Examine the water demands for a community that will reach a population of 120,000 at the design year. The estimated municipal water demand for the community is 300 l/c/d. Calculate the fire flow, design capacity of the water treatment plant, and design capacity of the water distribution system. Use NBFU formula for fire flow.

Q: The current population of a community is 40,000 capita, and the expected future population after 25…

A:

Q: Average daily usage of water in a city is 145 gallons per capita per day (gpcd), which excludes the…

A: This question is related to the environment engineering from the civil engineering. Given Data -…

Q: OD, COD, and ultimate BOD of a wastewater containing

A:

Q: 250. Determine the size used to supply water for a fire flow demand of a building constructed with…

A: Given: wooden frame building: Area = 900 m2 Ordinary structure: 2 Floors Area of each floor = 900 m2…

Q: Q2(b) Rainfall Data Cumulative Cumulative Rainfall (mm) 95 100 101 Time (mm) Rainfall (mm) Time (mm)…

A:

Q: Discuss the effects of excessive discharge of suspended solids from sewage treatment pland (STD)…

A: Sewage is defined as the mixture of liquid waste with water. The major impuruty in sewage in organic…

Q: Q2/A storm is proposed to drain a 16 hectares drainage area shown in the figure (2)below with given…

A: Solution: Given: Total drain = 16 ha peak discharge for 5 years t = 15 min For site A: A = 6 ha t =…

Q: Design a sanitary sewer from MH 5 to MH 6. Show your steps to get full score. Given: 100…

A: GIVEN: 5 dwelling units per gross acre area from MH5 TO MH6  A3=30 acres total dwelling unit from…

Q: Water flows in a 10-ft-wide rectangular channel with a flowrate of 200 ft3/s. Plot the specific…

A: Given information:

Q: 1. A city discharges 7.2 MLD of wastewater with a BOD, of 295 mg/L into a stream. Answer the…

A: solution Given discharge of waste water Qw=7.2MLD=0.083 m3secBOD5 waste water =295 mgltaBOD5 stream…

Q: A community had a population of 150,000 in 2010 and it is expected that this will increase to…

A: (a) No change in use rate: Water requirement in 2030 = Population in 2030 * average per capita water…

Q: #1: Design a sanitary sewer for a City “A”, using the following data: - Population of the city =…

A: Given- Population of the city P=(18300) persons Average water consumption, Qavg=(18300/100) Lpcd…

Q: A two-pond system shown in the attached picture is fed by a stream with a flow rate of 1.0 million…

A: Determine the initial concentration of pollutant;

Q: Q4) A small community discharge wastewater at rate of 500 m'/day and specific gravity of (sp.gr…

A: Given:  Rate of discharge of waste water =500m3/day Specific gravity = 1.05 Concentration of…

Q: The community of Enviro, USA, has found that its present ground water supply is inadequate to meet…

A: Po = 40,000 r = 2% = 0.02 Pn = Po (1 +r)n   P10 (@1/1/2032) = 40,000 (1+0.02)10 = 48,760

Q: An elevated storage supplies water to a residential catchment with a population of 10000. The…

A:

Q: The sewage collection system is comprised of pipes of three diameters of 1.00m, 0.50m and 0.10m,…

A: Given Data: Diameter of pipe 1 is d1=1 m. Diameter of pipe 2 is d2=0.5 m. Diameter of pipe 3 is…

Q: The intermittent sand filter needs to be drained and cleaned. If the treated wastewater volume in…

A:

Q: Q - If the average sewage from a city is 40×106 l/day and the average 5-day BOD is 200 mg/l against…

A: Given data in question Average sewage 40×106 l/day5 day average BOD 200 mg/lStandard 80 mg/dayTo…

Q: Design a sanitary sewer for a City “A”, using the following data: -         Population of the city…

A: Diameter (m) of the sewer =140m Slope of sewer = 1 in 5000

Q: Estimate the water demand for a city of 100,000 people. Assume the annual average consumption rate…

A: number of people=100000annual average consumption rate=647Lpcd

Q: Q- If the average sewage from a city is 40x106 l/day and the ar standard of 80 mg/day per capita at…

A:

Q: Using the ASCE and Griff methods, estimate the average, peak, and low rates of flow in the sewer…

A: As per company guidelines we are supposed to answer only the first three sub-parts. Kindly repost…

Q: 4) A city with an expected increase in its future population is to provide a complete water…

A: The water treatment plant for surface water source are a rapid mix, flocculation, sedimentation,…

Q: What must be the diameter of the sewer main to transmit sewage from 8000 households to a wastewater…

A: The values given in the question are as follows Number of households=8000  Allowable…

Q: The catchment area of a sewer is 50 hectares. Estimate the storm water flow corresponding to…

A: Catchment area = 50 hec Rainfall = 40 mm Time concentration = 30 min Impervious area = 55%

Q: A wastewater treatment plant receives, at an average, 75% and 125% of water supply during dry and…

A: Given Data: The average municipal water demand (Liter per capita day)=550 lpcd Do the following to…

Q: A town's household flow rate is measured at 90 gpcd (gallon/capita.day). If the plant receives 34.25…

A: Water lost in inflow and infiltration=12%Available water =(100-12)%×34.25 MGD…

Q: 5) In a town with a population of 100000, where seven rapid sand filters operated at 10 m/h are used…

A: Given information:Population of the town: 100,000Number of rapid sand filters: 7Filtration rate per…

Q: Generally, municipal wastewater collection system can be classified into separate and combined…

A: Required to find: The Engineering design aspect, Environmental aspect, Economic aspect and social…

Q: Problem 3: You are considering three design alternatives for treating a pollutant in wastewater…

A: Given data, Q = 8.6 mgd = 8.6×10^6 gal/d V = 9000 gal. For each system K= 1.1/min for first order =…

Q: estimate the average flow rates. Also,

A:

Q: Problem 1A 300-house residential development is proposed. Assume that each person uses 500 liters on…

A: Answer is 6 Lakh litres per day. Explanation is in the below box. If you have any doubts at anywhere…

Q: You are provided with the following information about a municipal wastewater treatment plant. This…

A: Brief concept and formula- Mean Cell Residence time- It is also called as the sludge age. It is the…

Q: Q1: A mid size city with populations of 62000, 70000 and 81000 for the years 1990, 2000 and 2010,…

A:

Q: 13.24 The sewage discharges from two neighborhoods A and B have to be disposed of through an…

A: Here, in this question to determine the values we will use a nomogram for pipe sizing in a…

Q: The flow totalizer reading the month of September was 121.4 MG. What was the average daily flow…

A:

Q: total Average Day Demand in a Development is 52,000gals, Determine the required volume of water tank…

A: Given  Average demand per day 52,000 gallons Additional requirements 20%  Fire demand 350pgm for 30…

Q: Assume that the average water usage of the Ermelo community is approximately 130 litres per person…

A: Qi = 130L/person/day Volume of water treatment plant = 10*106 L /day Volume of water for residential…

Q: Design a sanitary sewer for a City “A”, using the following data: -        Population of the city =…

A: Population of the city = 13500 person.   Average water consumption = Qavg-water = (13500/100) lpcd…

Q: A community has a current population of 25,000. 10 years ago, the population was 18,500 and the…

A: Given:- The current population of a community = 25000 The population of the community 10 years ago =…