The answer must be 141.5 N Determine the Tension in the cordAnswer in N, 1 decimal place without written units.The system is released from rest with the cable taut.For the friction coefficients u, = 0.25 and M = 0.20,calculate the acceleration of each body and the ten-sion T in the cable. Neglect the small mass and fric-tion of the pulleys.75 kg25 kg30B

Answered: Image /qna-images/answer/3f8c0553-2397-434f-b227-6d528cd2974f.jpg

Answered: Determine the Tension in the cord

Engineering

Civil Engineering

Determine the Tension in the cord

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

A: Solution: Section 1: H.I1 = 0.680+50.25=50.93 m h2 =50.93-1.455=49.475 m h3 =50.93-1.855=49.075 m…

Q: A ball is thrown vertically upward with an initial speed of 80 ft/ sec from the base A of a 50-ft…

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

A: Benchmark (BM): Benchmark is any station or apoint which has known Reduced level (RL). Reduced level…

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

Q: 1. Find the distance CD in meters. a. 81.20 m b. 34.67 m c. 77.46 m d. 59.01 m 2. Find the distance…

Q: 2000 KN 400 kN/m 200 kN/m mm sn -10 -10 m For the beam loaded as shown, what is the location where…

A: It is asked to determine For the given beam and loading, the location of zero slope from the right…

Q: 4.) 30 kN/m C 3m 3m D 7m 9m

Q: BS 5.36 FS 1.62 BS 8.11 FS 1.54 BS 7.32 FS 0.86 BM2 TP: TP, BM, Elevation 83.23

A: Given data in question FS BS R.L of B.M1 To find out Plot the data

Q: Compute for the error in latitude. LINES BEARING DISTANCES АВ N 53°27' E 59.82 m ВС S 66°54' E 70.38…

A: The latitude of the line is L = l cos θ where, l - length of the line θ - Quadrantal bearing of…

Q: For 0° <0< 360° find the angles that satisfy the equation cos(0) = -0.0314

A: Given: The equation is, Where,

Q: Hermie instructed Tine to do 3 trials of taping to determine a certain distance AB. The following…

A: for 90 percent error=1.644* standard deviation

Q: Q.I A line of level is run from B.M.1 (elevation=102.00m) to B.M. 2(elevation=106.00m). The field…

A: Given Elevation of BM1 = 102 Elevation of BM2 = 106 Reading of BS, IS and FS To Determine Computed…

Q: Given the following data: Azimuth A to B = 50° 00' 14", with a o value of 5" Distance A-B = 76.810…

A: Azimuth : The azimuth is the angle formed by the projected vector and a reference vector on the…

Q: Convert 165 degrees to rad in terms of r. O a) 2.87979 b) 117/12 O c) T/12 O d) 1036.73

A: We have to convert 165 degrees to rad.

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

Q: LINE AZIMUTH FROM NORTH AB ВС CD DE EF

Q: 21). The following consecutive readings were taken along a straight line from station (11+090) to…

A: Given reading are:- 0.680,1.455,1.855,2.330,2.885,3,380,1.055,1.680,2.265,3.540,0.835,0.945,…

Q: Calculate the probable error (mean) 545.789 545.180 544.988 545.543

A: Given: 545.789 545.180 544.988 545.543 Required: Probable error mean

Q: Calculate the natural circular frequency o of the illustrated system. W EI

A: To find natural frequency

Q: Problem 2: The difference in elevation between observed points A and B is 25m and the horizontal…

Q: Determine the magnitude and direction of reactionr at the rupporti. All measureme ntr are in meters.…

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

Q: Q1): A field book is reproduced below in which some readings marked as (x), are missing. The true…

Q: The micrometer reading of the following figure is: 10 5 15 20 -45 Select one: O a. 21.49 O b. 21.51…

A: Explanation: In above micrometer readingThe main scale on sleeve contains positions of 0.5mm ,…

Q: To mitigate the closing error, sum of latitudes and departures mu equal to zero. O a. True O b.…

Q: level 200, the leve another point B. Th point B was found order to check the

Q: in the Bank of Level A of arbitrary elevation 18.52 m, it is required to determine the elevation of…

Q: nt Station W.C.B Staff Station Vertical Angle Staff Readings (m) C 320 0 A -12 0 0.906, 1.728,…

Q: a. 81.20 m b. 34.67 m c. 77.46 m d. 59.01 m 2. Find the distance DA in meters. a. 61.89 m b. 49.16 m…

Q: Question two Using virtual energy methods, determine the slope at point A. Given that 200(10") mm…

Q: Question 1 Listen For 0° < 0 < 360° ,find the angles that satisfy the equation cos(0) = 0.2857 Round…

A: ● solution:- b) As we can see that the values are given like:- cos @ = 0.2857 And @ value should…

Q: A line was measured three times and yield the following results; 856.42, 856.69 and 856.12 m.…

A: Answer Probable error of the mean is given by Em = Esn Es = Probable error of a single measurement…

Q: a. Difference in elevation between A and B b. Elevation of A

Q: Home Work (1): For the Figure Shown Below, Calculate the Station of the BC and EC. PI 14+87.33 A=…

A: To Find station of BC and EC. Note :- Figure is given in question. As there is no changes in diagram…

Q: If the magnitude of R is 560 N, what is the value of P? y (30% 25° R /30%

Q: The slope distance and zenith angle observed from point X to point Y were 4890.95 ft and 83°15'17".…

