Water at 20°C is pumped between two large open reservoirs through 1.5 km of smooth pipe. The water surfaces in the tworeservoirs are at the same elevation. When the pump adds 35 kW to the water. the flowrate is 1 m/s. If minor losses arenegligible, determine the pipe diameter.D=m

Answered: Image /qna-images/answer/109de93d-bef2-4b0c-b12d-363aed8318d7.jpg

Answered: ed between two large open reservo ne…

Engineering

Mechanical Engineering

ed between two large open reservo ne elevation When the pump adds

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: List four service precautions for working on thefuel injection system

A: In an internal-combustion engine, fuel injection is the introduction of gasoline into the cylinders…

Q: 2. How does fluid flow to the reservoir when the directional control valve is in the center…

A: When a directional control valve is in the center position, it typically blocks the flow of fluid to…

Q: Q1/ Compare between the following: 1- Swirl and crevice flow motions. 2-S.I and C.I fuel injectors.…

A: Crevice flow and swirl flow are two different types of fluid motion in various contexts. Here is an…

Q: how to improve thermal efficiency of range extender micro turbine system.

A: The explanation is already in the Answer Section. hope this helps you a lot.

Q: Identify the D.C. valve employed to reverse the direction of flow and explain its working with neat…

A: D.C. Valve: These vales perform three below-mentioned functions. Allow fluid flow Stop fluid flow…

Q: Foul water pipe transfer the ... O a. The surface water to manhole. O b. The waste water from basin…

A: Given that Foul water pipe transfer the ........ a. The surface water to manhole. b. The waste…

Q: __________ pump is prepared for oil production and fuel transfer a. Vane b. Screw c. Lobe d. Gear

A: A screw pump, moreover known as a water screw, could be a positive-displacement (PD) pump that…

Q: which of the following compressor converts kinetic energy (velocityl into pressure energy. O a.…

A: We have to choose option Which Of the following compressor converts kinetic energy to into pressure…

Q: Pressure relief valves: Select one: a. Open manually upon overloading in pressure b. Open…

A: Pressure Relief valve- Pressure relief valve or Relief valve are used to control the pressure in a…

Q: Which of the following compressor, increases pressure by reducing the volume O a. Axial compressor O…

A: Solution:

Q: A centrifugal fan forms of which system??

A: A centrifugal fan is an open system. According to thermodynamics, an open system has both energy and…

Q: When is outdoor unit called evaporator

A: An evaporator is a heat exchanger device in which one fluid gets cooled (sensible cooling) by…

Q: placed by oil in the wate

A: Given Data : Water is replaced by oil in water pump

Q: dvantages in using a dual cylinder water pumping system using scotch yoke mechanism

Q: Which of the. compressors is not true? A. Scroll compressors operate with suction and discharge,…

A: Given Data : Scroll compressors

Q: The auxiliary fuel pumps are: a. electrically driven b. engine-driven. c. either electrically or…

A: SOLUTION: Fuel Pump: it is a device or a component of engine system that is used to draw a fuel…

Q: A one-way valve that lets air into the reservoir of a compressor, but does not let it out, is a…

A: Solution:

Q: Which type of compressor uses V-belt to create compression in the compresso

A: V-belt: These types of belt are most widely used in factories and workshops where a great amount of…

Q: For a hydraulic power unit, this part reads the oil pressure at the pump outlet

A: This question is based on the concept of Hydraulic power limit.

Q: Which of the following situations will make a pump noisy? Select all that apply. O Excessive oil…

A: Answer:- All given situations will make the pump noisy. The various situation that will make the…

Q: ________ occurs when the compressor is operating at high head and very low flow rates. a.surging and…

A: Given Data ________ occurs when the compressor is operating at high head and very low flow rates.

Q: For a hydraulic power unit, this part supplies the energy to cause the shaft of the pump to rotate.…

A: Option a is correct.

Q: For a hydraulic power unit, this part protects the pump from taking in any harmful particles that…

A: GIVEN DATA - A MCQ GIVEN RELATED TO PUMP WE HAVE TO CHOOSE CORRECT OPTION

Q: Non positive displacement pumps have a pressure up to Select one: O a. 700 bar 5 O b. 40x10 bar O C.…

A: non-positive displacement pump pressure??

Q: Explain what is the meant by critical pressure ratio of nozzle.

A: The answer is

Q: The condition of water leaving the pump of a Rankine cyde is O a Saturated liquid Ob Saturated vapor…

A: Turbine: The rotary mechanical device that converts the energy extracted from the fluid flow into…

Q: Discuss on why a need of improvement of a single stage compressor system is there and what are the…

Q: Centrifugal action in centrifugal pump is acting

A: Centrifugal pumps have been used to transport fluids by the conversion of rotational kinetic energy…

Q: What are the reasons for a noisy aircraft engine driven hydraulic pump and how to troubleshoot it

Q: What would be done to increase the compressor speedon a belt-driven compressor?A. Decrease drive…

A: Typically, belt pulley systems are used to drive the generators that power the compressors. The size…

Q: A.I) The term pressure drop refers to what in a hydraulic circuit a. The change in the flow rate in…

Q: How to operate single acting cylinder by using 3/2 direction control valve?

Q: __________________ is type of pump that the oil that comes from the suction side of the pump gets…

Q: The compressed air supply is intermittent in

A: Answer: (c) Piston compressor

Q: Satd. liquid water is throttled to a lower P. What happens to the state of the outlet? a. Saturated…

A: The saturation liquid water is throttled to lower pressure. The P-h diagram for this case is

Q: . If the speed of a centrifugal pump is doubled, its power consumption increases by ______ times a.…

A: If the speed of a centrifugal pump is doubled, its power consumption increases by ______ times.

Q: Draw the set-up for dehydration and clearing.

A: Draw the diagram for the clearing and the dehydration process.

Concept explainers

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.

Question

Water at 20°C is pumped between two large open reservoirs through 1.5 km of smooth pipe. The water surfaces in the two
reservoirs are at the same elevation. When the pump adds 35 kW to the water. the flowrate is 1 m/s. If minor losses are
negligible, determine the pipe diameter.
D=
m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The relative velocity of steam at blade inlet is 380 m/s and the losses in blade is 15%. The relative velocity of steam at blade outlet iS O a. 325 m/s O b. 327 m/s Oc 321 m/s O d. 323 m/s
What part is often changed with a water pump? Select one: a. A crankshaft pulley b. A timing belt C. An alternator d. A starter motor
7
Describe with mechanism abut how a boiler feed water telreatment sytem work
Which among the valves is called non return valve a.flap check b.ball c.plunger valve d.diaphragm e.Check
What is the function of a pilot-to-close check valve in a pneumatic system? A. Allows flow in reverse direction but to foward B. Blocks flow in reverse direction but not forward C. Allows flow in either direction D. Blocks flow in either direction Allows flow in reverse direction but not forward. Blocks flow in reverse direction but not forward. Allows flow in either direction. Blocks flow in either direction.
When the air bubbles collapse at the eye of the impeller of a centrifugal pump, due to low väpour pressure, it causes O a. Priming b. excess fluid flow O c. Cavitaion O d. excess fluid pressure
What is definition of natural gas compressor?
Mark true false 1.Changing the expansion device from a turbine to a throttle increases the COP 2.
What causes coolant to leak from the water pump weep hole? Select one: a. A faulty thermostat b. A faulty radiator cap C. A faulty bypass hose d. A faulty pump shaft seal
What is rotary compressor pump?
When there is an excess potential energy during the fluid flow, it can be stored using O a. pressure relief valve. O b. pressure reducing valve. O C. accumulator. O d. pressure absorbing valve.