Determine the minimum coefficient of static friction ???? which will allow the drum with fixed inner hub to be rolled up the 15o incline at a steady speed without slipping. What are the corresponding values of the force P and the friction force F? Use a mass of 50 kg and a radius r= 0.5 m.

Q: The vertical position of the 165-kg block is adjusted by the screw-activated wedge. Calculate the…

A:

Q: The brake is to be designed to be self locking, that is, it will not rotate when no load P is…

A:

Q: A block of weight W, attached to rigid linkage AB, rests on conveyor belt moving to the left as…

A: The force diagram for the system is,

Q: The tension in a pulley belt is 300 N when stationary. The smaller pulley has a diameter of 300 mm…

A:

Q: The designer is considering a slider at B rather than the usual roller. Determine the critical value…

A:

Q: The truck has a mass of 1.25 Mg and a center of mass at G. The coefficient of static friction…

A: In this problem o have simply used the laws of equilibrium and friction to get the load that the…

Q: The coefficient of static friction between the 65-lb roller and the ground is μ = 0.2. Fins the…

A: Given data: w=65 lbμs=0.2r=3 ft2=1.5 ftP=Pmax=?

Q: The uniform cylindrical drum weighs 250 lbs and is supported by a frictionless roller at A and the…

A: Given data as per question Drum weight =250 lbs Static coefficient of friction =0.3 kinetic…

Q: A filled barrel has dimensions of a = 0.55m, b = 1.1m, and c = 0.6m, a total mass of 108kg, and has…

A:

Q: The tension in a pulley belt is 300 N when stationary. The smaller pulley has a diameter of 300 mm…

A: Introduction In this problem, we will calculate the tension on each side of the belt and the power…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.