Discuss the operation and advantages of the application of light-touch auto-re-closers(pulse closing) on a distribution network.including a list of disadvantages of conventional re-closing and the sketch of the comparison of the waveforms generated by both conventional re-closing and pulse closing

Q: An NRZ polar code is using the following function to represent the l's: p(1) = s inc(xt /T,) a) Find…

A:

Q: Figure Q2 (b) shows a controlled full-wave bridge rectifier has a source of 200 V rms at 50 Hz, an…

A: Given that,  The source voltage, Vs is 200 V. The frequency, f is 50 Hz. The resistance, R is 50 Ω.…

Q: Question 8: In half-wave rectifier, what is the output frequency if the input frequency is 50HZ.…

A: Ans:- Image-1

Q: :A confocal resonator is 1m long, which I used in the He-Ne laser. Calculate the spot size in the…

A:

Q: Explain the basic characteristics of a Butterworth filter and how the characteristic is achieved.

A: The filter is an electric n/w in any circuit theory, that used to change either phase or amplitude…

Q: An interference filter is to be constructed for isolation of the nitrobenzene absorption band at…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An air-filled parallel plate capacitor is fed with a sinusoidal signal V = 20sin(10³i) mV. Calculate…

A: Given: V = 20 sin (103t) mV = 0.02 sin(103 t) VA = 10 cm2=10*10-4 m2d =2 mm = 2*10-3 m

Q: Calculate the longest wave length that can analyses by a rock salt crystal of spacing d = 2.82 A° in…

A:

Q: How would you design a 1.5 µm edge- emitting semiconductor laser to generate a 40 GHz pulse stream?…

A: Given: v=40 GHz L=1.5 μm

Q: A light with a wavelength of 450nm is directed at a solution with an absorbance of 0.1 OD for that…

A: Given Wavelength of the light =450 nm Absorbance= 0.1 OD

Q: In a symmetric slab waveguide, n₁ = 1.50, n₂ = 1.45, and d = 10 μm. (a) What is the phase velocity…

A: It is given that there is a symmetric slab waveguide. Here, n1=1.50, n2=1.45 and d=10 μm. It is…

Q: a b с Consider electromagnetic waves for which the relation γεμ /w² - w² C between wave number k and…

A: You have provided a question with multiple parts. So according to our guidelines, I can only solve…

Q: Example 7.4 Calculation of wall energy and thickness from anisotropy energy, saturation…

A: Exchange energy,  J=3×10-21JSaturation magnetization, Ms=0.38×106 A/mAnisotropy energy, K=33×104…

Q: ence in gain betweer (b) as a ratio of the

A: Given as, Maximum gain of horn antenna=+20 dB, Gain of 1st sidelobe=−15 dB.

Q: Calculate the beamwidth between first nulls & gain in dB for a 2.5m paraboloid reflector used at…

A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…

Q: For a BJT , if the Q-point was at the upper part of the load-line with normal 2 sources bias; if IB…

A:

Q: Figure 1. illustrates a parallel-plate capacitor of radius 3 cm, made of lossy dielectric material…

A:

Q: A filter material has a porosity of 0.75 and the Filter Path length is 2 mm. The dia of individual…

A: Calculate the total Single fiber efficiency by the following equation. E=1-exp-2αEεhπ1-α rf…

Q: The first layer of a three-layer cascade microwave system is a filter, the second and the third…

A: Given: T0=290KG2=9dBG3=18dBF2=3dBF3=2dB

Q: 8.2-7 Single-Mode Waveguide. What is the largest thickness d of a planar symmetric dielectric…

A: What is the largest thickness d of a planar symmetric dielectric waveguide with refractive indexes…

Q: Draw and describe a typical structure of avalanche photodiode? Why do they make a p+ layer located…

A: Avalanche photodiode is a type of diode that use the avalanche process to improve performance over…

Q: A continuous-time signal x(t) has a bandlimited spectrum with the highest frequency of 5KHZ is…

A:

Q: 13.2-2 Photon Flux. Demonstrate that the power of a monochromatic optical beam that carries an…

A: Solution:

Q: Prove that the coherence distance of the laser emission is d = 4 and find its valued if the %3D…

A:

Q: A uniform plane wave in free space is given by: Exs=800cos⁡(10^8t - βz)az   V/m Find: Phase…

A:

Q: (a) First, to capture the full generality of the wave equation solutions, find the complex…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. A plane wave in air is incident normally upon the surface of a lossless, nonmagnetic dielectric…

A: Note : Out of given multiple questions, we solve only first question unless specified. You can…

Q: 4.32 Assume that an FM demodulator operates in the presence of sinusoidal interference. Show that…

A: The input to the discriminator, in the presence of sinusoidal noise,    xr(t)=Accosωct+Aicosωc+ωit…

Q: 5. Using the WKB method, find the transmission coefficient of a potential barrier given by : V(x) =…

A:

Q: What are the similarities and differences between the information signal m (t) obtained as a result…

A:

Q: 3.17 Let f(t) be a T-periodic signal and let g(t) be the signal given by 1 t g(t) f(u) du. a Jt-a…

A: Given:     f(t) be a T-periodic signal and let g(t) be a signal  g(t)=1a∫t-atf(u)du We have to…

Q: For the following message y(t): et/10 y(t) E. Using a uniform quantizer, find the number of bits…

A: (E) Given: The following message y(t). Introduction: The signal-to-noise ratio is a measure that…

Q: A baseband digital receiver for a polar binary non-return-to-zero (NRZ) coded signal uses an optimum…

A: Correct option c

Q: Q.1 Use a distribution of wave numbers of constant amplitude in a range k about ko such as Ak Ak <k<…

A: Here what we need to simply evaluate the integral as- y(x)=∫A(k)cos(kx)dkfor the distribution of…

Q: Calculate ripple factor of full wave rectifier.

A: We know that  Irms   =  Im/√2  Idc = 2Im / π  Where Im is the peak current We know that Ripple…

Q: A tungsten fi lament of a typical incandescent lightbulboperates at a temperature near 3000 K. At…

A: