e total time the machiniries

Q: 14)The vibrating frequency used for the tool . in Ultrasonic machining is of the order of O10,000…

A: Ultrasonic machining is a machining process in which material is removed from the surface of the…

Q: Write the definition for shafts?

A: Shafts are the rotating machine elements which are used to transmit power from one part to another.…

Q: Mechanical working of metal is another name for_______________. a. Machining process b. Metal…

A: Mechanical working of metal is another name for Forming process. Answer: d. Forming Process

Q: he process of machining the start of a drilled hole to make a conical shape or angle is known as:…

A: Given: In this question multiple choice is given so we will learn about them one by one

Q: The cutting speed of a drill depends upon the A•material of drill B•type of material to be drilled…

A: The cutting speed of the drill is the speed at which the drill rotate in order to cut the material…

Q: 6. Approximate a spindle speed of 1000 rpm into rad/s. Spindle diameter = 200 mm 2.25 rad/s .16 mm/s…

A:

Q: Approximate a spindle speed of 1000 rpm into rad/s. Spindle diameter = 200 mm a. 2.25 rad/s b. .16…

A: The rotational speed of the spindle,(N)=1000 rpm The diameter of the spindle,(d)=200 mm Determine…

Q: What type of sectional view is used? a. b. What is the total number of holes in the part? Note that…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.