During a pregame warmup period, two basketballs collide above the hoop when in the positions shown. Just before impact, ball 1 has a velocity v₁ which makes a 30° angle with the horizontal. If the velocity v₂ of ball 2 just before impact has the same magnitude as v₁, determine the two possible values of the angle 0, measured from the horizontal, which will cause ball 1 to go directly through the center of the basket. The coefficient of restitution is e = 0.8. Assume ball 2's position just touches the horizontal line. The line of action can be computed from the drawing on the right. 2 1 10₁ 30° 15 2 V₁ XT200

During a pregame warmup period, two basketballs collide above the hoop when in the positions shown. Just before impact, ball 1 has a velocity v₁ which makes a 30° angle with the horizontal. If the velocity v₂ of ball 2 just before impact has the same magnitude as v₁, determine the two possible values of the angle 0, measured from the horizontal, which will cause ball 1 to go directly through the center of the basket. The coefficient of restitution is e = 0.8. Assume ball 2's position just touches the horizontal line. The line of action can be computed from the drawing on the right. 2 1 10₁ 30° 15 2 V₁ XT200

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Negative force and Displacement will cause compression andcontraction? True or False?
can this be done using simpsons rule?
Needs Complete and correct solution don't use chat gpt or ai i definitely upvote you. thank you.
Please use your own words. Do not copy paste. Explain this answer briefly. I don't want long answer.
A six inch diameter cylinder with a two inch rod pushes out its full stroke of 20 inches in 1.5 seconds the pushing load is 750 pounds while the pulling load is 600 pounds. The pulling of the cylinder takes place in 1.2 seconds. What are the ranges of sizes of the valve that should be used?
In a lathe machine, The diameter of the driver and driven pulley are 2130 mm and 1590 mm respectively, And the driver pulley runs at speed of 205 rpm. Find the speed at which is driven pulley runs in the machine. the speed of the driven pulley in rpm is
What is the Falling Block?
Engineering Drawing: Dimensions
23) In wire drawing process, the cross sectional area of wire is reduced. Select one: True False
in speed during bending why are you multiplying the speed during bending by 5/18
Select the correct statements regarding the addition of moments. (Select 3) Moments have directions, so a negative value implies it is along the opposite direction from the reference direction. All the moments need to have the same reference point/pivot in order to add together. Calculate each moment by multiplying each force with its distance to the reference point, and add all values together, regardless of their direction. You have to define the reference direction first, either clockwise or counter-clockwise.
In a lathe machine, The diameter of the driver and driven pulley are 2745 mm and 1200 mm respectively, And the driver pulley runs at speed of 225 rpm. Find the speed at which is driven pulley runs in the machine. the speed of the driven pulley in rpm is