Explain the following terms giving a suitable example for each :(i) Aerosol(ii) Emulsion(iii) Micelle

Q: 1. Look up and draw the structures for each of the following molecules: (a) glucose (b) naphthalene…

A:

Q: A student performed the experiment described in this module, using 6.00 mL of a 3% H2O2 solution…

A: Given, P1 = 30.30 in. Hg x (2.54 cm/1 in) x (10 torr Hg/1 cm Hg) = 769.62 torr Hg V1 = 65.40 mL =…

Q: Which of the following in each pair is likely to be more solublein water: (a) cyclohexane (C6H12) or…

A: The term miscible liquids can be defined as the liquids which when mixed together form only one…

Q: On the basis of polarity and hydrogen bonding, which solute would be the most soluble in benzene,…

A:

Q: Ionic liquids are a new class of organic salts that are liquids at low temperature (usually < 100…

A: Ans. Green aspects of ionic liquids: (a) The interest of ionic liquids (ILs) as “green” solvents…

Q: as been observed experimentally that the AHpolution for methanol as solvent and dimethylsulfo ISO)…

A: Methanol is not an ionic molecule and will not exhibit intermolecular ionic bonding. Methanol is…

Q: the molality of the following compounds is the same, which compound will have the highest boiling…

A:

Q: (a) sketch and label the two observed layers in an immiscible mixture of dichloromethane and water.…

A: The position of solvents in a immisible layer depends on the density and polarity of the solvents.…

Q: An “emulsifying agent” is a compound that helps stabilizea hydrophobic colloid in a hydrophilic…

A: Emulsifying agent is defined as the substance that helps in the formation of emulsion. These agents…

Q: Diffusion will occur when a solute in high concentration migrates to an area of low concentration…

A: In the given question, it is asked about the process of diffusion of solute in a system with varying…

Q: The density of grain alcohol is 0.789 g/mL. Given that thedensity of water at 48C is 1.00 g/mL, what…

A: The specific gravity of grain alcohol has to be given,

Q: State a reason of the following statement: (i) Soap do not work in hard water. (ii) The use of the…

A: (i) Soaps are the sodium and potassium salts of higher fatty acids. When soap is dissolved in hard…

Q: A common misconception about vapor pressure lowering is that the solute occupies some of the surface…

A: Vapor pressure lowering is the dercrease in pressure exerted by solvent molecules due to the…

Q: The following table presents the solubilities of severalgases in water at 25 °C under a total…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: The average osmotic pressure of blood is 7.7 atm at 25 °C. What molarity of glucose 1C6H12O62 will…

A: Given data, Osmatic pressure of blood is π=7.7 atm Temperature (T)=25°C=(25+273)=298 K Calculating…

Q: Which of the following in each pair is likely to be more soluble in hexane, C6H14: (a) CCl4 or…

A: We know that hexane is a nonpolar molecule and the substance which has less solubility will be more…

Q: What is Osmatic Pressure?

A: The pressure is equal to the force applied per unit area. A colligative property is a property that…

Q: O Calculate the mass of H2O2 in 5.00 mL of the H2O2 solution.

A:

Q: Of methanol, ethanol, propanol, butanol, which is the best solvent for ammonium?

A: It is defined as degree to which substances to dissolve in solvent to make solutions.

Q: Write one difference in each of the following:(a) Multimolecular colloid and Associated colloid(b)…

A: Answer to (a) Multimolecular colloids: When small molecules or atoms of particle size one-nanometre…

Q: Which of the following in each pair is likely to be more soluble in water: (a) cyclohexane 1C6H122…

A: Solubility of any substance means the mixing of one component into the other component. If the…

Q: Predict what would happen with respect to diffusion if evaporated milk containing sugar and milk…

A: A question based introduction to Chemistry that is to be accomplished.

Q: (a) Would you expect stearic acid, CH3(CH2)16COOH, to bemore soluble in water or in carbon…

A: a) Stearic acid is a saturated fatty acid. It has a bulky hydrophobic alkyl chain, which overpowers…

Q: Titus was dissolving his analyte and produceda colloidal type of precipitated. It indicates that:…

A: Precipitation is the process of formation of an insoluble solid in aqueous solution. The solid…

Q: What is the best explanation of this?

A: When soda bottle is opened up the CO2 is escaped out in the form of bubbles now we have to tell the…

Q: Which of the following statements is correct about the formation of emulsion? O Soaps and detergents…

A: Answer  Which statement is correct about the formation of emulsion…

Q: Methylene chloride ("proper" IUPAC name= dichloromethane) is considered a nonpolar solvent. Which of…

A: Dichloromethane is non-polar solvent.

Q: (A) Molar mass of Atrazine: 215.685 g/mol  Calculate the amount of Atrazine needed to prepare 100…

A: Given that, The molar mass of Atrazine is 215.685 g/mol, The molar mass of Glyphosate is 169.07…

Q: 2.6-2.7 Melting Points, Boiling Points, Solubility, and Intermolecular Interactions 2.43 Which ions…

A: Intermolecular forces are the forces existing between two different molecules, which determine the…

Q: 1-If 5.06 g of KNO3 is dissolved in 10.00 g water at 31 C°, then the solubility of KNO3in water is…

A: Given, The amount of KNO3 ( potassium nitrate) = 5.06 g The amount of H2O (water) = 10.00 g…

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.