- Determining the volume of base needed to titrate a given mass... A chemistry student weighs out 0.0878 g of phosphoric acid (H₂PO4), a triprotic acid, into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.1500M NaOH solution. Calculate the volume of NaOH solution the student will need to add to reach the final equivalence point. Round your answer to 3 significant digits. 10 X

- Determining the volume of base needed to titrate a given mass... A chemistry student weighs out 0.0878 g of phosphoric acid (H₂PO4), a triprotic acid, into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.1500M NaOH solution. Calculate the volume of NaOH solution the student will need to add to reach the final equivalence point. Round your answer to 3 significant digits. 10 X

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Suppose that while titrating a vinegar sample you suddenly realize that you forgot to add the indicator. You add the proper amount of indicator to the flask and the contents of the flask turn bright pink. Should you stop the titration and start over, or should you continue the current titration? Why?
During the standardization of NaOH , a drop of titrant was present on the tip of the buret when making the final volume reading. Would this affect the final calculations of molarity of NaOH? If so, how? Explain.
You weighed and dissolved 1.400g of sodium carbonate into a 100.0 ml volumetric flask. If a 10.00ml aliquot of the sodium carbonate solution is placed in a flask and titrated with 29.15ml of HCl, what is the concentration of the HCl solution?
Please don't provide handwritten solution ....
A strong acid-strong base titration was performed as follows: 10.00 mL of 0.10M HCl were collected in an Erlenmeyer flask, and then diluted to 100 mL with distilled water. After that, two drops of indicator were added. Then, the buret was filled with 0.100 M NaOH. The titration was started by slowly adding NaOH to HCl. (Note: The volume of two drops indicator is ignored as it is so tiny compared with 100 mL.) What is the pH of the solution in the Erlenmeyer flask after adding 10.20 ml of 0.100M NaOH? Select one:a. 9.80b. 10.26c. 9.90d. 11.08
By titration it is found that 35.7 mL of 0.101 M NaOH(aq) is needed to neutralize 25.0 mL of HCl(aq). Calculate the concentration of the HCl solution.
I have 28.63 mL of an unknown-concentration Mg(OH)2 (aq) solution. I find that, when I add 23.33 mL of 0.1060 molar HCl(aq) to this solution, the acid and base exactly neutralize each other. What was the original concentration of the Mg(OH)2 solution? a. 3.151 molar O b. 0.1728 molar c. 0.04319 molar d. 0.06504 molar e. 0.08638 molar Clear my choice Previous page Z 3 $ 4 n 5 80 MacBook Pro 6 & 11 8 Next page
Suppose the fluid in the stomach of a man suffering from indigestion can be considered to be 250.mL of a 0.063 M HCl solution. What mass of NaHCO3 would he need to ingest to neutralize this much HCl ? Round your answer to 2 significant digits.
4. A student did not read the directions to the experiment properly and mixed up where to put the NaOH and the HCl solutions. He put the HCl in the buret and the NaOH in the flask. He then added a drop of the phenolphthalein to the solution in the flask. Does the student need to empty out all of the solutions and start over again or can he go ahead and run the titration? Explain qalb ribidw qid edini olddud ris ogrel s znisimos tund entd nousu 5. How many liters of 3.4 M HI will be required to reach the equivalence point with 2.1 L of 2.0 M KOH? 9no vino to beateni nolusius to alsid sigulum ob of insttoqmi ti al VW S
An analytical chemist weighs out 0.050 g of an unknown triprotic acid into a 250 mL volumetric flask and dilutes to the mark with distilled water. He then titrates this solution with 0.1600 M NaOH solution. When the titration reaches the equivalence point, the chemist finds he has added 9.6 mL of NaOH solution. Calculate the molar mass of the unknown acid. Be sure your answer has the correct number of significant digits. g mol
An analytical chemist weighs out 0.185 g of an unknown monoprotic acid into a 250 mL volumetric flask and dilutes to the mark with distilled water. She then titrates this solution with 0.2000 M NAOH solution. When the titration reaches the equivalence point, the chemist finds she has added 9.5 mL of NaOH solution. Calculate the molar mass of the unknown acid. Be sure your answer has the correct number of significant digits. g x10 mol
Calculate the molar mass of the unknown acid. Be sure your answer has the correct number of significant digits.