Explain 1. Using 1-Address instructions 2.Using 2-Address instructions 3.Using 3-Address instructions

Q: What kind of operands may be used with the FADD instruction?

A: operands that may be used with the FADD instruction are listed below.

Q: Is there any room for interpretation with regard to the CMPS instruction?

A: In computer science, the CMPS instruction is a commonly used assembly language instruction that is…

Q: What role does the instruction fetch stage play in pipelining?

A: In the realm of computer architecture and processor design, pipelining stands as a pivotal concept…

Q: Explain the distinction between the written sequence and the time sequence of an instruction.

A:

Q: Explain the concept of an Arithmetic Logic Unit (ALU) in a CPU. What are its primary functions and…

A: The Arithmetic Logic Unit (ALU) is a part found in the Central Processing Unit (CPU) of a computer…

Q: MOV M,C STA 2000H IDAY D

A: In 8085 Instruction set, this instruction MOV M, r will copy 8-bit value from the register r to the…

Q: In real-address mode, which register is used as the counter by the LOOPD instruction?

A: The LOOPD instruction executes on CX, ECX, or RCX registers as the counters based on the…

Q: In real-address mode, which register is used as the counter by the LOOP instruction?

A: LOOP Instruction: According to ECX counter, the LOOP instruction is used to repeat a block of…

Q: What is the largest data type permitted by the FLD instruction, and how many bits does itcontain?

A: The FLD (Load Floating-Point Value) instruction is used to copy a floating-point operand onto the…

Q: Which of the following registers holds the information before it goes to the decoder? A control…

A: Registers holds the information before it goes to the decoder

Computer Fundamentals

The computer is termed computation. For calculating or computing something the device that has been used is known as the computer. Or we can say that for performing a fast arithmetic operation the device that has been used is a computer. Storing, processing, and retrieving are the main features of a computer.