Example 3.4 A jet of water 100mm in diameter, moving with a velocity of 25m/s in the direction of the vane, enters the vanes moving with a velocity of 12.5m/s. if the jet leaves the vanes at an angle of 60° with the direction of motion of the vanes, find i. Force on the vanes in the direction of their motion ii. Work done per second.

Example 3.4 A jet of water 100mm in diameter, moving with a velocity of 25m/s in the direction of the vane, enters the vanes moving with a velocity of 12.5m/s. if the jet leaves the vanes at an angle of 60° with the direction of motion of the vanes, find i. Force on the vanes in the direction of their motion ii. Work done per second.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A tank (contains a fluid of density=2715.2 kg/m3) stands on a frictionless cart (The cart is fixed) and feeds a jet of diameter 4 cm and velocity 6 m/s, which is deflected 0=35 degree by a vane. Compute the tension in the supporting cable. 6 m/s D 4 m- 35 deg Do = 4 cm Cable
A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction ofmotion and leaves it at 150° absolute with the direction of motion. The absolute inletvelocity of the jet is 25 m/s and the vanes move at a velocity of 10 m/s. Ignore frictionacross the vanes. Calculate:1. the power/kg of water
An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per second. At the same time, receiving a fluid at a rate of 225 US Gal per minute. At a certain post the tank is considered to be quarter full. Find the (a) water level and the (b) mass change In the tank 15 minutes later. Given: tank diameter = 10 ft tank height = 20 ft
A pump is delivering 160 liters per second of water using an impeller diameter of 254mm and operating at a speed of 1800 rpm. If the speed is held constant and the impeller diameter is changed to 203.2 mm, what is the new discharged of the pump in liters per second?(128 L/s)
Water flows at the rate of 5 ft/s through an inclined pipe. At point A, where the diameter is 12 inches, the pressure is 15 psi. At point B, the diameter is 6 inches and the center of the pipe is 2 feet lower than at point A. a. Draw a clear diagram of the pipe system that indicates the following: (a-1) water flow reflecting the quantities involved in describing fluid flow and (a-2) the object of interest and the quantities that describe Bernoulli's equation. b. Write the Bernoulli's Equation using subscripts U ad L for the upper and lower points respectively and determine the pressure at point B?
Water flows out of 5 mm x 200 mm slots in a sprinkler as shown. The mass flow rate is 15 kg/s. 200 mm 250 mm a. Find the torque required to prevent the sprinkler from rotating. b. Find the rotation rate of the frictionless sprinkler when released.
-, Given: Water from a pressurized tank flows out and creates a vertical jet as shown. Total head loss due to friction is 5 m At location A. a pump adds 20 J/kg in the direction of flow to the stream Water properties are as follows: p= 998 kg/m and u= 1E-3 Ns/m. Acceleration due to gravity is g= 9.81 m's?. Find: Maximum height H to which the jet rises. Air 75 kPa (gage) H? Water 85 cm