Do not use shift solve show complete solution

Q: Q3) For the mechanism shown in the figure: 1. Determine the numbers of links, joints, and…

A: Solution: Given Data:   To Find: (a) Number of links, joints and Instantaneous centers? (b) List…

Q: Identify the number of links, full joints and half joints, and then determine the degree of freedom…

A: Identify the number of links, full joints and half joints, and then determine the degree of freedom…

Q: Show how you would find the velocity of each point (no values given just the equation) for an…

A:

Q: A 13 in pulley turns at 30 rpms find the constant of inverse variations

A: Write the formula for the constant of the inverse variations. Nd=k Here, k is the constant of the…

Q: would find the velocity of each point (no values given just the equation) for an…

A:

Q: For the quick-return mechanism (at the instant shown): = 7/6 rad = -0.2 rad/s $=0 Perform a complete…

A: Given data;Initial angle of the crank ; Angular velocity of the crank ; Angular acceleration of the…

Q: #4 Balancing Torques 0.0 1.0 2.0 3.0 4.0 5.0 6.0 3.2 N 1.5 N 2.5 N in the the fulom (niuot the 2.0

A: given

Q: e numerical value for the ideal mechanical advantage of a bicycle with 10 teeth on e effort gear and…

A: Solution is attached below

Q: In the drawing, arm A is being driven back and forth in the direction of the arrows. It is connected…

A: Solution: Given Data: Screw B is lowered towards the end of arm A.   To Find: What happens to the…

Q: Identify the number of links, full joints and half joints, and then determine the degree of freedom…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The machine is being designed to carry out a pressing operation, as part of this a dual flywheel…

A: Answer: (a) Initial kinetic energy = 4875 Joule (b) Final kinetic energy = 4602.3 Joule (c) Energy…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.