Differentiate THREE (3) functions of DOSH and NIOSH according to your understanding?

Q: Compute the distance back to the channel "b"in mm. Fy = 250 MPa Using NSCP 2001, compute the axial…

A: ANSWER HAS DONE FOR THE FIRST 2 QUESTIONS 1. distance back to channel for 2 channels: Ix = Iy Iy =…

Q: 20kN 2AE 25KW solve for the internal force of member CD. 1. 3m 1.SAE ' 1-5AE ZAE 4m 2m 24E

A:

Q: What property is shown when you sprinkled pepper into the water? Discuss it, and make generalization…

A: The water surface exerts a surface tension. When the pepper powder is sprinkled uniformly on the…

Q: The Optimistic Time (O), Most likely Time (M) and Time (P) (in days) of the activities in the…

A: Given data- Optimistic time O, Most likely time M, Pessimistic time P given. To Find- The expected…

Q: A beam and a truss element are connected at joint 1 and loaded by 500 kN force. Use FEA to calculate…

A: The above problem can be solved by using the equilibrium equation by resolving the components in X…

Q: The bending stresses on an element are: om 25,00 psi or= 21,667 psi. There is a stress raiser with…

A: Given:σm = 2500 psiσr   = 21667 psiSy  = 80000psiSu  = 90000 psiSe  = 40000 psiKf    = 1.4

Q: Water flows through a horizont and a length of 100 m. The pres

A:

Q: Determine the equivalent mass (meq) to be located at C for the transitional masses connected by a…

A:

Q: Discuss the proper care of equipment and cleaning chemicals. Why?

A: A detailed list of all cleaning chemicals utilised in the plant, including how many gallons (and…

Q: Select from the following, the type of admixture that you will use if: The work will be carried out…

A: Type B admixture is to be used at the specified Location of Jericho as the temperature in that place…

Q: A suspension cable, having hinged supports at same level, has span of 30 m and maximum dip of 4 m.…

A: Span: 30 metersMaximum dip: 4 metersUniformly distributed load (UDL): 20 kN/meter throughout the…

Q: Question Two Prepare a data sheet & calculate the cost of painting a top and all sides of a Platform…

A:

Q: A town has an existing horizontal sedimentation flow tank with an overflow rate of 17 m³/day/m², and…

A:

Q: Define the Hiley's formula ?

A: Hiley's formula to calculate the ultimate capacity of the pile is given by, Qup=ηHηbWHS+C2 Here, ηH…

Q: The column A is hazard what is the column B of hazard?

A: Column hazards are usually observed in oil and gas industries. Distillation columns which are a key…

Q: Determine the member of forces of the truss. Utilize Method of joints and Method of section Put if…

A: To find force in all members of the truss

Q: Fundamentals of Computation - Set K Practice Problem No. 3 Dutermine the interior angles of the…

A: Given data:

Q: Apply knowledge of laboratory safety.

A: Safety in the laboratory knowledge 1) Using the standard operating procedurea) General personal…

Q: 1.7.2 Plot load vs.penetration graph and determine the in-situ CBR value for this layer. Calibration…

A: Given data:

Q: A three hinged semi-circular arch of radius R carries a uniformly distributed load of w per unit run…

A: For a three hinged semi-circular arch of radius R carries a uniformly distributed load of w per unit…

Q: The truss shown in the figure is applied with force P = 5 KN. 1.50 m 1.50 m 1.50 m P B 2 m 2 m 1.…

A: Method of joints: In this method, a joint is isolated by considering all the forces acting at that…

Q: Give 4 ways of preventing contamination of stock chemicals. and what is the purpose of using glass…

A: Concept Introduction- Chemicals- These are compounds that are used for the production of several…

Q: How the Surface and near-surface contaminants can be transported?

A: Contaminants are the substance which pollute either land , air or water bodies.

Q: PLASTICITY INDEX (PI) What soil type corresponds to the information shown below if the PL is 15.…

A:

Q: Differentiate b/w the following:   i) Ultimate limit states & Serviceability limit states

A: The ultimate limit state is the design for the safety of a structure and its users by limiting…

Q: Using the Table of Contents for the regulations, in which section would you find regulations…

A: As per  public health cade of the of connecticut chapter II of environmental health we have…

Q: P2 60 а- ахis 20 P = FN kN %3D P2 = P cos (60° - 20°) kN P2 FN cos (40°) kN = P cos (80° - 60°) kN…

A: The question itself has a some discrepancy in the solution, In this question generally, they asked…

Q: er ed Compute and tabulate the data necessary to stake, by tangent offsets, the full- stations of a…

A:

Q: For the following sieve analysis find the clean water head loss using the Rose equation. The water…

A: The given data is shown below: Temperature=20°CFiltration rate=200 L/m2-minBed depth=0.7…

Q: Part 1 For the simply supported beam subjected to the loading shown, derive equations for the shear…

A: A simply supported beam is given, we need to find out the reactions and draw the shear force and…

Q: If a worker falls and breaks his arm on a job- site, it would be considered an occupational

A: According to the OSHA, if a worker or engineer breaks his arm or any kind of damage in workplace or…

Q: 10 kN 3m 3 m 3m 3 kN 3 m

A: Consider the free body diagram of the whole system. Consider the moment equilibrium about point C.…

Q: If sin A 4/5, A in quadrant II, sin B = 7/25, B in quadrant I, find sin (A + B)

A: Given Data:sin A =4/5sin B=7/25

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.