Determine the output voltage value of a transistor amplifier circuit by frequency for 1.923 V to input voltage. Instead of. Calculate the gain in dB for the frequency given in the table. Maximum write down the frequency (s) where the gain is halved in terms of power (3dB). Frequency curve draw as

Q: Draw the signal after adding -2.5 DC level with the given signal, sketch the new output signal and…

A:

Q: A) The circuit in Figure 3A have Izan=20µA. The Resistance Rc=100k2, and Vcc=VEE=5V. The transistors…

A: Given the circuit: Given: ITAIL=20 μA, RC=100 kΩ, VCC=VEE=5 V The transistors are matched with…

Q: What is Frequency Modulation? Draw the waveforms.

A:

Q: What Is frequency modulation and demodulation? Describe their importance and how they work.

A: Given: Frequency modulation and demodulation

Q: Explain which one is better, Frequency discriminator or Phase discriminator methods

A: Frequency discriminator and phase detector circuits are disclosed, each having two flip-flops, one…

Q: Draw the transfer curve of logarithmic amplifier.Explain how does a chopper work with basic circuit…

A: Answer: given that  To find the transfer curve of logarithmic amplifier

Q: Why gain is constant in mid frequency region?

A: The frequency response curve represent relation between voltage gain and frequency.  At low…

Q: It is connected to the input of a transistor (BJT) amplifier circuit with a gain of "-50" with a…

A: Given Vin = 100 mV P-P Gain Av = -50  Voltage gain is negative so it should be common emitter…

Q: what is rms value of below signallll.

A: Given signal is -

Q: What are all the effects of harmonics in power system? Define Total Harmonic Distortion (THD) and…

A: Harmonics can be defined as components with periodic waveforms having multiples of fundamental…

Q: خاص A docs.google.com For the circuit shown in figure. For the circait skown in Figure IF IB- 40 MA…

A:

Q: why the gain at low end of the amplifier in linear-frequency plot often ? called the DC gain

A: Dc gain DC gain is defined as the total gain contributed by any operational blocks (it can be an…

Q: What is the function of coupling capacitors? Assuming that they are performing their intended…

A: In amplifiers, it is sometimes required to have only an AC signal at the output for an example audio…

Q: Discuss the effect of increasing inductor filter capacitor on the output voltage and current.

A: A capacitor that filters a specific frequency or frequency range from a circuit is known as a…

Q: Define in your own words what is a small signal FET when it comes to Av, Ai, ri, ro of the circuit.

A:

Q: Identify the given statement. The phase deviation sensitivity and the peak modulating-signal voltage…

A:

Q: Discuss the advantages and disadvantages of series resonant circuit.

A: Circuit is said to be resonance when capacitive reactance of circuit is equal to inductive…

Q: In an ac transistor amplifier, the circuit includes capacitors as well as  resistors. What is the…

A: Transistor amplifier

Q: Draw a n-p-n transistor connected in circuit common base (CB). Draw the input current-voltage…

A:

Q: The system given in the figure a. Draw the signal flow chart and obtain the transfer function with…

A:

Q: Q3/: Complete design as required for the following, sketch the output waveform (Vo), circuit. Vin 12…

A:

Q: What is the best value of relationship between the cut-off frequency of filter and frequency of PWM…

A:

Q: C. Draw a n-p-n transistor connected in circuit common emitter (CE). Draw the input current-voltage…

A:

Q: Describe the combined effect of the RC circuits for higher frequency response in a BJT & FET…

A:

Q: why the gain at low end of the amplifier in linear-frequency plot often ? called the DC gain

A:

Q: 3. The signal power at the input to an amplifier is 100µW and the noise power is 1μW. At the output,…

A: here we have to find the amplifier noise figure.

Q: b) Complete design to perform signal as shown Vo -6 -12

A:

Q: This problem is AC analysis problem. DC analysis is not needed to answer the question. A) If we…

A: We need to find out the resistance value and output voltage for given condition

Q: Theoretical calculations: 5. How does the bandwidth change in relation to increasing signal…

A:

Q: Explain the RC time constant and what its value means in terms of circuit characteristics.

A:

Q: What is a theory Single-sideband modulation

A: A Sideband is a band of frequencies, containing power, which are the lower and higher frequencies of…

Q: otal harmonic distortion (THD) index is used to determine the distortion levels of the voltage as…

A: Although total harmonic distortion is defined as the ratio of sum of power of all harmonics  to the…