This question Determine the output Cp(s) due to thedisturbance D(s), when D(s) = -1/s.D(s)R(s)4C(s)2s +1s+1Select one:- 4Cp(s) =s (9 s+ 5)а.- 5Cp(s) =O b.s (9 s+4)S+ 2Cp(s) =С.S(9s+7)- 2Cp(s) :O d.s (9 s+ 5)S +1Cp(s) =s (9 s+4)е.

Answered: Image /qna-images/answer/1d2e2586-481d-4dc6-a58b-878337d42925.jpg

Answered: Determine the output Cp(s) due to the…

Engineering

Electrical Engineering

Determine the output Cp(s) due to the disturbance D(s), when D(s) = -1/s. D(s) R(s) 4 C(s) 2s +1 s+1

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: At high frequencies in an AC bridge, the source is _______ a) tuned amplifiers b) oscillators c)…

A: Electronic oscillators are used as a source of bridge measurement in the AC bridge circuit on high…

Q: Often, the network is referred as an infinite bus when a change in input mechanical power or in…

A: In power systems many generator buses are connected together to form infinite bus.

Q: What is external setup?

A: EXTERNAL SETUP: Setup is the method involved with setting up a machine to run an item. A portion of…

Q: * Question Completion Status: The fuel cost functions for 3 thermal power plants in OMR I hr are…

A: Write the expression for the incremental cost of all the generating units as below.…

Q: A No. 10 AWG copper conductor

Q: Derrive the equation for impedance and phase shift for Series RLC circuit Connect to the AC Supply,…

A: The impedance of the different elements are shown in the table below:

Q: Explain briefly, the Professional Code of Ethics of an Electrical Engineer.

Q: approximate voltage amplitude and frequency of the waveform below

Q: A1. Voltage sag is common power frequency disturbance that can last half of a cycle to several…

A: Voltage sag is an important consideration while analyzing the power quality. It is always…

Q: Shown in the figure, ahydroelectric plant has two devices, a turbine and a generator. If the…

A: Given Whole plat efficiency ηp = 80% = 0.8 generator efficiency ηg=93 % = 0.93 Asked to find…

Q: got 10 true/false questions. 1) As long as there is a flow of chemicals into a fuel cell, the…

A: 1) Fuel cell : fuel cell is electrochemical cell which convert fuel's chemical energy into…

Q: PROBLEM: A generating station has two 50 MW units each running for 8,500 hours in a year and one 30…

A: Given data: a generating station has 2 units rated as 50 MW Running 8500 hours 1 unti rated as…

Q: Subject: Electrical & Electronics Engineering Course: Power Systems Question: What is GMR and GMD?…

A: To explain GMR and GMD

Q: Describe the structure and components of a power system.

A: A power system, often referred to as an electrical power system or an electric grid, is a complex…

Q: hat is the approximate voltage amplitude and frequency of the waveform below?

A: Disclaimer: "Since you have asked multiple questions, we will solve the first question for you. If…

Q: 8- Generally as of the operating voltage which of the following options are the correct words that…

Q: The symmetrical short circuit current is ______________________ quantity in nature. a-Exponential…

A: The symmetrical short circuit current is given by sinusoidal signal

Q: Why should we avoid wet contact with electrical appliances? Provide a mathematical justification for…

A: The water we use is an impure form of water. It contains minerals and other impurities in it. And…

Q: There are 144 fuel cells are joined in a series through interconnects.there will be 4 stacks having…

A: Introduction: Internal combustion engines have excellent durability. They can use renewable or…

Q: Question 5- Power Network, Frequency & Connected Load a) In the UK and many other countries, there…

A: The legal requirement to maintain the voltage and frequency with permitted tolerances is due to the…

Q: Explain the operation of thermochemical energy storage system.

