Ethane at 25°C and 1.1 atm (abs) flowing at a rate of 100 mol/s is burned with 20% excess oxygen at 175°C and 1.1 atm (abs). The combustion products leave the furnace at 800°C and 1 atm.(a) What is the volumetric flow rate of oxygen (L/s) fed to the furnace?(b) What shouldthe volumetricflow rate ofthe combustion products be? State all assumptions you make.(c) The volumetric flow rate of the combustion products is measured and found to be different from the value calculated in Part (b). Assuming that no mistakes were made in the calculation, what could be going on that could lead to the discrepancy? Consider assumptions made in the calculations and things that can go wrong in a real system

Q: Ethanol gas is converted to ethylene gas and steam in a continuous pressurized reactor at 5 atm. If…

A: Ethylene gas is formed by the decomposition of ethanol gas.

Q: 0.9781 1. Mass of compound (g) 4.08 2. Wire length (cm) 3. Initial temperature ("C) 23.300 28.051 4.…

A: heat of combustion is defined as the heat released when or given off when 1 mole or 1g of organic…

Q: Question 3: Several species of inhalational anaesthetics are used to start and maintain anaesthesia.…

A:

Q: A group of engineers is tasked to estimate the heat of vaporization (kJ/mol) of benzene at 20 °C…

A: Hello!! Thank you for asking the question. You have asked 3 different methods of calculation of the…

Q: A combustion engine has been made to use a mixture of liquid hydrogen and liquid oxygen as a fuel…

A: Given data: Length of tube = 1 m  Diameter of tube = 0.8 m Flow rate of exhaust gas = 72 kg/s…

Q: A chemical engineer is proposing to pump a certain organic solution (with s.g. of 8.66) from the…

A: The density of the organic solution from specific gravity, and the density of water.  Bernoulli's…

Q: It is desired to cool 100 ton./h (tons/hour) of a mixture of hydrocarbons from 90 ºC to 60 ºC in a…

A:

Q: A single-effect evaporator is being used to concentrate 10,000 kg/h of tomato juice from 5% total…

A:

Q: Pe b Natural gas is produced in a gas field Component outside of the City of Grande Prairie and is…

A:

Q: A feed stream containing 80 mole % n-butane, 5 mole % iso-butane and 15 mole % H20 is continuously…

A:

Q: Calculate the enthalpy change to take liquid water from 100 kPa and 25 °C to superheated steam at…

A: It is given that liquid water initially at 100kPa and 25oC is changed to superheated steam at 100kPa…

Q: a product having a moisture content of 60% (wet basis) is dried in a tunnel-type dryer at a rate of…

A: Initial moisture content of the product =60% (wet basis) Mass flow rate of the product,mp.=20 kg/hr…

Q: A product having a moisture content of 70% (wet basis) is dried in a tunnel type dryer at a rate of…

A: Given that- Moisture content= 70% (wet basis) Feed flow rate= 30 kg/h Inlet condition- Drying air…

Q: A feed of 8350 kg/h of a 20 wt% NaOH solution in water at 37.8°C enters continuously a single-effect…

A: Sodium hydroxide solution is concentrated in a single-effect evaporator.

Q: In a multiple effect (effect = number of equipment/evaporators), vapor from previous…

A:

Q: Nitrogen is an essential source of nutrition for growing plants. Ammonia has the highest nitrogen…

A:

Q: Ethanol gas is converted to ethylene gas and steam in a continuous pressurized reactor at 5 atm. If…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Question 4-Propane gas (C3H8) is used as a propellant in aerosol cans. a. Calculate the density of…

A: Note: As per our guidelines, we are only allowed to answer first three subparts. To get the…

Q: From previous experiments, this chemical reaction is known to absorb 210. kJ of energy. The position…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Q1: (A) kg of air is compressed causing its temperature to increase from 25K° to 100K°. If the…

A: Given, Heat capacity of air, Cp = 0.917+14.32×10-5T-51.29×10-9T2 mass of air, m = 1 kg Initial…

