Determine the maximum tensile and compressive stresses in portion BC of the beam, under loading conditions of two vertical forces that applied on it. The beam has cross section as shown in figure. 100KN 100KN 200 mem B 25 m 25 mm 150 m 塔mm -1500 mm 500 mm 500 mm

Q: The aluminum machine part is subjected to a moment of M-95 N-m. (Eigure 1) 10 mm 10 mm nm 20 mm 10…

A:

Q: For the vertical flexural member shown, determine the maximum shear stress in MPa at section K, as…

A:

Q: When a steel rod below is subjected to torque (T = 3 kN m) and bending moment (M = 2 kN m)…

A: Write the given data with suitable variables. M=2 kNmT=3kNmd=50 mm

Q: 4 - A rectangular block is loaded with a 180 kN axial force and a moment M, as shown in the figure.…

A: Given data:-  Axial force =180 kN the maximum allowable tensile stress = 50 MPa To find:- the…

Q: Q - The mechanism of bone as a solid rod shown in figure. The diameter is 4 cm and it is subjected…

A: Acting torque on the system = 200 ×0.15 =30 Nm Bending moment at end section = 200 ×0.25 = 50 Nm the…

Q: Problem: Figure shows a frame subjected to a load of 3.4 kN, find the resultant stress at A and B.

A:

Q: Find the shear stress (in psi) exerted on the member shown in the figure if load (V) = 55 6b kips…

A: Problem 1: Given data: Load, V = 55.66 kips = 55.66×1000 = 55660 pounds. Area, A = 105.85 in2…

Q: A simply supported beam (i.e., with a pin support at point A and a roller support at point D) is…

A:

Q: Two vertical forces, each of magnitude P = 22 kips, are applied to a beam of the cross section…

A:

Q: Consider the beam shown in sketch below, hinge supported at point A and roller supported at point D.…

A: Considering the cross-section of the beam The web is denoted as 1 and flange is denoted as 2

Q: Q3) a) Draw the free-body diagram for beam shown in the figure and determine the internal normal…

A:

Q: section shown in figure Question 2, determine the shear stress a. In the Web at point A b. and in…

A:

Q: A hemp rope L = 10 m long and d = 46 mm in diameter is supported from one of the roof beams in a 50…

A:

Q: 120 KN 100 mm H 400 mm B 22m 150 mm Find the shear stress at point H on the beam. The wall thickness…

A:

Q: re= 3cm 300m 20m

A: When a shaft is subjected to torque, shear stress produces in the shaft. The torsion equation is…