Determine the maximum depth and intensity for:20-min1-hr15-min TimeRainfallCumulative Rainfall(min)(in)rainfall(30-min)50.020.360.020.340.10.040.1910150.462005250.691.171.65300.480.51.171.672.1735400.51.810.5145502.682.842.222.340.160.31553.152.462.64600.663.81

For 15 minutes interval Time Rainfall min in. 0 0 15 0.02 + 0.34 + 0.1 = 0.46 30 0.04 +…

Answered: Determine the maximum depth and…

Engineering

Civil Engineering

Determine the maximum depth and intensity for: 20-min 1-hr 15-min

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Cross-sectional area of the river (sq m) b) Discharge of the river (cu m/sec) c) Average velocity…

A: given- At a certain section of the river to determine a)Cross-sectional area of the river (sq m) b)…

Q: In a two-section flocculation basin, if the inlet velocity gradient is 60 s-1, what would be a…

Q: An orifice is placed at the side of 2 m diameter vertical tank. The center of the orifice is 10 m…

A: Find horizontal velocity :ux=2gHux=2(9.81)(3m)ux=10.95445ms

Q: Point rainfalls due to a storm at several rain-gauge stations in a basin are shown in Figure.…

A: (a). Consider the following table for the calculations: Isohyetal region Rainfall in cm Mean…

Q: Please solve correctly

A: Step 1:Explanation: For the given time step of 2 hours, the inflow into the reservoir is 180 cfs.The…

Q: 2. Calculate the discharge from the stream given that each station is 1.5 m apart, and the depths…

Q: 2- Sketch and label the type of water surface profile in (a), (b) and (c).

Q: 19. What is the vertical reaction at A in KN? a) 475 20. What is the reaction at B in KN? a) 475 b)…

Q: (a) Calculate the critical depth (hint: Froude number definition) in a triangular channel that has…

A: Triangular channel Side slope (m:1) = 2 in 1 Discharge (Q) = 3 m3/s Determine the critical depth…

Q: 0-2 Water flows through a vertical contraction (venturi) section. Piezometers are attached to the…

A: It is required to determine the velocity at minimum area. Using Bernoulli's equation,…

Q: 9. A surface float took 10 sec to travel a straight run of a stream of 20 m. What is the approximate…

A: Given that: Straight run of stream of section of 20 m Time taken by float method 10 second.…

Q: A rapid-mixing basin is to be designed for a water coagulation plant, and the design flow for the…

Q: Base-flow separation is performed A On a unit hydrograph to get the direct-runoff hydrograph B) On a…

A: Base flow is that portion of steamflow which is not a part of runoff.

Question

Determine the maximum depth and intensity for:

20-min
1-hr
15-min

Time
Rainfall
Cumulative Rainfall
(min)
(in)
rainfall
(30-min)
5
0.02
0.36
0.02
0.34
0.1
0.04
0.19
10
15
0.46
20
05
25
0.69
1.17
1.65
30
0.48
0.5
1.17
1.67
2.17
35
40
0.5
1.81
0.51
45
50
2.68
2.84
2.22
2.34
0.16
0.31
55
3.15
2.46
2.64
60
0.66
3.81

