Discuss the following transformation in TTT diagram at eutectoid composition with their microstructure. Q.6 Austenite to pearlite Pearlite to spheroidite Austenite to martensite i. ii. i1.

Q: A gear train is made up of five spur gears as shown in the figure. Gear 2 is driver and gear 6 is…

A: Given data, Figure shown gear train is made of five spur gears. Where,  Gear 2 is driver and gear 6…

Q: In the figure shown, gear A rotates at 300 rpm. Gear S is fixed and has 80 teeth. The three…

A: Write the given data. Speed of arm, Narm=180 rpmSpeed of anulus gear, NA=300 rpmSpeed of gear S,…

Q: You are given two shafts of equal lengths and made from the same material: a hollow shaft, with an…

A:

Q: COMPLETE THE ORTHOGRAPHIC AND ISOMETRIC VIEWS BELOW.

A: To find:Orthographic and isometric views.

Q: I need these 2 parts answered pertaining to the print provided. If you can not answer all 2 parts,…

A: AP-001The diameter of the hole that is inclined 15 is ϕ0.25. It can be viewed in the section A…

Q: Answer the following in the space provided. 39. Suppose the engine in a vehicle is delivering 550…

A: Data given-  T1 = 550 lb -ft  N1 = 5000 rpm  Gear ratio = 1.5/ 1 = 1.5

Q: Input shaft of the gear train shown below rotates at 1,500 RPM. The output shaft must rotate exactly…

A: Given data wA = 1500rpm wB= 500rpm  TA= 20

Q: What is the gear ratio supplied by the gear system shown to the right? (It is a single pitch…

A: Here number of teeth in gear ( Tg)=30 Here number of threads/teeth in worm (tw)=5 For single pitch…

Q: A gear train consists of three gears: a pinion (which is the driver), an idler, and a gear (which is…

A: Given:- The gear train of three gears Tidler=68  Tidler(to replace)=37 To find:- Velocity ratio…

Q: There are several failure modes by which gears can fail. Select the true statement from among the…

A:

Q: I want to buy a two METAL SPUR GEAR for my 2 pieces of G.I pipe with an 3 inches diameter (3mm…

A:

Q: Quenching is a process that can reduce the grain size and form a lot of grain boundaries in the…

A: Quenching: In this process metal is heated above its recrystallization and than cool it rapidly. The…

Q: For practical working gears as manufactured, typically the addendum, a, is larger than the dedendum,…

A: Addendum: The distance between the top land and the pitch circle on a gear tooth, is called as…

Q: The two gears in the picture below on the left are meshing together. The two gears in the picture on…

A: A-The two meshing gears have the same module. When two gear meshes, the module (which is defined as…

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.