Estimate the first three standing-wave frequencies of the vocal tract. Use v = 344 m/s. (The answers are only an estimate, since the position of lips and tongue affects the motion of air in the vocal tract.) Estimate the second standing-wave frequencies of the vocal tract. Estimate the third standing-wave frequencies of the vocal tract.

Estimate the first three standing-wave frequencies of the vocal tract. Use v = 344 m/s. (The answers are only an estimate, since the position of lips and tongue affects the motion of air in the vocal tract.) Estimate the second standing-wave frequencies of the vocal tract. Estimate the third standing-wave frequencies of the vocal tract.

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter14: Sound

Section: Chapter Questions

Problem 16P: The area of a typical eardrum is about 5.0 105 m2. Calculate the sound power (the energy per...

See similar textbooks

Similar questions

Sound is detected when a sound wave causes the eardrum to vibrate (as shown). Typically, the diameter of the eardrum is about 8.4 mm in humans. When someone speaks to you in a normal tone of voice, the sound intensity at your ear is approximately 1.0 × 10-6 W/m2. How much energy is delivered to your eardrum each second?
In about 1657, Otto von Guericke, inventor of the air pump, evacuated a sphere made of two brass hemispheres (Fig. P15.62). Two teams of eight horses each could pull the hemispheres apart only on some trials and then with greatest difficulty, with the resulting sound likened to a cannon firing. Find the force F required to pull the thin-walled evacuated hemispheres apart in terms of R, the radius of the hemispheres; P, the pressure inside the hemispheres; and atmospheric pressure P0. Figure P15.62
The area of a typical eardrum is about 5.0 x 10-5 m2. Calculate the sound power (the energy per second) incident on an eardrum at (a) the threshold of hearing and (b) the threshold of pain.
The area of a typical eardrum is about 5.0 x 105 m2, (a) Calculate the sound power (the energy per second) incident on an eardrum at the threshold of hearing. (b) Calculate the sound power incident on an eardrum at the threshold of pain.
A bat uses echolocation to detect prey as small as about 1 wavelength of the sound of a bat call. Assume a bat produces a sound with a frequency of 60.9 kHz, and the speed of sound in air is 339 m/s. What is the length in mm of the smallest prey the bat can detect?
A particular person's eardrum is circular, with a diameter of 9.00 mm. (a)How much sound energy (in J) is delivered to an eardrum in one second, at the threshold of human hearing? (The threshold of human hearing is taken to be 1.00 ✕ 10−12 W/m2.) J (b)How much sound energy (in J) is delivered to an eardrum in one second, at the pain threshold for human hearing? (The pain threshold occurs at 1.00 W/m2, one trillion times as intense as the lowest audible level.) J (c)Assume that musicians onstage are exposed to sound that is 10 decibels below the human pain threshold. Over the course of a two-hour concert, how much sound energy (in J) does each ear absorb onstage? J
(a) Ear trumpets were never very common, but they did aid people with hearing losses by gathering sound over a large area and concentrating it on the smaller area of the eardrum. What decibel increase does an ear trumpet produce if its sound gathering area is 900 cm2 and the area of the eardrum is 0.500 cm2 , but the trumpet only has an efficiency of 5.00% in transmitting the sound to the eardrum? (b) Comment on the usefulness of the decibel increase found in part (a).
Determine how much the average force acting on the eardrum of the human ear (area S = 66 mm?) is greater than the hearing threshold if the sound pressure is 112,3 Pa. The sound frequency is 1 kHz. The sound pressure corresponding to the hearing threshold is taken equal to 0.02 MPa. Please enter the units of measurement in your answer.
A copper rod with length 1.4 m and cross-sectional area 2.0 cm2 is fastened to a steel rod of length L and cross-sectional area 1.0 cm2. The compound structure is pulled on each side by two forces of equal magnitude 6.00 104 N (Fig. P14.57). Find the length L of the steel rod if the elongations (L) of the two rods are equal. Use the values Ysteel = 2.0 1011 Pa and YCu = 1.1 1011 Pa. FIGURE P14.57
A copper rod is given a sharp compressionalblow at one end. The sound of the blow,traveling through air at 0 ◦C, reaches theopposite end of the rod 6.4 ms later than thesound transmitted through the rod.What is the length of the rod? The speed of sound in copper is 0 ◦C: Vc= 3450 m / s The speed of sound in air at 0 ◦C: V= 331 m / s. Answerin units of m. A) 1.45 m B)1.75 m C) 2.19 m D) 5.1 m E) 2.33 m F) 2.5 m G) 2.75 m H) 1.85 m
Sound is detected when a sound wave causes the tympanic membrane (the ear drum) to vibrate. Typically, the diameter of this membrane is about 8.4 mm in humans. A) how much energy is delivered to the eardrum each second when someone whispers (20 dB) into your ear? B) to comprehend how sensitive the ear is to very small amounts of energy, calculate how fast a typical 2.0 mg mosquito would have to fly (in mm/s) to have this amount of kinetic energy.
Energy Delivered to the Ear. Sound is detected when a sound wave causes the tympanic membrane (the eardrum) to vibrate. Typically, the diameter of this membrane is about 8.4 mm in humans. (a) How much energy is delivered to the eardrum each second when someone whispers (20 dB) a secret in your ear? (b) To comprehend how sensitive the ear is to very small amounts of energy, calculate how fast a typical 2.0 mg mosquito would have to fly (in mm/s) to have this amount of kinetic energy.