A: Given:- The slope distance from point X to point Y = 4890.95 ft The zenith angle = 83°15'17" The…

Q: For 0° < 0 < 360° , find the angles that satisfy the equation cos(0) = -0.2091

A: cos(102.07) = -0.2091 cos(77.93) = 0.2091 cos (257.93) = -0.2091 cos(282.07) = 0.2091

Q: a) In the process of taking a rod reading, one can eliminate parallax mathematically. Parallax is…

A: (a) False The parallax can be eliminated by two steps, they are Focusing the eyepiece, and Focusing…

Q: What will be the corrected staff reading at a point A if the staff reading taken from an instrument…

A: Given data- Staff reading = 3.5 m, Distance D=2 km, To Find- The value of the corrected staff…

Q: Route the Pollowing hydrogaph through a river reach for which k-22 hr and x=0-25 at the start of…

A: Since K = 22 hr and x = 0.25 2*K*x = 2*22*0.25 = 11 For best results the routing interval should be…

Q: Situation D. Using the figure, supply the data needed in the numbered cell. BS FS 3.06 BS FS BS FS…

A: Given data in question Back sights Fore sights Elevation of BM To find out Complete the table.

Q: In the leveling across a wide river on Pampanga, a reciprocal level readings were taken between…

A: Set up near B Average of BS = 2.283+2.284+2.286+2.2834=2.284m Average of FS…

Q: 5' 200th's #H 12' boolbs 6² с 4001 C A 10º 300165 ✓ I F D 8' B 66°C to 1000 155 G CALCULATE FORCES…

Concept explainers

Friction

Friction is defined as the force that prevents any solid surface, any layer of fluid, or any kind of element or material from sliding.

Question

The answer must be 141.5 N

Determine the Tension in the cord
Answer in N, 1 decimal place without written units.
The system is released from rest with the cable taut.
For the friction coefficients u, = 0.25 and M = 0.20,
calculate the acceleration of each body and the ten-
sion T in the cable. Neglect the small mass and fric-
tion of the pulleys.
75 kg
25 kg
30
B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1x

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q: Find the distance x in fig below, use the common intensity method as (i= 1200/1+90) x 150 m Sewer 1 Sewer 2 Sewer 3 50 m B Percent Slope Area A 0.44 0.5 B 0.35 2 Sewer D (mm) 1 290 2 410 3 600 0.8 Distance (m) 140 80 d/D 0.3 0.6 V full m/s 1.8 2 1.6
Trial Line Length (m) Difference Mean Relative Precision 1 АВ 258.50 2 ВА 258.85
Azimuth Azimuth Fraction) Length Degrees Minutes Seconds Line 10047 86.99 100 28 AB 44 186.18 186 10 BC 259 89 0.00 CD 100.11 125.32 115 12 44 115.21 DE 323 10 323.17 EA 284.548 SUM 856.858 7. Determine the FGCC dassification of the angle measurements in the problem shown here. Interior Angles Degrees Minutes Seconds 80 28 86 10 44 100 01 215 12 4. 58 3. 18 SUM 69
Q1). The following consecutive readings were taken along a straight line from station (11+090) to station (12+015). The instrument has been changed after third, fifth, eighth and welfth readings. The readings are as bellows: (3 0.68 0.680, 1.455, 1.855, 2.330, 2.885, 3.380, 1.055, 1.680, 2.265, 3.540, 0.835, 0.945, 1.530 and 2.250, first and last point are a bench marks having elevations 50.25m and 50.81 m respectively. 44.8 1- Draw page of level book and enter the above data. 2- Find cleve on of pointe hy height of instrument method. 3- Check your calculation. 4- Determine the gradient of the line joining the first and last point. 5- Determine loop closure and adjust calculated elevations. -5.408
B1
A transit with a stadia interval factor of 100.12 was set at C on the line between points A and B, the following stadia readings were observed. (draw the Instrument set up) Stadia Hair Readings (m) Rod Position Vertical Angle Upper (a) Middle (c) Lower (b) Rod Held at A - 50 17 1.318 1.148 0.978 Rod Held at B + 20 21' 2.048 1.882 1.355 If the stadia constant is 0.29 m determine the following: A. Length of line AB (horizontal). ANSWER: B. If the elevation at B is 76.751m what is the elevation at A. ANSWER:
I need a quick solution within 15 minutes With my best wishesTon.
Q3: Find the elevation of all point if the elevation of Last point is 30 m and check the results. (25 %) Station B.S F.S elevation В.М 1.245 T.P, 3.254 2.523 T.P2 2.522 1.421 T.P3 1.242 0.263 3.486 30
Complete the table below. STATION BM1 A B C D E F BM2 BS 1.470 1.967 2.792 2.225 2.209 1.072 HI 368.382 369.414 370.245 Lowest rod reading Station with the Highest BS Lowest Elevation 370.780 370.278 371.138 Highest elev of the line of sight Station with the highest elevation (excluding BM1 & BM2) FS 1.200 1.136 1.082 3.400 0.212 1.204 ELEV 367.182 368.278 369.163 368.555 368.069 369.934
Q.2. A distance AB is observed repeatedly using the same equipment and procedures, and the results, in meters, are listed. 65.401; 65.400; 65.402; 65.396; 65.406; 65.401; 65.396; 65.401; 65.405; 65.404; 65.398 and 65.408 d} Determine the 90% error limits and list the percentage of values that fall within this range, e) Determine the 95% error limits and list the percentage of values that fall within this range. 1