I need the answer as soon as possible layed soil have LL-S0%specimen of this soil drg from vol.of 40 cm² at LL tovalume d 25 cm at sL. Find Gs-6pL- 304. 1 $L=204if the

Answered: Image /qna-images/answer/edb8e062-184f-4036-930c-eb6b56749faa.jpg

Answered: Elayey soil have LL=S0% spL= 301, 1…

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.5P

See similar textbooks

Similar questions

In AASHTO, which group are the following soils likely to fall into? a. A well graded gravel with approximately 10% fines. b. A well graded sand with approximately 10% fines. c. A uniform fine sand. d. A high plastic clay.
Since laboratory or field experiments are generally expensive and time consuming, geotechnical engineers often have to rely on empirical relationships to predict design parameters. Section 6.6 presents such relationships for predicting optimum moisture content and maximum dry unit weight. Let us use some of these equations and compare our results with known experimental data. The following table presents the results from laboratory compaction tests conducted on a wide range of fine-grained soils using various compactive efforts (E). Based on the soil data given in the table, determine the optimum moisture content and maximum dry unit weight using the empirical relationships presented in Section 6.6. a. Use the Osman et al. (2008) method [Eqs. (6.15) through (6.18)]. b. Use the Gurtug and Sridharan (2004) method [Eqs. (6.13) and (6.14)]. c. Use the Matteo et al. (2009) method [Eqs. (6.19) and (6.20)]. d. Plot the calculated wopt against the experimental wopt, and the calculated d(max) with the experimental d(max). Draw a 45 line of equality on each plot. e. Comment on the predictive capabilities of various methods. What can you say about the inherent nature of empirical models?
Refer to the soil in Problem 4.5. Using the Casagrande plasticity chart, graphically estimate the shrinkage limit of the soil as shown in Figure 4.22. 4.5 The following data were obtained by conducting liquid limit and plastic limit tests on a soil collected from the site. Liquid limit tests: Plastic limit test: PL = 19.3% a. Draw the flow curve and determine the liquid limit. b. Using the Casagrande plasticity chart (Figure 4.21), determine the soil type.
For the soils that are classified by the following AASHTO symbols, what would be the most likely USCS symbols? (Reference: Liu, 1970) Gravels sands: A-l-a, A-l-b, A3, A-2-4, A-2-5, A-2-6, A-2-7 Fines: A-4, A-5, A-6, A-7-5, A-7-6
In AASHTO, which group are the following soil likely to fail into? a. A well-graded gravel with approximately 10% fines b. A well-graded sand with approximately 10% fines c. A uniform fine sand d. A high plastic clay
The properties of seven different clayey soils are shown below (Skempton and Northey, 1952). Investigate the relationship between the strength and plasticity characteristics by performing the following tasks: a. Estimate the plasticity index for each soil using Skemptons definition of activity [Eq. (4.28)]. b. Estimate the probable mineral composition of the clay soils based on PI and A (use Table 4.3) c. Sensitivity (St) refers to the loss of strength when the soil is remolded or disturbed. It is defined as the ratio of the undisturbed strength (f-undisturbed) to the remolded strength (f-remolded)) at the same moisture content [Eq. (12.49)]. From the given data, estimate f-remolded for the clay soils. d. Plot the variations of undisturbed and remolded shear strengths with the activity, A, and explain the observed behavior.
State whether the following are true or false. a. In the AASHTO classification Table 4.1, the soils that are more suitable for roadwork are located on the left than right. b. In AASHTO classification system, the better performing fine grained soils are the ones with lower group indices. c. In AASHTO classification system, sands are classified as grains with 0.075-4.75 mm diameter. d. The USCS symbol for clayey gravel is CG. e. A soil with USCS symbol SM is sandy silt.

Recommended textbooks for you

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Construction Materials, Methods and Techniques (M…

Civil Engineering

ISBN:

9781305086272

Author:

William P. Spence, Eva Kultermann

Publisher:

Cengage Learning

Fundamentals of Geotechnical Engineering (MindTap…

Civil Engineering

ISBN:

9781305635180

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Elayey soil have LL=S0% spL= 301, 1 $Le2012ifthe specimen of this soil dy from vol.of 40 cm? at LL to volume d 2s cm'at sL Find Gs.