A: Thermal energy from the sun can be stored as chemical energy in a process called solar…

Q: Airframe Electrical System Question: What is the temperature operating limit of tin-coated…

A: The temperature operating limit of tin-coated copper-stranded electrical wire (600 V rating) is…

Q: 1) What are the things that must be clarified (angles) and others) when drawing a circuit diagram of…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: All information about the parts of protection system (transducer,protective relay,circuit breaker)

Q: arning Portal Courses Reports e-Services Academic Departments ETC CIMS - 1.When lighted, a 100-watt…

Q: A system can be defined as I. A group of the interconnection of subsystems. II. A group of…

Q: 220* A/ 345 A 96145 - 9.1955) 5.2793 - 5.4190) None of the answers 13.2-43.7)

Q: the course is power transmission system... Question : Differentiate between capacitance grading and…

A: Capacitance Grading Capacitance grading is done by employing various layers of different dielectrics…

Q: 6. Discuss the present practice in neutral grounding.

A: The neutral of the system or rotating system or transformer is linked to the ground in a neutral…

Q: Airframe Electrical System Question: By what means should aircraft electrical circuits/wires be…

A: Aircraft electrical circuits/wires should be protected from excessive current by means of Circuit…

Q: Question 2 Not yet answered Which of the following does not use combustion process for Power…

A: Need to find correct option

Q: Predictive maintenance is to be applied to an industrial conveying system. a) Discuss and illustrate…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: B) Discuss the influence of the adding pole / zero to the system.

A: We have to discuss the influence of adding pole / zero to the system.

Q: (b) A 480 V, 100 kW, 50 Hz, four-pole, Y-connected synchronous motor has a rated power factor of…

A: According to the question we have to find input power, output torque mechanical speed, EA, IA ,…

Q: A VCO can be used to construct a phase-locked loop (PLL). Draw a system block diagram with clear…

Q: Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD.…

Q: What is the importance of Code of ethics of Electrical Engineer in students?

A: The Code of Ethics for Electrical Engineers plays a crucial role in shaping the behavior and…

Q: Problem 3: Commutators (.

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In the northeastern Uhited States, In East of geographic north South of geographic north O North of…

A: As per the policy I am able to answer only one question at a time

Q: What are the 8 basic electrical safety analyzer functions

Q: how was the load 300<-36.86 achieved?

A: We know that power factor can be represented in terms of cosine function as shown below.

Concept explainers

Photoelectric

The photoelectric effect occurs when light (or similar incident radiation, including X-rays) falls on material together with a metal plate and causes it to emit electrons. The discovery of the photoelectric effect led to important new theories (and to a Nobel Prize for Albert Einstein). Photoelectric cells, or photocells, are utilized in burglar-alarm light detectors and garage-door openers (each employs a through-beam of light this is broken when something movements throughout it), and also to play soundtracks on film movies (in which a light beam shines through the soundtrack encoded at the film and is "read" with the aid of the photocells).

Question

100%

This question

Determine the output Cp(s) due to the
disturbance D(s), when D(s) = -1/s.
D(s)
R(s)
4
C(s)
2s +1
s+1
Select one:
- 4
Cp(s) =
s (9 s+ 5)
а.
- 5
Cp(s) =
O b.
s (9 s+4)
S+ 2
Cp(s) =
С.
S(9s+7)
- 2
Cp(s) :
O d.
s (9 s+ 5)
S +1
Cp(s) =
s (9 s+4)
е.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

kindly give short and accurate answer. thanks.the course is power transmission system
What cases do we use HVDC for testing?
Question A
How to verify the validity of the nodal analysis technique in solving electrical networks?
A line has a rated current of 1,000 A. Assume that a relay (with a rated current of 5A) is connected to the line through a CT with a ratio of 78. If relay is set to pick up when the line current exceeds 15% of its rated value, the secondary pickup current in per unit will be: (Round the answer to 2 decimal places and don't type the unit)
22)This multiple choice question from MEASUREMENTS INSTRUMENTATIONS course.
Q5(a) i) Explain the major difference between IT and TT earthing systems using sketches with labels. ii) Describe the major difference between TN-C-S system and TN-S earthing systems using sketches with labels.
6. Hi can you please address the question in attached image. Thank you so much have a nice evening.
I need the answer at 20 minute.