Explain in detail the phenomenon and concept of the heat transfer involved in the heat exchanger and the way to enhance the heat transfer performance of the heat exchanger.

Q: To> 20°c vertical wall width - o.15m %3D calculate the rate of hect transfer due to pree convect.on…

A:

Q: Experimental analysis was carried out about turbulent convective heat transfer in trapezoidal…

A: In the question Re number is given & corresponding that values Nu number is also given . We…

Q: The shown high-pressure heat exchanger sold by McMaster-Carr, is promising 59,000 Btu/hr…

A: Write the given data with suitable variables. Q1=59000 Btu/hrT1=180 °FT2=85 °FT3=140 °FT4=100…

Q: A house has a composite wall of WOod, fiberglass insulation, and plaster board, as indicated in the…

A: The expression for the total thermal resistance of the house wall is given by as follows

Q: A one-dimensional plane wall is exposed to convective and radiative conditions at x = 0. The ambient…

A: Given:The ambient temperature, T∞=20oC=20+273=293 KThe surrounding temperature, Tsur=40oC=40+273=313…

Q: A long copper tube (O.D.=0.5 m and I.D.=0.45 m) is centered in a concrete block (square…

A:

Q: Hot air at atmospheric pressure and 80°C enters an 8-m-long uninsulated square duct of cross-…

A:

Q: Find the equivalent conduction resistance of the wall illustrated below. 0.5 m? Im? |(A) (C) |(D)…

A:

Q: A gas enters an insulated steady-flow system (fig. 9-3) at 200 kPa, 27°C, with an enthalpy of 214…

A: In this question concept of conservation of energy is used.  To find the enthalpy, SSFE equation is…

Q: GIVE AN EXAMPLE OF HOW TO ENERGY TRANSFER BY HEAT?

A: Let us consider example of Internal combustion(IC) engine fuels. In IC engines, fuels (gasoline or…

Q: An insulated, rigid tank whose volume is 0.5 m³ is connected by a valve to a large vessel holding…

A:

Q: A dormitory at a large university, built 50 years ago, has exterior walls constructed of Ls =…

A:

Q: A student living in a 4-m x 6-m x 6-m dormitory room turns his 150-W fan on before she leaves her…

A:

Q: Why do we calculate/measure power? (From engines, electricity, etc.)

A: Measuring power of different equipment is so important due to following reason  ,

Q: Engine oils enters a 14 mm internal diameter thin aluminum tube of a heat exchanger at 20°C at a…

A:

Q: The cake mix, whose initial temperature is 25°C, will be baked at 120°C in a cylindrical mold. It…

A: Given: The initial temperature is Ti=25°C. The baking temperature of cylindrical mold is Tf=120°C.…

Q: A classroom that normally contains 40 people is to be air-conditioned with window air-conditioning…

A:

Q: Conduction is the process of transferring thermal energy through

A: In the given statement, it is asked about the conduction mechanism.

Q: The rear window of an automobile is defogged by passing warm air over its inner surface. If the warm…

A: Given:The inner warm air temperature, T∞,i=40oCThe convective heat transfer coefficient on inner…

Q: 1. Discuss the transfer of heat via convection.

A: Convection: The convection is a type of modes of heat transfer under which the heat is transferred…

Q: A refrigerated compartment of a truck is H=2.4-m high and L =6.9-m long. On a hot summer day, it is…

A:

Q: Name three other examples of heat energy transfer in the home

A: There are three forms of heat transfer possible. One is conduction that happens because of…

Q: What is the thermal resistance of a spherical shell with 12 in OD and an internal radius of 5 in.?…

A: Q)Given dataouter diameter of spherical shell=12ininner radius=5ink=25btu/hr ft.FTo…

Q: What is the relation between work and velocity?

A: The expression of the force is given by, F=m×Vt......1 Here, F is the force, m is the mass, V is the…

Q: Water at 15.6 °C flows across a 20- cm-square plate with a velocity of 2 m/s. A thin strip, 5 mm…

A: This question is solved with the help of the law of convection.  It states that heat transfer by…

Q: Q5A) Hot water at 90 °C enters 15 m section of cast iron pipe (k = 52 W/m. °C) whose inner and outer…

A:

Q: A22-mm-diameter and 10-m-long electric wire is tightly wrapped with a 1-mm-thick plastic cover whose…

A:

Q: 4. Consider steady, one-dimensional heat flow through two plane walls which are exposed to…

A: Solution: Since thickness of the insulation is missing or not given, we cannot find the individual…

Q: A double-glazed window assembly consists of two glasses, each 6 mm thick, and an air gap of 6 mm…

A:

Q: A tube bank uses a staggered arrangement of D=0.9 cm diameter tubes with S,=2 cm and S=1.5 cm. There…

A:

Q: 1. A fluid is having viscosity of 0.4 Ns/m² and relative density of 900 Kg/m² through a pipe of 25…

A: Reynold's number=inertial forceviscous forceIt shows that the given flow is laminar or turbulant, if…

Q: Work done by the weight depends on which factors?

A: Work done Weight is the path independent quantity, so it comes under the conservative force. That’s…

Q: Two concentric spheres of diameter D₁ = 0.8 m and D₂ = 1.2 m are separated by an air space and have…

A: Given:D1=0.8 mD2=1.2 mT1=410 KT2=300 Ka Both surface are black, ε1=1; ε2=1b Surfaces are diffuse and…

Q: The 5-mm-thick bottom of a 200-mm-diameter pan may be made from aluminum (k = 240 W/m-K) or copper…

A:

Q: When heat energy transfers through a solid, what is it called?

A: Convection : This is a kind of heat transfer through fluid (liquids or gases) due to movement of…

Q: Problem 2. Water at 150°F is pumped at the rate of 60 gal/min from a reservoir at atmospheric gauge…

A:

Q: flow through the tur- 4.105 Separate strea bine and heat exchanger arrangement shown in Fig. P4.105.…

A:

Q: Determine the heat transfer realized by radiation between two coaxial and parallel, full and…

A: To find: The heat transfer. Given: The radius of the semicircular surface is r1=4 cm1 m100 cm=0.04…

Q: Consider a silicon wafer positioned in a furnace that is zone-heated on the top section and cooled…

A: To find: The value of steady-state temperature of the wafer, in K. Given data: Tsur,h = 1150 KTsur,c…

Q: Describe each of the three methods of heat transfer, in your own words. Make sure to explain how you…

A: As per given  We have to describe  a. Conductionb. Convectionc. Radiation

Q: Consider a large plane wall of thickness L=0.30 m. The wall surface at x=L is insulated, while the…

A: Given data, L = Thickness of the wall = 0.3 m T1 = Temperature of the wall where x= 0 m, is 32 °C k…

Mechanisms of heat transfer

Heat transfer is an essential discipline in thermal engineering that deals with the transfer, conversion, usability, and creation of heat or thermal energy. Transfer of heat occurs through various mechanisms like conduction, convection, radiation, and change of phases. All these mechanisms have distinct characteristics, but these mechanisms can simultaneously occur in an identical system.