e) What type of basic meter is configured as a wattmeter?

Q: what are the two main classifications of resistors?

A: Two main classifications of the resistors are:  1-Fixed or constant resistor 2- Variable resistor…

Q: Where the 7 ohm came from?

A: Given: Note: The previous solution given is not correct. Below is a detailed solution for the given…

Q: Electric meters can run backward for homeowners participating in net metering

A: Net metering is a billing arrangement that allows homeowners with solar panels or other renewable…

Q: Explain in paragraph the relationships of resistance, voltage and current, and the distribution of…

A: Question is asking about relationships of resistance, voltage and current  also distribution of…

Q: What does it mean if a power supply exhibits 2% voltage regulation?

A: - Every power supply is rated with certain specified voltage level. - Regulation denotes the…

Q: The suitability of using a multi-meter to measure current, voltage and resistance.

A:

Q: 5. What will this voltmeter register when connected to a battery as shown (assume a battery voltage…

A: Given circuit diagram:

Q: RI R3

A: The total current supplied by the voltage source (IT) is the ratio of voltage of voltage source and…

Q: What is different cost of electrical energy?

A: In real world nothing comes for free, everything has their own cost to produce or use it. Similarly,…

Q: Which of the following is true? a. A meter rated CAT III may be used for CAT II measurement. b. A…

A: CAT ratings are categorised rating of overvoltage measurements. They are as follows. CAT I…

Q: What is indicating when I'm reading a 26 ohms on my meter?

A: Reading 26 ohms on meter

Q: How is an ammeter connected into a circuit

A: An ammeter is an apparatus which is used to compute current in the circuit. An ammeter has a fixed…

Q: An electrical circuit must contain:       A)  a load, connecting wires, and a fuse   B)  a load,…

A: option b is correct Practical electric circuit requires a source to supply power to the circuit and…

Q: what are devices helps prevent electrical fires before they happen? like "ting"

A: Electrical fire prevention devices: They are the smart devices which are connected through the…

Q: 5. Explain the hazards of using batteries. 6. Write the 4 conventional kinds of primary batteries.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: what are two additional terms used to identify voltage?

A: For example, in a battery to represent the fundamental characteristic of it, the term voltage is…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.