During a steady right turn, a person exerts the forces shown on the steering wheel. Note that each force consists of a tangential component and a radially-inward component. Determine the moment exerted about the steering column at O. The moment will be positive if counterclockwise, negative if clockwise. 20° Answer: M- 33° 375 mm I 7.1 N 33° 7.1 N 2.233 B 20⁰ N.m

During a steady right turn, a person exerts the forces shown on the steering wheel. Note that each force consists of a tangential component and a radially-inward component. Determine the moment exerted about the steering column at O. The moment will be positive if counterclockwise, negative if clockwise. 20° Answer: M- 33° 375 mm I 7.1 N 33° 7.1 N 2.233 B 20⁰ N.m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Question 34 of 46 A man exerts a force Fon the handle of the stationary wheelbarrow at A. The weight of the wheelbarrow along with its load of dirt is 215 lb with center of gravity at G. For the configuration shown, what force F must the man apply at A to make the net moment about the tire contact point B equal to zero? Assume a = 43 in., b = 8 in., h = 22 in., 0 = 24°, and = 50°. %3D %3D W B. Answer: F = Ib
The 58 kg uniform beam (slender rod) is lying on the floor when the man exerts a force of F = 336 N on the rope, which passes over a small smooth peg at C. a) Determine the initial angular acceleration of the beam, in rad/s2. b) Find the horizontal reaction on the beam at A (considered to be a pin) at this instant. Express your answer in Newtons.
! * Determine the component of each forces, the magnitude and direction of the resultant force. F₂ = 150 N 135.94 54.8 F1x (N) F1y (N) O F2X O (N) F2Y(N) R (N) O F₁ = 100 N 15° 147.72 26.04 O O O
M 10kN/m IM I'm Im 3 Solve for the support reactions and moment using three moment equation.
The mechanism for a car window winder is shown in the figure. Here the handle turns the small cog C, which rotates the spur gear S, thereby rotating the fixed-connected lever AB which raises track D in which the window rests. The window is free to slide on the track. If the handle is wound at 0.5 rad/s, determine the speed of points A and E and the speed vw of the window at the instant = 40°. - D 20 mm 0.5 rad/s 50 mm B 0 -200 mm -200 mm A E
Please draw the complete free body diagram including the components. And give explanations for the correct Answer
Consider the portal frame shown in the figure and assume the modulus of elasticity, E = 3.5 x 104 MPa and the moment of inertia, I = 9 × 108 mm4 for all the members of the frame. A 2m 1650 kN/m ot - 2000 KN P E,I Q E,I R E,I S 4m 4m The rotation (in degrees, up to one decimal place) at the rigid joint Q would be
During a steady right turn, a person exerts the forces shown on the steering wheel. Note that each force consists of a tangential component and a radially-inward component. Determine the moment exerted about the steering column at O. The moment will be positive if counterclockwise, negative if clockwise. 7.8 N 26 14° 14° Answer: M = 380 mm i 26° 7.8 N B N.m
A 7-meter tall post is sunk firmly into the ground. Two tension forces are applied to the top of the post as shown in the diagram below. Tension 1 has magnitude of 6 Newtons and acts horizontally. Tension 2 has a magnitude of 7 Newtons and acts 34 degrees below horizontal. What is the expected reaction moment, in N-m, at the base of the post at A? Remember positive moments act counterclockwise and negative moments act clockwise. T1 7m A Ꮎ T₂
determine the menber end moments and reactions for the frames shown by using the slope - deflection method
A car depicted in figure below is moving on a simply supported beam bridge AB. The front tyre and back tyre having a load of 9kN and 7kN respectively. The distance between front and back tyre is 3m. Using (Influence line) determine the reaction support of the beam when the front tyre of the car is. a) At mid span of the beam b) On top of support
Answer close to 8.55