Answered: Example 2: Assume a leg has 0.6 m shaft… | bartleby

Related questions

Question

Example 2:
Assume a leg has 0.6 m shaft of bone with an average
cross sectional area of 1.5 cm², What is the amount of
shortening when all of the body weight of 350 N is
supported on the leg:

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Determine the force in member BE of the loaded truss. Enter a positive number if in tension, negative if in compression. 11' B 14' 15° 15° F E 11' 15° 1.0 L 1.7L 15° 45° A Answer: BE = i !L 45° D
a cable has a diameter of 4mm and an original length of 2m.The cable is pulled by a force of 130N.The final length of the cable is 2.02m -calculate the youngs modulus of the cable
A high-speed lifting mechanism supports a(n) 880-kg object with a steel cable that is 28.0 m long and 4.00 cm² in cross-sectional area. (a) Determine the elongation of the cable. (Enter your answer to at least two decimal places.) mm (b) By what additional amount does the cable increase in length if the object is accelerated upwards at a rate of 3.1 m/s²? mm (c) What is the greatest mass that can be accelerated upward at 3.1 m/s² if the stress in the cable is not to exceed the elastic limit of the cable, which is 2.2 x 10³ Pa? kg
Assume Young’s modulus for bone is 1.40×1010 N/m2 . The bone breaks if stress greater than 1.50 × 109 N/m2 is imposed on it. (i) What is the maximum force that can be exerted on the femur bone in the leg if it has a minimum effective diameter of 2.50 cm? (ii) If this much force is applied compressively, by how much does the 20.0 cm long bone shorten?
Orb Spiders make silk with a typical diameter of 0.15mm. 1)A typical orb spider has a mass of 0.50 g. If the spider suspended so from a single 12 cm long strand of self, by how much will the self stretch? 2)What is the maximum weight that a single strand of silk and support? 3)why do you have to lean forward when standing from a chair?
Describe the stress involved when stretching out a rubber band by pulling its ends apart
A single non-reinforced concrete column with a rectangular cross-section of 12.0 * 18.0 cm is used to support a large platform a) What is the maximum weight of the platform if we want to maintain a safety factor of at least 10.0? The ultimate compression strength of concrete is 172MPa b)If the column were to break under the weight, where would it most likely break, at the top or bottom?