Elementary Surveying: Measurement of Horizontal Distances, show proper and right solution. 1. A line AC cannot be measured directly because of an obstruction on the line. Accordingly, the two lines AB and BC were measured as 2,357.90m and 1,846.00m, respectively. Point B was set at a perpendicular distance of 225m from point D on line AC. Using the approximate slope correction formula for steep slopes, determine the length of line AC. Illustrate.

Q: All azimuths are measured from South. All angles must be written to the nearest minute only. All…

A:

Q: The X and Y coordinates (in feet) of station Shore are 653387.06 and 395027.52, respectively, and…

A:

Q: A survey was laid out as follows: a. Line AB has a bearing of S14°26'12"E b. At B, point C was…

A:

Q: Q1/ The following staff readings in meter were obtained when leveling along the center line of the…

A: This can be solved by rise and fall method.

Q: A line AB cannot be measured directly because of an obstruction on line, Accordingly, the two lines…

A:

Q: 8. This method of traverse adjustment does not conform to any mathematical equations it simply…

A:

Q: 6-) Plan-view sketches of benchmark leveling runs are shown in Figure. Along each line representing…

A: Consider the free body diagram;

Q: Describe about the Basis of slope stability analysis by method of slices.

A: Slope stability analysis is a method of determining the stability of earth and rock-fill dams,…

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.