Determine the quantity (volume) of saline water in a steam generator. The heat energy of 1738 kJ is supplied to saline water in the steam generator to heat from 26ºC to 111ºC for the generation of water vapor, Take the density & specific heat of the solution as 1031 kg/m3 & 3.6 J/kgºK respectively. Solution: Change in Temperature (in K) Answer for part 1 Mass of the saltwater (in kg) Answer for part 2 Quantity (Volume) of saltwater (in m3) Answer for part 3

Q: The interior contents and materials of a small building weigh 10 tons, and together they have an…

A:

Q: A piston-cylinder assembly contains 2 kg of liquid at 20 ° C and 100 kPa pressure. 1000 kPa pressure…

A: Given Data: The mass of water in the piston cylinder is, m=2 kg. The initial temperature of water…

Q: Q3) A perfectly insulated cylinder fitted with a leakproof frictionless piston with a mass of 30.0…

A: Write the given value using suitable variables. Here mp signifies piston mass, A signifies piston…

Q: 4. Two liquids of different densities p= 1500 kg/m³ and p= 500 kg/m³ are poured together into a…

A: Given: The density of two liquid is ρ1=1500 kg/m3 and ρ2=500 kg/m3. The volume of tank is V=100 lt1…

Q: 500 J/(Kg. C), is The quantity of heat required to raise the temperature of 500 g of iron by 2°C…

A: As given in question, Mass of iron = m = 500 g = 0.5 kg Change in temperature = ΔT = 2 oC Specific…

Q: An air bubble rises from the bottom of a well where the temperature is 25oC, to the surface where…

A:

Q: A steam stripper is used to help removing wallpapers. It comprises of a tank of water with an…

A:

Q: How many J of energy must be removed when 187.0 g of steam, at a temperature of 182.0°C, is cooled…

A:

Q: 1) For vapour contained in an engine 2 cylinder:

A: we have to discuss about the vapor contained in the system

Q: these are the properties dependent on the size or extent of the system

A: Solution:   The correct answer with necessary explanation is given below:

Q: An air bubble rises from the bottom of a well where the temperature is 25oC, to the surfacewhere the…

A:

Q: The thermodynamic process of a substance when it passes through device changes in a constant…

A:

Q: QUESTION 17 Estimate how much energy is required (in kJ) to heat 200 g of H20 from 28.5 °C to 95.5…

A: Heat transfer is the form of energy that transfers from one system to another system by the virtue…

Q: Determine the steam condition for the steam properties on the table below. Write: SHV if it is a…

A: Mollier Diagram provides all the necessary information for various conditions of steam. By analyzing…

Q: Consider a 400 Liters Tank contains 14.9 kg of refrigerant-134a at 12.0 °C. What is the quality of…

A: From the given data,

Q: 35 kg of certain gas is contained within the piston- cylinder assembly. THE GAS undergoes a process…

A: Given:m=35 Kgpv=Cp1=6 bars =600 KPaV1=0.2 m3V2=0.4 m3dU=10.5 KJ/Kg

Q: im to show the above process. fficient of performance (COP) of the refrigeration cycl py analysis…

A:

Q: Air treated as an ideal gas and having a specific heat at constant volume Cv=1200 J/kg.K undergoes a…

A:

Q: The temperature of a block of aluminum increases by 17.5 K. What is this temperature increase in ∘C?

A: the temperature of the aluminum block increased by =17.5 k we know that relation between kelvin and…

Q: Two ideal gases were delivered to two containers of equal volumes temperature and pressure. One of…

A: Given: Both the containers have same pressure temperature and volume initially. The first container…

Q: An ideal gas expands isothermally along AB and does 630 J of work. The process is illustrated in…

A:

Q: Steam expands in a reversible adiabatic process, employing a cylinder-piston configuration. The…

A:

Q: In Lecture I described many ways by which the constant pressure specific heat capacity of water an…

A:

Q: Determine the quantity (volume) of saline water in a steam generator. The heat energy of 1605 kJ is…

A:

Q: 1 kg of a gas at a temperature of 40° C and a pressure of 120 Ka occupies a volume of 0.25m^3. If…

A:

Q: Rate of heat transfer to evaporator from the chilled water: Rate of heat transfer from condenser to…

A: To be evaluated Rate of heat transfer to the evaporator from the chilled water: Rate of heat…

Q: 2.5team is held in two compartments separated by a membrane. The total volume is 777 ft3, and the…

A:

Q: A gas, whose composition is not known, has 40 BTU of paddle-work input at a constant volume of 20…

A:

Q: The driving force for fluid flow is the pressure difference, and a pump operates by raising the…

A:

Q: A piston cylinder device initially contains superheated steam as shown in the following figure. Then…

A: At P1=3.5 Mpa T1=Tsat+7.4 T1=250C v1=0.05876 m3/Kg u1=262.4 KJ/Kg At P2=3.5 MPa v2=vf=0.001235 m3/Kg…

Q: Consider a device similar to that used by Joule to measure the net work between two states as…

A: The mass of the weight is m=4 kg. The height of fall of the mass is h=0.8 m.

Q: 1 kg of an ideal gas is heated at constant pressure p. Given that this results in an increase in…

A: To select the correct option.

Q: 2. The height of a cylindrical tank, containing 9.1 kg of gas at 482.5 kPa and 48.9deg. C is triple…

A: INTRODUCTION : The gas contained in the cylindrical object is the given condition in this problem.…

Q: He gas undergoes adiabatic expansion at P1 = 8 bar, T1 = 750K to T2 = 400K. Then, the gas is heated…

A:

Q: Solution: i) Change in Temperature (in K) ii) Mass of the saltwater (in kg) iii) Quantity (Volume)…

A:

Q: A 300 L rigid tank contains Methane gas at 35 °C and 350 kPa. Some methane is allowed to enter the…

A:

Q: ft lb and Cp = (0.2 + 0.0002T) lb R Btu 4. For a certain ideal gas, R = 77.8: lb R It is heated from…

A:

Q: Q2/ Choose the Correct Answer: 1-The heat transfer is not constant when: (b) temperature decreases…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: A frictionless weighted piston in a cylinder contains 1 kg of wet steam at 100 °C and has a volume…

A: Part 1: Mass of steam inside the cylinder = 1 kg T1 = 100 oC V1 = total volume = 0.1 m3 It is…