Determine the MAXIMUM SHEAR and MAXIMUM MOMENTS for using SHEAR AND MOMENT DIAGRAMS OR BY ANALYTICAL METHOD (EQUATION OF SHEAR AND MOMENTS) 40 KN/m -2.0m of 1.0m pour † pin -2.0m H 2.0m 15 KN 60° ↓ + 5 KN/m TAI 25 KN/m 4.0m 2.0m

Q: Draw a single FBD that would allow you to solve for the force in members DG, DF, and EF knowing that…

A: Determine the force in members DG, DF and EF. Let's solve using method of section.

Q: Find determine the negative bending moment on point B, and maximum positive bending moment in span…

A: Find reactions:∑ MA=0RB(6)-P(8)-8(6)(3)=0RB=P(43)+24∑ Fy=0 RA+RB-P-86=0 RA=24-P13

Q: For the system shown below draw Shear Force and Bending Moment diagram using Force Method.

A: Find: Shear Force and Bending moment diagram -Using Force Method

Q: 1. 2. 3. X 2 -2.5 m3.5 m- 2.5 m D 3 m -3 m- A E m P = 8000 N B C 1.0 m Determine the tensile force…

A: To find tension in cable AD,CE

Q: Using PLASTIC ANALYSIS, determine the plastic moment on the given beam below. 7 kN/m 3.5 m O 11 kNm…

A: Number of plastic hinge n = Ds + 1 Ds = Number of reaction force - equilibrium equation = 4 - 2 = 2…

Q: Accurate solution?

A: Step 1:Step 2:Step 3: Step 4:

Q: 7. Determine the moment at the supports. Make at least eight distributions. Use Moment Distribution…

A:

Q: Please solve in moment distribution method A-Fixed C-Roller

A: Given:- To find:- From the given question it is required to solve the frame as shown in figure by…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.