Answered: Determine the volume of 3 kg of…

Determine the volume of 3 kg of saturated water with a quality of 60% and a pressure of 150 kPa. 0.795 m^3/kg O 2 088 m^3

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Using Bernoulli's principle between point 1 and 2, determine the maximum height that the water can…

Q: According to the law of conservation of mass, the specific mass of a compressible fluid is same at…

A: During the flow process the mass flow rate given by - m¯ =ρAV , where -ρ is density of fluidA is…

Q: Answer the following questions with solution/ detailed explanation: 1. The pressure in an…

A: Given data: Pg=210 kPaT1=25°CT2=50°CPAtm=100 kPaV=0.025 m3 Need to determine the amount of air that…

Q: A pressure gauge fitted on the side of a tank filled with liquid reads 50 kPa and 100 kPa at heights…

A: Hydrostatic Pressure at any point at depth h is given by:P=γh=ρghHere,γ=unit weight of…

Q: 2.A manometer is used to measure the pressure in a tank, the fluid inside the manometer has a…

Q: If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O. (a) Express…

A: Solution:

Q: A certain gasoline gives a hydrometer reading of 66.5 oBaume at 15.6 oC. Using the Bureau of…

Q: According to the law of conservation of mass, the specific mass of a compressible fluid is same at…

A: According to law of conservation, mass is neither created nor destroyed in case of incompressible…

Q: Q1\ A 80°C cup of coffee left in 25°C room. After 5 minutes, the temperature of the coffee is 75°.…

Q: A pressure gauge fitted on the side of a tank filled with liquid reads 50 kPa and 100 kPa at heights…

A: A pressure Gauge is a mechanical device used to measure the pressure of the system compared to…

Q: An engineer was tasked to determine the pressure of the air in the air receiver of an air…

Q: The water in a tank is pressurized by air, and the pressure is measured by a multi-fluid manometer.…

A: Given all information in the figure. Determine the gage pressure of air in the tank.

Q: A tank containing potable water is under an absolute pressure of 60 KPa and has a temperature of…

A: Air in the tank P = 60 kPa T = 60 oC r = 1.5 m L = 4 m Volume of tank = π×r2×L=π×1.52×4=9π m3

Q: determine the pressure of superheated steam at 250 °c and specific volume of 0.05970 m3 /kg.

Q: The total pressure in a gas pipeline is to be maintained at three times atmospheric pressure. Figure…

Q: Ethylene glycol (antifreeze) has a density of 1.11 g/cm^3.What is the volume in L of 4.1 kg of this…

A: Given: The density of the Ethylene glycol is ρ=1.11 g/cm3. The mass of the Ethylene glycol is m=4.1…

Q: A container is filled with oil. A pipe is connected to the container at point C and the owner left…

Q: When a 2-mm-diameter tube is inserted into a liquid in an open tank, the liquid is observed to rise…

Q: The maximum blood pressure in the upper arm of a healthy person is about 120 mm Hg. If a vertical…

Q: Polluted air can have carbon monoxide (CO) levels of 15.0 ppm. An average human inhales about 0.50 L…

A: Given data: Level of CO in polluted air = 15 ppm = 15 Litre CO106 Litre air Average human inhales =…

Q: A spherical research balloon is filled with 420 m3 of atmospheric air at a temperature of 10°C. If…

A: Given: The initial volume of balloon is V1=420 m3. The initial temperature of air is T1=10°C. The…

Q: A volume of 45000 mL of air is measured at a pressure of 4.92 in Hg gage and a temperature of 21°C.…

Q: Specific volume of mercury m³ /kg is

A: It defines how much volume unit mass of a material can occupy, the denser the material lower will b…

Q: The pressure Gauge on a 2.5 m³ Oxygen tank reads 512 KPa and the atmospheric pressure is 96 KPa.…

Q: For water at 4°C its density is equivalent to slugs/ft O 1.94 O 62.40 O 1000

A: To find density of water at 4 degree celcius

Q: The barometer shows a value of 700 mm Hg, the temperature of the dry ball is 55 °, the temperature…

Q: Two plates are separated by 8 mm space. The lower plate is moving at a velocity of 5 m/s, the upper…

Q: container is filled with oil. A pipe is connected to the container at point C and the owner left the…

A: To Find : The maximum absolute pressure (psi).Given : The density of oil is Assumption : The…

Q: A pressure gauge fitted on the side of a tank filled with liquid reads 50 kPa and 100 kPa at heights…

Q: Determine the volume of 3 kg of saturated water with a quality of 60% and a pressure of 150 kPa.

