Draw the influence line for (internal) bending moment MĘ. Enter the magnitude of your influence line when the load is at B [ Select ] and D [Select ] A В D E Hinge 8 m- -6 m- -4 m→-3 m

Q: Draw the influence line for the force in member CD.

A: During the movement of a concentrated force across a member, the influence line represents…

Q: Question 2: Draw the influence line for the force in member DK. L K H G 1.5 m B] E D -2 m-2 m-–2…

A:

Q: 1. Draw the influence line for the forces in bars CG, HD and EF of the truss shown in Figure 1.…

A: Dead load:15 kN/mLive load: To determine:Maximum forces in CG, HD and EF by drawing ILD of forces.

Q: Draw the influence line for shear force Vc. Enter the magnitude of your and G influence line when…

A:

Q: Draw the influence line for (a) the moment at C, (b) the shear just to the right of the support at…

A: Question is based on section supported on hinge and roller support . Length of span is given in the…

Q: Draw the influence line for member BC and interpret the diagram.

A: Solution: Considering the diagram of Truss: Applying a unit load at x from point A and find the…

Q: The designed to withstand a uniformly distributed live load of 60 kN/m, a dead load of 20 kN/m, and…

A:

Q: Can you please explain using muller breslau law principle step by step

A: Informações da figuraThe figure shows a beam supported on three supports A, B, and C. Support A is a…

Q: Draw the influence line for (internal) bending moment MA. Enter the magnitude of your influence line…

A:

Q: 2. Draw the influence line for the force in (a) member EH and (b) member JE. M C B D E F m-4 m 4 m 4…

A: Given :

Q: Determine quantitatively the influence lines for Ay, ME and VẸ for the statically determine system…

A: Data given: Asked: Influence lines for Ay, ME and VE

Q: For the simply supported beam shown, draw influence lines for moment at C (12-ft from support A),…

A: when the unit load at A and B then bending moment at C equal to 0 .and if the unit load at C then…

Q: Draw the influence line for the force in member CD.

A:

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.