EL..20m K=0.5 A= fi= 0.02 D₁-0.3m Lis 150m F₂2 0.02 Da= 0.6m L₂=240m Valve For Valve K= 0.2 EL.: 5m K=1 Q2: A: For the system shown in figure (2). Find the flow rate. B: Water flows through (90m) length of square pipe of dimension (0.4m) and the shear stress at the pipe wall is (44KPa). Determine the head loss.

Q: If the diameter at section 1 is D₁ = 0.5 m, and at section 2 the diameter D₂ = 0.2 m. All the other…

A:

Q: A piston-cylinder is producing a viscous oil flow, which has the flow rate of Q, radius R=1.5 mm,…

A:

Q: Q₂/Suppose in Figure 2, the lengths and diameters of pipe 1 is 300 m x 0.3 m, Pipe 2 is 150 m x 0.2…

A: Given:Pipe 1: L1=300 m, d1=0.3 mPipe 2: L2=150 m, d2=0.2 mPipe 3: L3=250 m, d3=0.25 mWater…

Q: The characteristics for a pump are given in the table below. The pump is required to left water…

A:

Q: Looking for the calculations / unit analysis for ... 1.) Inlet Potential Energy 2.) Outlet…

A: Given that, Rate of water, Q=60 GPM,Diameter of water, D=2 in,Elevation of pipe, h=100 ft,Pressure…

Q: 2 for the system shown in Figure 2, the parameters of pump and motor are as follows: maximal…

A: According to the given information of the system, we have the following parameters which are given…

Q: Keeping in mind continuity of flow, compute the velocity of flow for section C (Vc), the 6 inch…

A: Given Data

Q: Determine required input power to motor [1.64 kW]

A: As per policy, we can solve the first problem from multiple questions.

Q: 5.) For 300 mm diameter concrete pipe 3,600 m long, find the diameter of a 300-m long equivalent…

A:

Q: 49. Water flows at a rate of 200 GPM into a piping system connected in series. Length, diameter, and…

A: Given:To find:(a) Total pressure drop.(b) Diameter of the equivalent pipe.

Q: Water enters a fountain through a pipe with a cross-sectional area A1 at a flow rate Q. The pressure…

A: Given:

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.