Euro copter 130 F-WGYP Model was remodeled by John McClane to be weaponized. He plans to integrate a Machine Gun and a rocket launcher to the helicopter by using a truss system. The designed truss is presented Figure FE-001. If the machine gun weighs 181.382kgs and the rocket launcher weighs 181.382kgs and were attached to points B and A respectively, Determine the internal forces on the members and all the reactions of the supports.

Euro copter 130 F-WGYP Model was remodeled by John McClane to be weaponized. He plans to integrate a Machine Gun and a rocket launcher to the helicopter by using a truss system. The designed truss is presented Figure FE-001. If the machine gun weighs 181.382kgs and the rocket launcher weighs 181.382kgs and were attached to points B and A respectively, Determine the internal forces on the members and all the reactions of the supports.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Two identical 10 mm diameter A36 steel wires support the rigid beam shown. Determine the maximum load P that can be applied if a Factor of Safety of 2.0 is required. See the text Appendix for any material properties that are needed. E 4 m A -3 m 2 m
A beam shown below has a T-shaped cross section. Determine the values of maximum tensile and compressive bending stresses and its locations from left support of the beam.
Question- A tension member of a roof truss carries a factored load of 430 kN. By considering the strength in yield, what is the gross area required to carry this load? (Consider Fe 250 grade steel).
I need the answer as soon as possible
this is a structural analysis question please answer it ASAP thank you in advance
It is not graded question and it is complete question.Plz, solve it for your understanding.Structural Analysis-2Plz, write as this process: Given Data Required solution Results Attempt Neat and Clean with proper diagrams
Please answer the problem attached image. Using NSCP 2015 ,thank you.
i need the answer quickly
5 5a 5b 5c Alaterally supported beam was designed for flexure. The beam is safe for shear & deflection. The most economical section is W 8 x 13 however the said section is not readily available at the time of the construction. If you are the engineer in charge of the construction what alternative section will be the best replacement? Why? Use: Fy=248 MPa: E=200,000 MPa Designation Ag (mm2) Weight kg/m 1910 19 30 width 24 flange. thickness d (depth) mm 200.41 bf 100.06 W8 x 10 4.32 15 expla'n briefly your cho'ce. (transform your comparative analys's 'nto a narat've form to support your cho'ce) W8 x 13 2477 202.05 101.60 6.48 W6 x 20 3787 157.48 9.27 152.91 102.36 W6 x 16 3058 159.51 10.29 tf Web 5.21 thickness tw Elastic Properties mm 4 Ix x 106 mm 3 Sx x 103 5.84 6.60 6.60 13 16 17 13 126 162 220 167 mm rx 81.79 81.53 67.56 66.04 mm 4 lyx 106 1 1 6 2 mm 3 Sy x 106 17 22 72 36 mm ry 21.36 21.41 38.10244 24.54 Plastic properties mm 3 Zx x 103 145 187 244 192 mm 3 Zyx 103 27 35 110 56…