draw frequency response on semi log paper

Q: in matlab What are the possible ways to fix the error in the following model? Interpreted MATLAB Fan…

A: Scope block in matlab is used to see the simulation results The display block in matlab is used to…

Q: nput to the step up chopper is 161 V. The output required is 510 V. If the conducting   time of…

A: Given Data:A step-up chopper with,Input voltage Output voltage On-time To Find;The output voltage…

Q: . val 01 Dland D2 1) The PWM is new thechnigue adopted in power electronics application .explaine…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: Information: 2 Vp-p (Am = 1V) 20 Hz sine wave Carrier: 4 Vp-p (Ac = 2V) 500 Hz sine wave Modulation…

A: Given message signal is Amplitude, Am =1V frequency, fm=20Hz Hence,…

Q: Q) The frequency is relating to time period-- Square proportional. O Not related. Directly…

A: Frequency f = 1 / Time period. Or time period =1/ frequency.

Q: using the purtiel fraction Xcnd for me thed to frnd + 2 for

A: From the Z transform properties

Q: Design Wien-bridge and ose to get sin wave F = 3000 HZ 1 signal

A: The wein bridge oscillator is a low frequency oscillator which generates sinusoidal waveform based…

Q: Identify the nature of the signals 700 YL" 700 An x 100 À Discrete time & discrete amplitude…

A: Given four signals  Let us name the above signals as a ,b,c ,d signals  b ,d are right side  a,c are…

Q: Problem #2 - A digital signal is to be represented by a positive voltage A for a "1" and negative…

A:

Q: the folding frequency of a sinusoidal signal with sampling rate 30 khz and 6000 samples is

A: Given data Sampling rate of sinusoidal signal (f) = 30 KHz  No of samples = 6000

Q: The carrier frequency is 500 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

A: For given Amplitude modulation we need to calculate peak voltage level for modulating signal .

Q: Select one: O a. 4v2 O b. V3 O c. V5 O d. V14

A:

Q: If the frequency of the input signal is 200 Hz, the frequency of the half-wave rectified signal…

A: Given: In a half wave rectifier frequency of the input signal is, fin=200 Hz.

Q: Rin Each R is 10 2

A: We will use star to delta and delta to star conversion then we will use series and parallel…

Q: In a CE configuration, the output voltage is with the input voltage. O a. in-phase O b. out-of-phase…

A: Answer: b.out-of-phase by 180 degrees.

Q: Write output waveform 20kQ 10kQ INPUT OUTPUT Write output waveform 20ΚΩ aww 10kQ INPUT A OUTPUT

A:

Q: What is (j205-j307+j47)-1? a. 1 b. -1 c. j d. -j

A: What is (j205-j307+j47)-1? a. 1 b. -1 c. j d. -j

Q: Signal B 100kHz cos Adder Carrier + Messoge (Sine) 100KHZ SINE 10kHz Signal A

A: Modulation- It is technique by which properties of a signal can be modified or varied.

Q: Design a sequential circuit that has one input (x) and one output (z) to detect z=1) the input…

A: State diagram for 10001 or 000 Present state Next state     PS input x=0 input x=1 Z S0 S0…

Q: Skelch the vesponce : for aunit step change in Tics) O without coutoller coPen Ioop) Q with…

A: The response is determined for with controller and without controller

Q: an inductive proximity sensor is used detect the presence of car in traffic light.the out put circut…

A: Given data : Frequency of output circuit  fo=30 KHz Change the signal frequency ∆f=10 KHz

Q: Continous signal t=B10s Quont a) Find Nyquit kate If squping faopueey fud dlscnlte signal xin2e

A: Sampling is  process of converting Analog signal in to discrete signal. The sampling theorem states…

Q: Calculate the frequency of a Wien bridge oscillator circuit when R d R₁ R₂" Ra b +Vcc 9 Op-amp -VEE…

A: SOLUTION GIVEN-->                 R =10K ohm                 C =…

Q: Find the natural frequency for this system with its closed-loop poles as shown.

A:

Q: Vin C₁ HH R₁ W Ao Vout Q2. The differentiator above is used to amplify a sinusoidal input at a…

A: Given:a circuit, Above circuit is amplifying input signal by a factor of 5 at a frequency of 1 MHz.…

Q: Please explain the waveforms, what are the reason why does the 3rd waveform is attenuated. 1st…

A: An electrical waveform is basically a visual representation of the variation of voltage or current…

Q: Q/Exprees the de cinaluumbe (83)(-85)2 see complemust )

A:

Q: H.W: A resistor of resistance R=1000 S2is maintained at 17 °C and it shunted by 100 uH inductor.…

A:

Q: 0.4 Σ 0.25 0.9 1.5 C 0.45

A: while shifting summing point before the block we have to add 1.5 block to the feedback network and…

Q: what frequencies will the output waveform be half-wave rectified? A full-wave rectified?

A:

Q: The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

A:

Q: SHOW COMPLETE SOUTION C2 Cs C8 C7 a=C2 -Ca - 4MF C4 = Cr =Co 2MF CT= C8 = 6AF %3D 1. CNTAL - ?

A: In this question we will find total capacitance and total charge and charge on C2.. Note:- as per…

Q: s² + 420s Q(s) Pao(s) s2 + 620s + 4000

A: The given transfer function is a type 0 system. On comparing the denominator of the transfer…

Q: Which of the following its not a dynamic property? Select one a saturation time b, response time c…

A: Saturation time is not a dynamic property.                 Saturation refers to the point at which…

Q: In digital frequency meter, converts input signal into a square wave, which has a fast rise and fall…

A: Digital frequency meter is used to measure the frequency in a circuit.

Q: Draw the following signal 10-10e-10t Please upload picure of your graph.

A: Given: The signal is, y=10-10e-10t

Q: Draco the CMOs circuit layout for the following and implement the layouts Micro wind Simulation. and…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: I sketeb out the fellewing signals: (a=5, b=3, c=2) a-) V = 15a(sin211000* ct) b-) V =…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: the signal is sampled at a rate of FS. Determine the alias frequencies in the recorded data set if…

A: for each case:For fs​=40 Hz: Aliasing will occur for frequencies above 20 Hz.For fs​=22 Hz: Aliasing…

Q: Which of the following is not a part of the PLL O a. Loop filter O b. phase detector O c.…

A: In this question, choose the correct options Which is the following is not a part of PLL.    as per…

Q: Find value of R

A: In this answer we will try to find the value of R using the mesh equation technique as shown below.