Draw the shear and moment diagrams for the loaded beam. After you have the diagrams, answer the questions as a check on your work. 16 KN 3 kN/m 5 kN/m B 6 m 12 m when x = 10, V=Blank 1kN, M=Blank 2kNm Absolute Vmax=Blank 3kN Absolute Mmax=Blank 4kNm Round your answers up to 3 decimal places. +3m 3 m3 m

Q: Define PDOP?

A: PDOP ( Position dilution of precision) It describes the error caused by the relative position of the…

Q: From the given closed traversed shown LINES AB BC CD DE EA BEARING S 35° 30' W N 57°15' W N 1° 45' E…

A:

Q: What are inaccessible points?

A: Points which cannot be viewed via ranging rods or other instruments directly from a point of…

Q: Explain what is Morganstern Charts for Rapid Drawdown?

A: The introduction to Morganstern's stability charts for earth slopes during rapid draw down is as…

Q: Explain Footings on Slopes.

A: Foundation is just the house's substructure. The base carries the construction weight and moves it…

Q: 3. A circular steel bar with cross sectional area of 4 in is loaded as shown. a) Compute the shear…

A:

Q: What is a site plan? Discuss it. (M Please cite reference as per APA

A: A site plan is a detailed drawing that shows the area where the building has to be constructed…

Q: What are velocity charts?

A: The Velocity Chart displays the value amount delivered in each sprint so as to forecast the work…

Q: 1 / 2 \text { inch } \times 1 / 4

A: To find:- 1/2*1/4

Q: The Howe roof truss shown in figure below carried the given loads. The wind loads are perpendicular…

A: A Howe truss is a type of truss bridge that consists of chords, verticals, and diagonals with…

Q: give me answer for 700 m radius?

A: Design speed (V) = 80 kmph Superelevation provided (e) = 7% or 0.07Radius (R) = 700 m

Q: Find the area for each. Then put in square feet and square yards

A:

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.