Determine the maximum safe value of W that can be carried by the beam show if the allowable bending stress for tension is 20 MPa and 60 MPa for compression

Q: Determine the maximum shear stress in the strut if it is subjected to a shear force of V = 20 k

A: Given data  Shear force V = 20 k

Q: Consider the beam below. If the beam is subject to a 20kN internal shear force, determine the…

A: shear force , V= 20 KN  thickness of all pieces= 30 mm

Q: eformation sustained by members CG, AF, 12 kips

A: Given:- 8 kips,12kips To find:- deformation sustained by members CG,AF,FG

Q: H.W 2 A steel tee shape is used to support the loads shown on the beam in Figure 2 a. dimensions of…

A: Given data,   Required: (a) the maximum tension bending stress at any location along the beam (b)…

Q: Determine the forces in all bars of the truss in the Figure. If your solution is statically…

A:

Q: The three suspender bars AD, BE, and CF are made of the same material (E = 70 GPa) and have equal…

A: Given Data Three suspender bars are givenCross-sectional area A=450 mm2Young's modulus E=70 GPaTwo…

Q: The rigid bar EFG is supported by the truss system shown. Determine the cross-sectional area of…

A:

Q: For the section shown here made of wood (E1=16Gpa) and steel (E2=200Gpa) calculate the bending…

A: Given:- The section is made up of wood and steel  The elastic modulus of wood = E1 = 16 GPa The…

Q: The force in DB of the truss shown in below figure is W 5m 2W 5m W D O 5 W tension W tension 2 W…

A: We have to determine the value of force in DB of the truss shown in above figure as per the given…

Q: Compute the average normal stress in each member of the truss below. Each member has a circular…

A: Given:Circular cross-section diameter= 0.75 inch Required:Average normal stress in each member

Q: Consider the beam below. If the beam is subject to a 20kN internal shear force, determine the…

A: Given:- V= 20 KN  thickness of all pieces= 30 mm  To find:- The maximum shear stress

Q: For the beam shown below, the ratio of stiffness coefficients k41 and K43 is Assume El is constant.…

A: For the given beam,To find the ratio of stiffness  coefficient

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.