Determine the zero bars and the load values for each element. Indicate whether the elements are under tension or pressure.

Q: Note: Pi= 1000 lb and P:= 500 lb 4 ft 4 ft 4 ft 666 239 222

A: Using the Method of Joints:   Joint A:   Taking equilibrium of vertical forces (∑Fy = 0),   Taking…

Q: Determine the the force in member GJ of the truss and tate if this member is in tension or…

A: Given that : F = 1050 lb Intro : 1- It is asked to determine the forces in member GJ and GC of the…

Q: Please explain all question and draw diagram

A: Part 1. Calculate the displacements at the jointsGiven InformationThe truss structure is square with…

Q: 1 m √3 m D F 4. 1 m A B E √3 m A P

A:

Q: For the truss shown in the following figure, the temperature of member BC is raised by 140 °C, and…

A:

Q: PROBLEM 10-n GIVEN: THE STATE OF STRAIN AT THE POINT ON THE PIN LEAF HAS COMPONENTS OF = 200(106), y…

A: εx=200×10-6 εy=180×10-6 γxy=-300×10-6 θ=-30o counter clock wise

Q: ML All the members in the figure below have same flexural rigidity. If a moment 'M applied at joint…

A:

Q: El is constant, find the reaction forces. Using the method of consistent deformations

A: Calculation of Reactions at Supports using method of consistent deformation or Force method of…

Q: A simply supported planar truss is subjected to point loads at joint B and D as shown in Figure 2.…

A: Find the reaction of the truss calculate θ=tan-113.2710=52.99° and α=tan-113.275=69.35°consider ∑…

Q: The state of strain at the point on the member has components of Px = 180(10-6), P y = -120(10-6),…

A: The given figure is shown below:

Q: Consider the pin-jointed truss as shown in figure below: A B D 30° 45° 90° 60° Coordinate direction…

A:

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Load on Structures

Civil engineers primarily deal with beams in their day-to-day applications. A beam is a structural member that resists shear loadings. There are various types of beams such as cantilever beam, simply supported beam, and over the hanging beam. All these beams have a different end and loading conditions.