Draw the isometric view using creo parametic ,3D view and attach the file -Ø 26 Ø 10 Ø 7- R 20- R 4- Ø 50- 4 DEEP BOTH SIOES-

Q: Draw the cavalier oblique projection of the object. Use 45° for the third axis.

A: Refer the following Cavalier Oblique view of the given orthographic views.

Q: Given the multiview projection of the solid, draw the isometric view.

A: Given:To find:Draw the isometric view.

Q: Title: Object 3 Draw the isometric projection in this location. All dimensions are in mm

A: Isometric projection Isometric projection is a method for representing three-dimensional objects…

Q: sketch the isometric view of the BASE plate of the crosshead assembly and also sketch the top view…

A:

Q: Q1/ Draw Sectional Front view (Front section), Sectional Side view (Side section),and Draw the…

A: Top view of an object is referred as the sketch of the object that is visible to an observer when…

Q: Q1. Force F = {270i + 450j –140k} N and it passes point B. The coordinates of the points are: A (21,…

A: Given: The force acting, F = (270i+450j-140k) N The distance between O and B, OB = 21 cm The…

Q: Given the multiview projection of the solid, draw the isometric view. HRP FRP F DA FRP PRP

A: Given the multiview projection of the solid, draw the isometric view.

Q: Draw the isometric pictorial of the object. Use the given front, right, and top views in their…

A: According to the given data A three Projection view of the object is given We need to draw Isometric…

Q: The three planes of 'orthographic' projection of an object are presented in Figure 1.1 below. Draw…

A: Draw the isometric block according to dimensions of the object as shown in the image:

Q: A Figure 2 shows an isometric view of an object. Draw to a full size scale the following views in…

A: the given iso metric view is draw below

Q: Based on the following orthographic projections for each object, generate a full-scale isometric…

A: Isometric projection Isometric projection is a method for representing three-dimensional objects…

Q: 3. Pin P at the end of the telescoping rod as shown in Figure-2 slides along 40x, where x and y are…

A:

Q: OFFSET 040 24 30 024 ? 25 20 FRONT VIEW OBUQUE SECION RIGHT SIDE VIEW SECTION VIEW SHEET 1 SHEET 2…

A: Please see the below views drawn in scale 1:1

Q: Draw Front View and Top View of the following component

A: Solution:

Q: Please draw it on grid sheet with proper dimensions

A: Solution:   Scale:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.