Answered: Ex. 7: Ex. 7: A conductor of length 10… | bartleby

Related questions

Question

Ex. 7: A conductor of length 10 cm is moved
parallel to itself with a speed of 10 m/s, at
right angles to a uniform magnetic induction
10 4 Wb/m². What is the induced e.m.f. in it?

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

nillan Learning Activity on the Sun, such as solar flares and coronal mass ejections, hurls large numbers of charged particles into space. When the particles reach Earth, they can interfere with communications and the power grid by causing electromagnetic induction. For example, a current of millions of amps (known as the auroral electrojet) that runs approximately 100 km above Earth's surface can be perturbed. The change in the current causes a change in the magnetic field it produces at Earth's surface, which induces an emf along Earth's surface and in the power grid (which is grounded). Induced electric fields as high as 6.0 V/km have been measured. We can model the circuit at Earth's surface as a rectangular loop made up of the power lines completed by a path through the ground beneath. We can treat the magnetic field created by the electrojet as being uniform (but not constant) and parallel to Earth's surface near the surface. Consider a 1.0-km-long stretch of power line that is…
A straight conductor of length L moves with an acceleration A =0.1 ms-2 at right angles to a magnetic field of uniform strength B=10.2 T. Calculate L, considering that the e.m.f., ? = BLv, between the ends of the conductor increased from 0 to 5 V during the first 20 s after the beginning of motion.
QB2d. Calculate the EMF induced in the railway carriage wheel of radius R=840 mm by the magnetic field of the Earth. Consider that the magnetic field of the Earth makes an angle of 71.5 deg with the horizontal surface of the railway track. Take the speed of the carriage to be v = = 158 km h¹ and the value of the magnetic field of the Earth B = 10-5 T. Provide your answer in microvolts (10-6 V=1 μV): for example, if you calculated the value to be 0.000075 V, then enter 75 as your answer. Enter your answer in the box below.
A square loop with area of A= 0.25m^2 has a perpendicular magnetic field passing through. If the magnetic field increases from B=2.0T to B=4.0T in 0.2 seconds, what is the induced e.m.f?
The figure above shows a 40.0cm thin metal bar, with mass of 900g, that rests on two conducting metal supports that is connected to a battery and a 25 ohm resistor. The metal bar is placed under a uniform 0.50-T magnetic field. (a) What is the highest voltage, vmax, the battery can have without breaking the circuit at the supports?
A metal bar is in electrical contact with some metal rails as it is sliding to the left (assume that the rails and rod form a complete loop). And the rod is moving to the left in a uniform magnetic field that points out of the screen. What is the direction of the induced current (if any) in the rod? O There is no induced current O up O down
Imagine that we have a rectangular loop of wire (with a total resistance of 1.6 ohms) placed in a magnetic field that dies off as: 0.3*e-10t T into the page. What is the induced current in the coil at 0.002 s? The loop has a length of 1.7 m and a width of 1.7 m.