Devices using semiconductors to measure temperature are calledoptical pyrometersthermistorsthermocouplesO resistance temperature detectors

An optical pyrometer is a temperature measuring device that works on the principle of matching the…

Answered: Devices using semiconductors to measure…

Devices using semiconductors to measure temperature are called O optical pyrometers thermistors O thermocouples O resistance temperature detectors

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Circular motion is a special case of plane curvilinear motion where

Q: Lubrication is a method to reduce close contact between surfaces and helps in heat transfer. Select…

A: Basics of Lubrication & Cooling.

Q: https://www.sciencedirect.com/science/article/ abs/pii/S036013230700025X In this literature review,…

A: The article likely discusses a ventilation system installed in a particular setting, detailing its…

Q: Torricellian vaccum is

A: answer is 2nd option, Barometer.for solution refer below image.

Q: FILL IN THE MISSING WORDS (some words may be used more than once) aluminum atomic bars conductivity…

A: Given: There are so many words from which we have to choose for the given sentences. So the correct…

Q: 2. This problem is a real application of the impedance method derived from Prof. Shen's research.…

A: Step 1: Step 2: Step 3: Step 4:

Q: Thermal conductivity measurement for good conductors using Searle's Method

A: serale,s method is used to measure thermal conductivity of matter by using steam.

Q: What is the resistance R of a length of copper wire whose length = 10 m and whose diameter = 0.10

Q: Question 1 (a) Explain what you understand by the term Callibration. (b) Describe in details the…

Q: * Surface tension is caused by the force of ..............at the free surface None of the above. O…

A: Answer 1: Cohesion force is a force which is caused due to the attraction force between two same…

Q: How can we measure the sound pressure level of the noise generated by a machine by Formula for…

A: The unit measure of SPL is decibels (dB). It is measured with a Sound Pressure Level Meter, such as…

Q: Conductivity readings are often referenced to a specific temperature typically equals for…

Q: Explain the operating principles and limitations of 3 viscosity measuring devices

A: The operating principles and limitations of 3 viscosity measuring devices

Q: The mass of a solid hemisphere is measured once with a digital balance whose resolution is 1 g. The…

Q: A conductor made of nickel (pe=6.8 10- 8V m) has a rectangular cross section 5 x 2 mm and is 5 m…

A: Solution:

Q: Most modern electrical heating and cooling devices are provided with thermostat. What is the purpose…

A: given; Most modern electrical heating and cooling devices are provided with thermostat. What is the…

Q: Two 6-cm-diameter aluminum electrodes are spaced 2 mm apart. The electrodes are connected to a 178 V…

A: Given Data Potential difference, V=178V Diameter, d=6cm Radius, R=0.03m Distance, d=2mm=0.002

Q: atals Boren catide Scen Tungaer arbide

A: Given: Maximum service temperature is around 800 c Solution: Plastic is very good for inner wall…

Q: Industrial Pipes In order for there to be interchangeability between different components of a pipe,…

A: The objective of the question is to understand whether the pressure class and the gauge of different…

Q: Redesign of elements for the design of a PIEZOELECTRIC TILE PROTOTYPE FOR THE GENERATION OF ELECTRIC…

A: To redesign elements for the design of a piezoelectric tile prototype for the generation of electric…

Q: Rocket is presented with 20 Harbulary Batteries, 10 of which are real and 10 of which are fake. He…

A: Given : n = 20 To find : Calculate the appropriate values to indicate Rocket’s sensitivity and…

Q: An amourphous TiO2 (titanium oxide) wire has a resistivity of 10.1 Ohm.cm, a diameter of 4mm and a…

Q: You are required to measure the temperature of exhaust gas from a petrol engine. During the…

A: According to our guidelines I can solve only 1 question at a time, kindly repost your second…

Q: What is Pwall/0.2885? what number is Pwall?

Q: The temperature measurement capability of thermistors is from 200°C to over 2000°C. Select one: True…

A: We have to determine the temperature measurement capability of thermistors

Q: Kinematic viscosity of water is 10-6 m2/s. Dynamic viscosity is O 10-6 Pa.s O 0.001 Pa.s O 0.001…

Q: How did the length of the tube affect the amount of standing waves?

A: A standing wave, also known as a stationary wave in physics, is a wave that oscillates in time…

Q: Question Discuss how the design of photovoltaic cells are optimized to minimize energy losses and…

Q: Heat transfer through insulation systems may include several modes:

A: This question is based on the concept of heat transfer.

