Example 3:In the natural state, a moist soil has a volume of 0.0093 m3 and weighs 177.6 N. The oven dry weight of the soil is 153.6 N. If G, = 2.71. Calculate the moisture content, moist unit weight, dry unit weight, void ratio, porosity and degree of saturation.

Example 3:In the natural state, a moist soil has a volume of 0.0093 m3 and weighs 177.6 N. The oven dry weight of the soil is 153.6 N. If G, = 2.71. Calculate the moisture content, moist unit weight, dry unit weight, void ratio, porosity and degree of saturation.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A university is considering two alternative types of bleachers for a new gymnasium. One of the two…

Q: From the following table, develop network diagram, determine the critical path, and Calculate the…

A: Given:- The activity and duration of the activity is given To determine:- The critical path The…

Q: Post 8 Activity Bredessor Duration Predelſer A B с D E f ç A A H' B C 2 D.E f.G 5 7 4 10 356 4 0 2)…

Q: Activity IPA Activity IPA D B D, E C, F, G C, G C A, B H, I FGHH

Q: 10 - In Gantt chart what does the gap means; A B a) An Expected delay b) Expected extra work at the…

A: This type of delay is common in finish to start task. Such a delay called lag time. Now in given…

Q: Normal Crash Task Precedence Duration Cost Duration Cost Name (week) (week) A 0,1 700 3 850 В 100…

A: Solution Since you have posted a question with multiple sub-parts, we will solve three sub-parts for…

Q: Activity A B C D E F G H 1 J K Depends on Completion of Activity A B с B D and G B I and F

A: The activity on arrow (AoA) technique is a project management tool for mapping and scheduling…

Q: O5: Coasider the following table summarizing the details of a project: Activity Predecessorts)…

Q: Q: Figure I shows the activities of a small project with their details. 1. Draw the Gantt chart of…

A: Introduction- A project organization diagram depicts the logical and sequential link between…

Q: H.W: Find the total duration of the project and determine the critical path for the activities shown…

A: Given that: Activity details as shown below:

Q: EC, LS, LC, TF, and FF. Preceding Activity Time A,F

A: Given:- Network diagram To find:- total project duration ES,EC,LS,LC,TS,FF

Q: Assignment # 3. For the following schedule, draw the arrow diagra (AOA), perform the CPM…

A: Given schedule and asked to draw the activity on Arrow diagram (AOA) and mark critical path.It is…

Q: Homework #1 For the shown project, answer the following questions (durations re in days). Optimistic…

A: Activity Optimistic time(To) Most likely time (Tm) Prismatic time (Tp) 1 0 0 0 2 59 70 93 3 22…

Q: 12. Compute the values of ES, EF, LS, LF, FF, and TF for the activities in the following network. 1…

Q: Q2) Find the total duratlon and date of completion (assume the project start date is 10/6/2019) by…

A: Gantt chart : A Gantt chart is a form of bar chart that depicts a project timetable. It is named…

Q: 6) Construction of a building is based on the following CP network ACTIVITY A B C D E F G…

A: Given data:- Below table is given; Activity Predecessor Normal Time (days) Normal Cost ($) Crash…

Q: : Draw the network diagram by using AON technique for the following activities, define the located…

A: First we will draw the network using AON type. Then we will find the critical path for the network.…

Q: Q1: Draw the allocation of resources chart on the earliest and latest start time for the project…

A: Given,

Q: Draw a network diagram for the project: Activity A B C D E Predecessor B A B B F с с G H F, G I D,…

A: Network diagram can be done into two ways. AOA network which means activity on arrow, AON Network…

Q: the Q3: Determine project for the activities shown below: Activity A BCD E F GH K Expected duration…

A: Given that:

Q: gave answer without involving Ai contentt 120. How do combined operations affect the construction…

A: Combined operations in construction refer to the integration of various construction activities to…

Q: 3. One disadvantages of the Gantt chart is not showing : a) O The effect of activity duration The…

A: The different techniques used for scheduling the construction projects are Bar chart or Gantt…

Q: Project onsultär is responsiblê för: a. Site preparation b. Supervises and coordinates the work in…

A: Solution: The correct option to above question is option B.

Q: Calculate the contract value, the monthly value of the planned work to be completed (Budget value)…

Q: Activity A B G Predecessors A А,В C,E Duration (Weeks) 7 9 12 8 5. Given the activity table above.…

A: By using critical path method, we are calculating total duration of the project to complete. Network…

Q: b. Identify and develop a comprehensive work break down structure for the project. c. The WBS…

A: Solution Given data network diagram is given

Q: ratio

A: PERT uses three estimated times for activity duration optimistic time The estimate is determined…

Q: Short interval scheduling is a vital link between...?

A: Short interval planning is a method of dealing with the evolving environment of field operations by…

Q: Q2: Draw the network diagram (Job-on-arrow) and find the shortest possible time to finish the whole…

Q: Activity A started as planned- took 2 more days. Activity B started on day 5, was completed in the…

A: The network diagram given in the question is as follows-

Q: cated activities on the critical pat fES, EC, LS, LC, TF, and FF.

A: Given:- activity,precedent activity,time To find:- total project duration ES EC LS LC TF FF

Q: What is non excuseable delay?

A: Non-excusable Delays are defined as the delays which are within the control of the contractor and…

Q: Homework3: Draw the network diagram by using AON technique for the following activities, define the…

Q: Activity A B C EDF GH JLN M I0K|SQ 2 4 3 2 75 8 3 1 47 3 11 8 2 Duration 4 3 Weeks Followed L EFGH…

A: AON Network for given Activities schedule is drawn as shown below.

