Example 9 : The weekly discharge of a typical hydroelectric plant is as under : Day Discharge(m3/sec) 500 The plant has an effective head of 15 m and an overall efficiency of 85%. If the plant operates on 40% load factor, estimate (a) the average daily discharge (b) pondage required and (c) installed capacity of proposed plant. Sun Mon Tues Wed Thurs Fri Sat 520 850 800 875 900 546

Example 9 : The weekly discharge of a typical hydroelectric plant is as under : Day Discharge(m3/sec) 500 The plant has an effective head of 15 m and an overall efficiency of 85%. If the plant operates on 40% load factor, estimate (a) the average daily discharge (b) pondage required and (c) installed capacity of proposed plant. Sun Mon Tues Wed Thurs Fri Sat 520 850 800 875 900 546

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a question by considering the annual load time curve for an electric station as a straight line from 20mw to 3mw, and to cover these loads, then operate three generating units, the first and second, each with a capacity of 10mw, while the third has a capacity of 5mw, and illustrate the load time curve by drawing, then find: 1- the total capacity of the station 2- the maximum demand 3- capacitance coefficient 4- pregnancy coefficient 5 utilizatio
Which of the following statements about next-generation wind energy is correct? a. They will have a lower capacity factor than current wind energy. b. Offshore wind energy will be much cheaper than onshore. c. Offshore wind has the potential for a higher capacity factor than onshore installations. d. Integrating offshore wind into existing grid infrastructure is easier than for onshore energy
The steady-state voltage drop between the load and the sending end of the line seen in (Figure 1) is excessive Suppose that V-4950/0° V (rms). A capacitor is placed in parallel with the 192 kVA load and is adjusted until the steady-state voltage at the sending end of the line has the same magnitude as the voltage at the load end, that is, 4950 V (rms). The 192 kVA load is operating at a power factor of 0.8 lag. Part A Calculate the size of the capacitor in microfarads if the circuit is operating at 60 Hz. In selecting the capacitance, use the value that results in the lowest possible power loss in the line. Express your answer in microfarads to three significant figures. ▸ View Available Hint(s) Figure 1 of 1 202 1100 192 kVA 0.8 lag ΜΕ ΑΣΦ. 11 vec C= 22.8 Submit Previous Answers Incorrect; Try Again; 5 attempts remaining Provide Feedback ? F
What is Energy crisis? What are the causes of energy crisis? Explain the consequences and possible solutions of the energy crisis.
I need the answer as soon as possible
925 3- The approximate equivalent circut of is to be determined. The open-circuit at 0 20KVA, 8000/240 V 60 Hz transformar short-circut tests that were performed transformer. primary side gave the following results. Open - Circut Test V₁x = 8000 Iloc=0-214 A Ploc = 400 W Short-Circuit Test |Visc = 489V 5₁s = 2.5A Pisc = 240k/ al Find the components of the magnetising branch i referred to the primary side b) Find the Components of the equivalent series impedence referred to the primary side. 119 210 2 15 16
What are microgrids, and how do they differ from traditional power distribution systems? Discuss their benefits and challenges.
Explore the concept of smart grids in power systems. What technologies and strategies are employed in smart grids, and how do they enhance the efficiency and reliability of electrical distribution?
A system consists of four idenital 400 MVA generating units feed- ing a total load of 1016 MW. The intertia constant of each unit is 5 on 400 MVA base. The load changes by 1.5% for a 1% change in frequency. When there is sudden drop in load by 16 MW, obtain the power system time constant (T) with constants H and D expressed on 1600 MVA base.
The single line diagrams of interconnected power system show: Select one: O a. All the network components except power transformers the power systems in normal steady-state operation O b. Bus and Branch model of system. C. The view of the location of power stations and substations Clear my choice
A generating station has a maximum demand of 30MW, a load factor of 65%, a plant capacity factor of 50% and a plant use factor of 72%. Solve for the reserve capacity of the plant, daily energy produced and maximum energy that could be produced daily if the plant while running as per schedule, were fully loaded.