Q: What is a pneumotachometer and what is it used for? Explain the construction and operation of the…

A: A pneumotachometer is a device used to measure airflow or the volume of gas passing through a…

Q: R1 ww 11) Consider the following circuit. An ammeter with internal resistance Ri is inserted between…

A: Step 1:Step 2:Step 3:Step 4: Verification for part (a) using simulatorVerification of part (b)…

Q: - Describe two ways that you think mechanical waves produce effects that are harmful to society

A: Introduction Mechanical waves can only transmit energy when a medium is present if the medium is…

Q: 30_ Select the correct statement for a radial conductivity exp…

A: For Q 30 ) For a radial conductivity experiment The inner section represent the heating area and the…

Q: 1. The resistivity of aluminum is 2.8 x 10-8 0m. How long (in meters) a piece of aluminum wire 1.0…

A: Find how long a piece of aluminium wire is needed to give a resistance of 4 ohm's

Q: A transistor has a DC Beta of 280 and a base current, IB, of 25 Amperes. Find IE * 7.868microA…

A: Given Base current, IB = 25 microA Beta = 280 Find Emitter current, IE

Q: A conductor made of nickel (pe=6.8 10-8V m) has a rectangular cross section 5 x 2 mm and is 5 m…

A: According to the information we have a conductor made up of nickel having a rectangular…

Q: 4. Three parallel connected resistor when connected across a dc voltage source dissipate a total…

Q: alculate the sensitivity if the RTD temperature is 628.9 oC and Resistance as 903.6 ohms. a. 2.87 b.…

A: Given Data⇒RTD TemperatureRTD=628.9°CResistance R=903.6 ohmProblem definition⇒Problem says estimate…

Q: : A 100-Ω platinum RTD is being used to measure temperature in an oven. The present temperature is…

A: We have to find temperature

Q: 27 of 32 A thermistor obeys the equation R(T) = A"exp(B/T) ohms, where A = 0.02 Q and B = 3700 K.…

A: Find the temperature .

Q: expect the equivalent resistance of the two resistors to be (including the

Q: A measurement device is specified as having a repeatability of ±0.6% of full-scale when used on its…

Q: The transducer used for the measurements is/are

A: Correct answer is:

Question

Devices using semiconductors to measure temperature are called
optical pyrometers
thermistors
thermocouples
O resistance temperature detectors

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1- A J-Type thermocouple referenced to 80°F has a measured output emf of 2.878 mV. What is the temperature of the measuring junction?
Question 5.1: A thermopile is constructed with chromel-alumel materials. Five junctions are maintained at 400-C and five junctions are maintained at 100°C. The output of the thermopile is connected to a potentiometer. Answer the following questions: a) Draw the equivalent circuit and indicate all the given information. b) What is the voltage induced by the potentiometer? Given: Table 8.30 Temperature. °C -150 -100 <-50 <<-25 0 25 50 75 100 150 200 300 400 500 600 800 1000 1200 1500 1750 Thermal emf in absolute millivolts for commonly used thermocouple combinations, according to ITS(90) (Reference junction of 0 C)¹ Copper vs. Constantan (7) -4.648 -3.379 -1.819 -0.940 0 0.992 2.036 3.132 4.279 6.704 9.288 14.862 20.872 Chromel vs. Constantan (E) -7.279 -5.237 -2,787 -1.432 0 1.495 3.048 4.657 6.319 9.789 13.421 21.036 28.946 37.005 45.093 61,017 76.373 Iron vs. Constantan ( -6.500 -4.633 -2.431 -1.239 ( 1.277 2.585 3.918 5.269 8.010 10.779 16.327 21.848 27.393 33.102 45.494 57.953…
Obtain information about K - , E - , and R -type thermocouple wires. Write a brief report discussing their accuracy, temperature range of application, and in what application they are commonly employed.
Thermal conductivity of solid metals with rise in temperature normally Select one: a. unpredictable O b. increases O c. decreases O d. remains constant
1. We can measure the velocity of a flow by using a pitot tube. (True or False) 2. It is the study of the thermodynamic properties of air. 3. A pressure transducer that utilizes an elastic element that usually oval in shape. It is fixed on one end and the displacement caused by pressure at the free end is measured.
a physical condition which indicates that the failure has started Inability to meet the specified performance standards failure is not apparent until the function is attemted. Functional Failure O O O Potential Failure O O O Hidden Failure O O O
Part A What is the capacitance of two square parallel plates 3.6 cm on a side that are separated by 2.1 mm of paraffin? Dielectric constant of paraffin is = 2.2 Express your answer to two significant figures and include the appropriate units. Α Хь 919 . x.10"
Pleas very fast Determine the resistance of a copper wire that has a cross-sectional area as 9.2 mm2. The length and the electrical resistivity of the copper wire are 78.7 m and 1.67 x 10-6 Ωm. The resistance of a copper wire (in Ω)
A rope-brake dynamometer attached to the crank shaft of an IC engine measures a brake power of 10 kW when the speed of rotation of the shaft is 400 rad/s The shaft torque (in Nm) sensed by the dynamometer is....
the magnitude of the velocity is known as the speed and it is generally expressed in units of m/s^2 or ft/^2. true or false
A magnetic actuator is expected to operate at 400°C.a) Using a clearly labelled diagram, describe the effect of temperature onsaturation magnetization. b) From the table above, suggest a material that could be used to make themagnetic actuator. Explain.
Describe the Various types of Bourdon tubes used to measure pressure. They work on the same principle as party noisemakers (bottom photo) due to the flat tube cross section.