36000 km = 36×106 m Frequency f…
Q: Find the change in radar cross section area of a cylindrical aero plane at different frequency…
A: The radar cross-section for the cylindrical airplane, normal to axis be defined as, Where a be…
Q: How does the IR exposure affect the histogram and look-up table in a digital system
A: Histogram It is image processing technique used to identify the edges of image and access the raw…
Q: Why is control of column and detector temperature more impo suppressed IC than it is for suppressed…
A:
Q: plot the spectrum for full Vm wave rectifier and find the band width 0.2 C14
A:
Q: 1) Time-of-flight: Suppose that you have a time-of-flight mass spectrometer with a detector that can…
A: Given: The given details are, Suppose that you have a time-of-flight mass spectrometer with a…
Q: Calculate the percentage efficiency of a solar PV module whose length is 137 cm and width is 107 cm…
A:
Q: 1. Consider a receiver with a 4-dB noise figure and a 2-MHz bandwidth. If a carrier-to-noise ratio…
A:
Q: Explain the Nature of probe spacing for vibroflotation ?
A: Given: To explain the nature of the probe space for vibroflotation as,
Q: For a category-5e twisted pair the far end cross talk is if the cross-talk nea and the equal level…
A: FEXT = 20*log*( Vx talk / Vo ) Attenuation = 20* log ( v1/v0)
Q: (1) A signal m(t) band-limited to 3kHz is sampled at a rate 100/3% higher than the Nyquist rate. The…
A: question rejected under wrong subject
Q: What is the angle from we get the maximum c voltage in three phase
A:
Q: Can you get a dark-field image for mass–density contrast? What is the main difference of dark-field…
A: Yes we can get te dark field image for the mass density contrast. TEM has an objective aperature…
Q: For a BJT , if the Q-point was at the upper part of the load-line with normal 2 sources bias; if IB…
A:
Q: The maximum number of bits which a noisy channel can carry = B log2 (1 + S/N) with B = channel…
A: The maximum number of bits carried by noisy channel is given by N=Blog21+SN Where SN is signal to…
Q: A signal is sampled at 384 000 samples per second. The samples are encoded as 32-bit words a)…
A: Given that and
Q: Also discuss the difference between multi mode Step index and multi mode graded optical fiber cable…
A:
Q: As light increases, the resistance of LDRs __ - and vice versa.
A:
Q: If the dark saturation current of a solar cell is 1.7X108 A/m², the cell temperature is 27 °C, and…
A: If the dark saturation current of a solar cell is 1.7X10-8 A/m², the cell temperature is 27 °C, and…
Q: the magnete fietd nkensity B at Point a given by Show that VxB Maj %3D Maxwell eguatioN using DxE =…
A: Given, B→=μ04π∫J→×r→r3 dV r=R→-R'→we have, ∇→1r=-r→r3B→=-μ04π∫J→×∇→1r dV∇→ is done with respect…
Q: 6.9. A thin film of BCC structure (a = 4.0 Å) was deposited on a (001)-oriented substrate of FCC…
A: Answer:— A/c to Bragg's law we have 2dhklSin = n In the above problem we have two type of d h k l…
Q: Calculate the expected duration of mode-locked pulses in a Nd:YAG laser operating at 1.06 m, with a…
A: Concept: The Formula to determine the expected duration of mode-locked pulses will be…
Q: An x-ray unit is operated with three pha voltage at 80 kVp, 750 mA tube current,for time of 100 ms.…
A:
Q: The conerence lengtn of an ordinary white lignt Source Can be Increased It We Place a culor HIter in…
A: Coherent lenght L=0.1060nm Minimum wavelength=648nm
Q: if i had a d-spacing of 0.82nm, 0.47nm for a biological hydroxyapatite and i want to find the miller…
A: The steps listed below can be used to get the Miller indices for a crystal plane without applying…
Q: With the support sketch and example calculation, please explain why Vrms is more important than…
A: Here ,Vrms stands for root-mean-square voltage whereas Vpeak stands for peak voltage.Vrms is…
Q: 2) a) What is the purpose of FTIR analysis? b) What information can FT-IR provide? c) List at least…
A: (a) The purpose of FTIR purpose. (b) The information provided by FT-IR. (c) The three advantages of…
Q: How large a collecting area would you need to collect 1 W from a 1 Jy source over a band- width of…
A: To determine: In order to gather 1 W from a 1 Jy source over a bandwidth of 109 Hz 1GHz, how big of…
Q: The increased bandwidth in multi-mode graded index optical fibers compared to multi-mode step index…
A: Intermodal dispersion in multimode fibers may be reduced by using refractive index profile which is…
Q: If a BJT is biased at active region, then : O Vce is max. ; lc is min. O Vce is min. ; lIc is max.…
A:
Q: A totally depleted silicon detector with 0.12-mm thickness is operated with large overbias so as to…
A: Given: d = 0.12 mm μe = 1350 cm2/Vs μh = 480 cm2/Vs
Explain with suitable example the relationship between co-channel reuse ratio, cluster size and signal to interference ratio.
![](/static/compass_v2/shared-icons/check-mark.png)
Step by step
Solved in 2 steps
![Blurred answer](/static/compass_v2/solution-images/blurred-answer.jpg)