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

11:01 Home work 1a.docx Home work 1 1. Calculate the normal depth in a concrete trapezoidal channel with side slope of 1 to 3, a bed slope of 0.00033, a bottom width of 4.0 m and a water discharge of 39 m/s. Manning coefficient is 0.013. 1 4m Example The cross section of the river in flood stage has the dimensions shown below: -30.5 m 30.5 m 1.52 m 1.52 m Estimate the total discharge if Manning's n= 0.05 for the overbank, and 0.03 for the main channel, and the channel slope is 0.00167. Also, what is the mean velocity for each section? II
Describe with appropriate and enough illustation one complete cycle of wave motion in pipe due to sudden closure valve. (You are requested to show direction of flow velocity and wave celerity at specified time periods).
Q) The following data are obtained from the current meter gauging of a stream, at a gauging station. Compute the stream discharge using 1- Mid section method 2- Mean section method. Rating equation of current meter: v = 0.72 N+ 0.144, where N = rev./sec, v=velocity (Km/hr). Distance from Water depth Immersion of current meter below water surface the left bank of river (m) (m) depth (m) revolution sec 10 36 20 40 3. 0.6 0.44 1.76 0.8 3.2 1.6 6.4 0.84 3.36 0.5 2.0 0.72 40 48 50 57 53 59 57 51 49 52 53 2.2 9. 30 12 8 46 33 33 29 34 29 16 15 4.2 18 2.5 21 24 1.2 48
Water at 60° F flows by gravity from a large reservoir at a high elevation to a smaller one at a lower elevation through a 60-ft-long, 2-in-diameter cast iron piping system that includes four 90° flanged elbows, a well-rounded entrance, a sharp-edged exit, and a fully open gate valve. Taking the free surface of the lower reservoir as the reference level, determine the required elevation zi of the higher reservoir if the flow rate is 13 ft/min. Use a= 1.04. l a
A 100mm height cylinder with specific weight of 5kn/m^3 is submerged ina a a fresh water with 9.81kn/m^3 specific weight. Determine the submerged length of the cylinder or depth D. a. 90.82mmb. 50.97mmc. 60.28mmd. 50mm
a) Estimate the atmospheric mixing depth from a ground source (0 m) at ambient temperature (12 °C) from the following readings:Altitude, m 100 200 300 400 500 600 700Temperature, °C 9 10 11 12 13 14 15 b) For the same readings, estimate the mixing depth (or plume rise) from a 50-m elevated source with a temperature of 20°C.
The data pertaining to a stream-gauging operation at a gauging site are given in the table below. The rating equation of the current meter is v=0.450 No + 0.004 m/s where N revolutions per second. Table A Stream-gauging Operation Data Distance from left water edge (m) NAMPI 0.0 1.5 4.5 7.5 10.5 13.5 16.5 18.0 Depth y (m) JOHNN-GO 0.0 0.8 1.5 2.4 2.5 1.4 0.7 0.0 Revolution of current meter kept at 0.6 m depth 0 60 80 130 125 52 42 0 Duration of observation (s) 0 90 90 120 120 60 60 0 -Draw the stream cross-section diving it into appropriate number of segments - Calculate the velocity in each segment - Calculate the area of each segment - Calculate segmental discharge -Determine the total discharge of the streami Write your answers correct to three decimal places. Please upload your own handwritten answer in dropbox.
For Toowoomba, calculate 70 min duration 10% AEP rainfall depth (mm) (151.936,-27 54). Accuracy within 1 decimal place Answer
A mechanical bar screen is to be used in an approach channel with a maximum approach velocity of 1 m/s in a channel with a width of 1.1m. The bars are 15mm thick, and the opening are 25mm wide. Draw a figure and determine the velocity between bars and the head loss when the screen is 40% clogged screens. Head loss coefficient for a clean and clogged bar screens - 0.65 and 0.83 respectively.
A rectangular channel carries a uniform flow with a Froude number of 2.83. The ratio of critical depth to normal depth of this flow is
Hydaway Lake needs to monitor the lake bottom conditions. A contract withEagle Underwater Remote Operated Vehicles (ROV) was established to create a remotelyoperated vehicle. The ROV must be able to determine where it is relative to the sides of thelake. Eagle ROV is using a standard periscope through which a laser measuring system willoperate. The 2.5-m long periscope is attached to the ROV and has an outside diameter of 50mm. The ROV travels at 1 m/sec in water that is 15°C. Based on the assumption that theperiscope is a smooth cylinder determine the moment at the periscope-ROV interface. Thewater is at 15°C.
10-12. Compute the average sound pressure level of the following readings by simple arithmetic averaging and by logarithmic averaging (Equation 10-13) (all readings in dB): 42, 50, 65, 71, and 47. Does arithmetic averaging un- derestimate or overestimate the sound pressure level? Answers: x 55.00 or 55 dB L, = 61.57, or 62, dB