Q: Sulphur can be recovered from underground elemental deposits via the Frasch process. In this…

A: Given thatT =165 CP = 2.5 MPaPT  = 6 atmρl  =1.811 gml =1.811 x 106  gm3ρs  =2.050 gml =2.05 x 106…

Q: It is desired to produce 250 kg/h of steam methanol at 150 ° C and 1 atm from liquid methanol at 25…

A: • This problem is solved by taking one assumption that there is no heat loss to the surrounding.  •…

Q: Q1. The cooling water from the condenser of a power plant enters a wet cooling tower at (35° C) at a…

A: part you are looking for, so we are answering the first three subparts, please repost your question…

Q: A combustor uses H2 gas and oxygen gas (02) as reactants. The equivalence ration is 0.3. Both…

A: In a combustion study, the ratio between the actual fuel/air ratio to the stoichiometric fuel/air…

Q: When a hydrocarbon fuel is burned, almost all of the carbon in the fuel burns completely to form CO2…

A: Given, mCO2=0.59 kg/kWh N= 50,000 Power=700kWh/houses/year

Q: A heat exchanger is a piece of equipment that allows heat to be transformed from one stream to…

A: Given:  Cp (NH3 vapor, P=12.2 atm) = 8.0J/mol-K and Cp (NH3 liquid, P=12.2 atm) = 82.3 J/mol-K

Q: A petroleum cut has the specific gravity (SG = 0.825 at 60 °F) and the mean average boiling point is…

A: Specific gravity is the ratio of the density of the substance to the density of the reference…

Q: temperature for the condensor. 100 gmol/min of a gas stream containing 30 mol% ethane (C,H,) and 70…

A:

Q: Q 2. Air at 400°C and 1.7 bar flows through a horizontal 8.2-cm ID pipe at a velocity of 50.0 m/s.…

A: Given: Air temperature and pressure initially T1 = 400oC = 673 K and; P1 = 1.7 bar = 1.7×105 Pa…

Q: Prior to entering a reactor, a stream of air flowing at a rate of 100 mol/s must be pre-heated…

A: Given Air flow rate ma=100 mol/s preheated from T1=25°C T2=1200°C For steam P1=10 bar T1=510°C…

Q: 27.4 moles/min of methyl alcohol (methanol) vapor enters a heat exchanger. In the heat exchanger,…

A:

Q: Water boils at 100°C at atmospheric pressure, that is, at sea level (To=15°C). point is defined as…

A:

Q: A sample of 260.0 of liquid water is initially at a temperature of 75.0ºC. If that water is heated…

A: Combustion reactions are basically oxidation reactions. The combustion reaction take place when…

Q: As a process engineer in the resin plant, you are dismayed to find in your morning round that the…

A: Step 1: Step 2: Step 3: Step 4:

Q: Q2/ Acetylene enters to heat exchanger at ( 20°C) and ( 2 bar) gauge at a rate of ( 856 m'/min ) is…

A:

Q: 4. What is the minimum amount of ice at 0°C that must be added to the contents of a can of diet cola…

A: Given details: Volume of cola=340 ml initial temperature of cola (T1c)= 20.50C=293.65 K Final…

Q: Q 2. Air at 400°C and 1.7 bar flows through a horizontal 8.2-cm ID pipe at a velocity of 50.0 m/s.…

A: Thermodynamics is the study of effects of heat, work and energy on a system. In thermodynamics a…

Q: Solution Basis: Given Flow Rate Assume ideal-gas behavior. 2000 L (STP)/min, 20°C (mol/min) 0.100…

A: volumetric flow rate of mixture entering the tower = 2000 L(STP) Temperature of the mixture entering…

Q: A feed containing 5% (by weight) sugar in water is fed to a triple effect backward- feed evaporator.…

A: Given Xf=0.05 Xl=0.8 Ts=121.1°C Ps=205.5 KPa P=13.4 KPa F=10000kghr Tf=26.7°C Cp=4.19- U1=3123 Wm2K…