You are attempting to raise a 7.5 m long, 35 kg6.mass, and 42 cm diameter flagpole that has a hinge at thebase. You pull a rope attached to the center of the pole atan angle of 26° (rope to flagpole) and the flagpole is 50.1°off the ground, as seen in the figure below. What forcemust you exert on the rope to hold the pole motionless inthe position below?

Answered: Image /qna-images/answer/02a56b03-4428-49c8-a8a5-f45e4f372689.jpg

e attempting to raise a 7.5 m long, n diameter flagpole that has a hing a rope attached to the center of th (rope to flagpole) and the flagpole as seen in the figure below. What on the rope to hold the pole moti ow?

e attempting to raise a 7.5 m long, n diameter flagpole that has a hing a rope attached to the center of th (rope to flagpole) and the flagpole as seen in the figure below. What on the rope to hold the pole moti ow?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The rod is then cut and rotates bout the hinge to a vertical position, where it collides with and sticks to a lump of clay of mass 2.4 kg, as shown. a. What is the angular speed of the rod just before it collides with the clay? b. What is the angular speed of the rod-clay system just after the collision?
A 20.3kg floodlight in a park is supported at the end of a horizontal beam of negligible mass that is hinged to a pole, as shown in the figure below. A cable at an angle of a = 26.4° with the beam helps to support the light. a Find the tension in the cable connecting the pole to the beam. Submit Answer Tries 0/10 Find the horizontal force exerted on the beam by the pole. Submit Answer Tries 0/10 Find the vertical force exerted on the beam by the pole. Submit Answer Tries 0/10
Please solve and answer the question correctly. Thank you!!
Consider a rower in a scull as shown. The oars aren’t accelerating, and they are rotating at a constant speed, so the net force and net torqueon the oars are zero. An oar is 2.8 m long, and the rower pulls with a 250 N force on the handle, which is 0.92 m from the pivot.a. Assume that the oar touches the water at its very end. What is the drag force from the water on the oar? Assume that the oar is perpendicular to the boat, and that the force of the rower and the drag force are both perpendicular to the oar.b. Given that both oars are the same, what is the total force propelling the boat forward?
Please Asap
A clever witch is social distancing during trick-or-treating by sticking her pumpkin-shaped bucket full of candy on the end of her broomstick. Her broomstick has a length of L = 1.2 m and she holds it Broomstick ly. The broomstick has a mass of 1.10 kg and the pumpkin has a mass of 2.4 kg. The witch holds her hands a distance of d = 0.80 m apart. L d. What is the force from the hand on the end of the broom? This is the hand on the left in the figure. FL = What is the force from the hand closer to the middle of the broom? This is the hand on the right in the figure. FR = N
A refrigerator of width wand height h rests on a roughincline as in Figure P8.31.Find an expression for themaximum value θ can havebefore the refrigerator tipsover. Note, the contact pointbetween the refrigerator andincline shifts as θ increasesand treat the refrigerator asa uniform box.
W A large block of wood has the shape of an isosceles trapezoid, as shown in the figure. The bottom end of the 1.79 m, and the top end has a block has a width of w %3D width w = 1.15 m. %3D If the center of gravity of the block is located a distance = 1.15 m directly above the midpoint of the base, what heg is the maximum tipping angle that the block can undergo before tumbling over? Wb maximum tipping angle: Assume the total height of the block is 2.485 m. If the block were resting on its narrow end, how far could it be tipped from that position without it falling over? maximum tipping angle:
W Two wheels A and B with weights w and 7w, respectively, are connected by a uniform rod with weight as shown below. 6 The wheels are free to roll on the sloped surfaces. Determine the angle (in degrees) that the rod forms with the horizontal when the system is in equilibrium. Hint: There are five forces acting on the rod, which is two weights of the wheels, two normal reaction forces at points where the wheels make contacts with the wedge, and the weight of the rod. (Enter the smallest angle.) 15.175 B 30° 60° A
II1. E is the solid bounded by the parabolic cylinder z = 1 – y² and the planes x + z = 1, x = point is proportional to the distance to the xy-plane. Find the center of mass. 0, and z = 0. The density at each
H Review Multiple-Concept Example 7 to see the basic ideas underlying this problem. A stone has a mass of 7.98 g and is wedged into the tread of an automobile tire, as the drawing shows. The coefficient of static friction between the stone and each side of the tread channel is 0.979. When the tire surface is rotating at 11.1 m/s, the stone flies out of the tread. The magnitude FN of the normal force that each side of the tread channel exerts on the stone is 1.55 N. Assume that only static friction supplies the centripetal force, and determine the radius r of the tire (in terms of m). Number i 0.65 Type here to search 3 4 Units % 5 F5 m 6 Y F6 F7 & 7 7 Sides of tread channel 8 FN 9 48°F Mostly cloudy F10 s 17
62. I A 120-cm-wide sign hangs from a 5.0 kg. 200-cm-long pole. A cable of negligible mass supports the end of the rod as shown in FIGURE P12.62. What is the maximum mass of the sign if the maximum tension in the cable without Cable 250 cm breaking is 300 N? 200 cm PRISICS SHOPPE 80 cm FIGURE P12.62 3/3