Draw rankine cycle with one open type feed water heater. Assume the condition of the steam before entering the turbine to be superheated. Sketch the cycle on T-s diagram.  b) in an ideal reheat cycle, the steam enters the turbine at 30 bar and 500°C after expansion to 5 bar, the steam is reheated to 500°Cand then expanded to the condenser pressure of 0.1 bar. Determine the cycle thermal efficiency, mass flow rate of steam. Take power output as 100 MW.

Q: A ideal rankine power plant cycle uses ammonia as the working fluid. Saturated vapor leaves the…

A: Given:TH=85°CTL=40°C

Q: The net work output and the thermal efficiency for the Carnot and the simple ideal Rankine cycles…

A: Given, Both the Rankin and Carnot cycles are operated between same pressure limits. Boiler pressure…

Q: Draw the schematic or plant layout. Draw the T-s diagram Mandatory: A, B, C Suggested: D, E, F…

A:

Q: 7. Consider a regenerative vapor power cycle with two feedwater heaters, a closed one and an open…

A: P1 =12MPa = 120barT1= 480°CP1= 2MPa = 20barT1= 440°CP2=2MPa = 20barP3=0.3MPa = 3barPc=P4 = 6kPa =…

Q: It has been decided to operate a steam power station on a Rankine Cycle with a relatively high…

A: Process 1 - 2 : Isentropic expansion process (Turbine).Process 2 - 3 : Constant pressure heat…

Q: 4. Steam at 10 MPa, 600°C enters the first-stage turbine of an ideal Rankine cycle with reheat. The…

A:

Q: Water is the working fluid in an ideal Rankine cycle with reheat. Superheated vapor enters the…

A: Back work ratio: The Back work ratio is nothing but the ratio of the pump work to the turbine work.…