A: Answer: The volume of 3 kg of saturated water with a quality of 60% and a pressure of 150 kPa is…

Q: Methane is stored in a tank at a pressure of 291,890 Pa and a temperature of 279 Kelvin. The ambient…

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

Q: What is the quality of saturated water at 370 K if 3 kg has a volume of 2 m³?

A: given:volume V=2 m3mass m=3kgwater temperature T=370K

Q: Q56. The water in a tank is pressurized by air, and the pressure is measured by a multifluid…

Q: A rigid tank contains superheated water vapour at 300 kPa. When the tank is cooled, the superheated…

A: Given that: Superheated water vapor is initially at P = 300 kPa. Water is cooled until it becomes…

Concept explainers

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.

Question

Determine the volume of 3 kg of
saturated water with a quality of 60%
and a pressure of 150 kPa.
O 0.795 m^3/kg
O 2.088 m^3
2.385 m^3
O 0.696 m^3/kg

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In figure (1), The Gauge pressure at A reads P87 kPa. All fluids are at 20°C. Determine the elevations Z in meters of the liquid levels in the open piezometer tubes B and c. Gasoline S.G= 0.8, Glycerin S.G= 0.9, air density= 1.25 kg/m³. A В C 2 m Air 1.5 m Gasoline 1 m Glycerin -
Determine the quality x of water if P = 0.04 bar and v = 17.4 m^3/kg a. 0.75 O b. 0.85 C. 0.35 d. 0.5 e. 0.2 TOSHIBA
1. A device for measuring the specific weight of a liquid consists of a U-tube manometer as shown. The manometer tube has an internal diameter of 0.5 cm and originally has water in it. Exactly 2 cm³ of unknown liquid is then poured into one leg of the manometer, and a displacement of 5 cm is measured between the surfaces as shown. What is the specific weight of the unknown liquid? Answer: Y = 0.5 cm. T 5 cm ↓ Water
Determine the pressure, specific volume, and internal energy of water at 25 C and a quality of 70%
Substance A has a density of 1.7 g/cm^3. Substance B has a density of 1.7 kg/m^3. Without doing any calculations, determine which substance is more dense.
A car tyre has a gauge pressure of 1.9 bar. Determine it's absolute pressure in mmHg, assuming the atmospheric pressure is 1.013 bar.
As temperature increases, the saturation vapor pressure over a water surface increases exponentially increases linearly decreases exponentially decreases linearly
Chemistry The cylinder with a volume of 0.1 m ^ 3 contains oxygen with a manometric pressure of 6 MPa and a temperature of 25 C. After a portion of the gas was released from the cylinder, the manometer showed a pressure of 3 MPa and the temperature had dropped to 15 C. Determine the mass of oxygen released from the density of the cylinder and the oxygen remaining in the cylinder. The barometric pressure is 0.1 MPa.
Convert 2.543 inHg to lb/ft2 manually. Show the step by step Conversion
A rigid tank contains water at a pressure of 200 kPa. The volume of the tank is 2 m^3. The mass of liquid in the tank is 0.5643 kg and the mass of vapor in the tank is 2.2572 kg. In the question that follows, select the answer that is closest to the true value. What is the quality of the water in the tank?
In medical work, pressures are often measured in units of mm of H2O because body fluids, including the cerebrospinal fluid, typically have nearly the same density as water. The pressure of the cerebrospinal fluid can be measured by means of a spinal tap. A hollow tube is inserted into the spinal column, and the height to which the fluid rises is observed. If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O. a) Sometimes it is necessary to determine whether an accident victim has suffered a crushed vertebra that is blocking the flow of cerebrospinal fluid in the spinal column. In other cases, a physician may suspect that a tumor or other growth is locking the spinal column and inhibiting the flow of cerebrospinal fluid. Such conditions can be investigated by means of the Queckensted test. In this procedure the veins in the patient’s neck are compressed, to make the blood pressure rise in the brain. The increase in pressure in the blood vessels is…
salt solution contains 6.4% salt by weight in water how many kilograms of 0.8% solution are required to dilute 150 kg of the 6.4% solution to 3% ? *