Q: The is a schedule forecast of the probable duration of a project.

A: Given data Schedules forcast Probable duration of project

Q: A Gantt Chart is used for planning, scheduling and monitoring projeets, and managing th dependencies…

A: 3) False Gantt chart is used for planning, scheduling but it can't show interdependency between the…

Q: For 300 trips, assign them using constant assigntment ratio Route Hours 1 1.1 2 1.2 3 1.3 4 1.4 5…

Q: Q/Find the completion time and critical path for a project with following: 5 H 4 15 3 2 M 10 A 8 C.…

A: There are activities named from A to M and their durations , overlapping times between successor…

Q: From the following table of information: a) Draw the precedence diagram; b) What is the probability…

Q: Q2(b)(ii) Resource constraint has affected the project in so many ways. Describe how has slack…

A: Program evaluation and review technique: It is a tool to visualize a diagrammatical timeframe of a…

Q: What is a job progress scheduling?

A: The construction management has the responsibility of supervising the planning, scheduling,…

Q: Q3: Determine the time completion of project for the activities shown below: A-0-N Activity:…

Q: Identify which system of network scheduling is best adapted to each of the following types of work:…

A: Since, we answer only three sub-parts, will answer the first three. Please resubmit another question…

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

I need solutions in15 min please

-Third year Studer
2020-2021--
years
Sil Mechanics Lectures/Coarse 1
Vazo
Example 3:In the natural state, a moist soil has a volume of 0.0093 m3 and weighs 177.6
N. The oven dry weight of the soil is 153.6 N. If G, = 2.71. Calculate the moisture
content, moist unit weight, dry unit weight, void ratio, porosity and degree of saturation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1Given

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are the advantages of CPM scheduling technique?
10. From the following table, draw the precedence network, perform the CPM calculations, and complete the table entries, assuming interruptible activities. Activity A ABCO с Duration IPA Type Rel Lag ES 3 3526 5 2 6 LAABC А B с SS FF 3 EF LS LF TF FF "If the relationship type is not mentioned, it is finish to start (FS). If no lag is mentioned, it is zero.
Q18. Q22. Q23. Which of the following is the advantages of digitalised communication in Common Data Environment (CDE) for construction manager? Approved Work in Progress (WIP) is quick authorised in shared area by other specialist designers II. Creating quick stakeholders analysis for project decision making III. Conduct virtual meetings as often as possible IV. Performance reporting that keeps the stakeholder informed once a month to avoid interference V. The documentation publishes for all participants of projects and then it archives. I. A. I, II & V B. II, III & V C. I, II, III & IV D. All of the above Value Creation in project Management includes: Time, Cost and Quality Risk, Value and Benefits. I. II. III People, Prosperity and Planet 1V. Product and Process. V. Increase environmental impact A. B. с D. I & V I, II, III & IV III & IV All of the above Mechanism in Project Management process needs the followings combination: People, Tools, Technique, Equipment & Organisation…
Using the activity list below and any appropriate drawing tool, create a complete network diagram using the precedence method showing Activity, Duration, ES, EF, LS, LF and Slack per activity: ACTIVITY A B C D E F G H DURATION 5 12 20 15 15 30 12 8 PREDECESSOR A B B B C, D E, F G
Q: Draw the allocation of resources chart on the earliest and latest start time for the project that its information shown below, and identify the most reasonable of them and why? A B CD E FG HI 1 12 13 24 2-5 Activities K 48 5-6 6-9 79 89 Events 34 4-7 Duration 4 3 6 resources 3 4 5 4 3 6 1. IN
Example (1) In the following example, there is a group of activities. Find the following using the network diagram method R 6 I 5 H 5 B, critical path, CP, A, G 4 F 3 E.D (A.O.A): time required to complete the project. C B 5 2 3 5 R R H.I G F F,G G A 4 C,F B,D,E Effectiveness Duration (week) Subsequent effectiveness
In the following table, a part of a project, for which the time period for each activity is specified, find the time required to complete the project using the network diagram by Act. on arrows. Activity A B D G H I Time Followed by Preceded by B.C 23573625 G.F D.F E I I H I A A C B.C DBG H.E.F
). The network and durations given below show the normal schedule for a project, and the table given below summarizes the time-cost information for the activities, the owner wants to finish the project in 110 days, so find the minimum possible cost for the project to finish in 110 days AND 20 A B C D (19) E F 9. Activity (days) 120 20 40 30 50 60 Normal du 120 60 Crash (days) 100 15 30 20 40 45 30 on 4 50 Norma Cost 12000 1800 16000 1400 3600 13500 Cost 14000 2800 22000 2000 4800 18000
The AON (activity on node) scheduling network diagram and associated data are given below. As part of the time-cost tradeoff process, which activity(s) would you shorten to reduce the project duration by one time unit? What is the total project direct cost with the reduced project duration?
Name four types of scheduling methods.Line-of-balance scheduling is best adapted to what type of application?
Sieve No. Diameter Soil A 4 4.760 96 6. 2.380 91 10 2.000 89 20 0.840 85 40 0.420 81 60 0.250 78 100 0.149 67 200 0.074 64 LL 30 PL 10 Determine its classification using USCS, FS F6 FB F9 DIR % 7 Y P G H. 因 LO