Determine the maximum shear and moment for the beam shown below. 2000 lb 400 lb/ft Hinge B C ←4 ft- - 4 ft → 10 ft lb (magnitude only and use up to 3 significant figures) lb.ft (magnitude only and use up to 3 significant figures) A |--4ft - ANSWER: Vmax = Mmax = K D E

Q: Determine the magnitude of the pin force a Assume W = 895 lb, a = 4.8 ft, b = 3.3 ft, r = r W C…

A:

Q: Determine the magnitude of the pin forc Assume W = 845 lb, a = 4.4 ft, b = 3.4 ft, r 1 W C Answer: A…

A: Given: Weight  Distances  Radius  To find: Pin force at A in above figure

Q: etermine resultant internal forces normal shear and moment at points F and G

A: A structure is loaded with a point load at F at the extreme end of DEF bar.The bar DEF is supported…

Q: Determine internal shear, internal normal and internal bending moment at point c   w = 340 lb/ft

A:

Q: For the cantilever beam and loading shown

A: Given: Cantilever beam with below loading conditions: To calculate: Vertical reaction at support A

Q: 9. Determine the minimum axial forces in member CD of the truss given the following loading…

A:

Q: The steel member shown below has a diameter of 69 mm, modulus of elasticity of E = 200 GPa, and is…

A: Given Reaction at B 110 kNSpan 5.8 mTo find out Load P

Q: 3 m Reactions @A Ic Ax = A₁ = MA = Internal Loads @C V = M= N = 3 m ts) s) 8 kN/m 3 m Force lagram…

A:

Q: wo A Questions: 1.4 L At x = 1L, V = At x = 1.7L, V = i i 1.4 L WOL, M = WOL, M = i Wo B i The…

A:

Q: Questions a/b c₁₂=c 200 10 E 5 0.291 m 20 40 289 10 0.312 200 0.323 0.328 10 1. 6.3 kNm torque is…

A: For given data:Torque = 6.3 kN-mLength of the shaft = 3mCross-sectional area, a= 5090 mm2Modulus of…

Q: 4/Use Force Method to assume the support at A is fix, D is hinge

A: Step 1: Given that force act on it is 25 kN /mE = 200 GPa Step 2: Step 3:  Step 4:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.