Answered: Determine the magnitude of the… | bartleby

Related questions

Question

100%

Determine the magnitude and direction of the resultant hydrostatic force that the water exerts on the face of AB of the overhang if it is 2 m wide.

Determine the magnitude of the resultant hydrostatic force the water exerts on the
face AB of the overhang if it is 2 m.
B.
143.94 kN
93.67 kN
456.68 kN
O303.15 kN

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Ju Barge floating in freshwater (@=1000 Ing/m³), is shaped as hollow Prism with base area A=350m² & height H=2m. When empty, bottom of barge location Ho = 0.55 m below surface of water. Fully loaded with coal, location H₁ = 1.75 m below surface of water. (a) mass of coal (m₁) in ing? m₁ = ? Ivi Sc (b) how far would barge be submerged (inm) if Mi₂ = 450000.ing. of coal was placed on empty barge? H₂ ?? Qwater = 1000 ng/m 3 A = 350 m² (prism) H= 2 m (prism) H₂ = 0.55m (below surface, empty) H₁ = 1.75m (below surface, full) ΔΔΔΔΔΔΙΔ
(A) What is the pressure drop (in N/m2) due to The Bernoulli Effect as water goes into a 3.50 cm diameter nozzle from a 8.90 cm diameter fire hose while carrying a flow of 35 L/s? (B) To what maximum height (in m) above the nozzle can this water rise? (The actual height would be significantly smaller due to air resistance)
A U-tube open at both ends is partially filled with water (Figure (a)). Oil (p = 750 kg/m³) is then poured into the right arm and forms a column L = 4.53 cm high (Figure (b)). Shield Po Water Oil (a) Determine the difference h in the heights of the two liquid surfaces. (The density of water is 1.00 x 103 kg/m3.) cm (b) The right arm is then shielded from any air motion while air is blown across the top of the left arm until the surfaces of the two liquids are at the same height (Figure (c)). Determine the speed of the air being blown across the left arm. Assume the density of air is 1.29 kg/m. m/s
Gasoline is piped underground from refineries to majorusers. The flow rate is 3.00×10–2 m3 /s (about 500 gal/min), the viscosity of gasoline is 1.00×10–3 (N/m2 ) ⋅ s ,and its density is 680 kg/m3 . (a) What minimum diametermust the pipe have if the Reynolds number is to be less than2000? (b) What pressure difference must be maintainedalong each kilometer of the pipe to maintain this flow rate?
A square steel hatch, hinged at A and controlled by a chain at B, is used to drain water from a tank. The resultant of the force caused by water pressure on the hatch is 55.0 kN and acts perpendicularly to the gate at the location shown. The hatch is of uniform construction and its weight of 2.95 kN can be considered as a load concentrated halfway between A and B. Draw free body diagram on paper. determine the force F required to open the hatch. Match the answers. +53.295 34.5 Moment about A due to the 55 kN force is 1. KNm +51.425 2. Moment about A due the weight is KNm 35.6 3. force F - kN +52.125 4. Not an answer +2.300
A vat contains a mixture of oil and water. The water forms a lower layer which is 0.8 m deep, and above it there is an oil layer 0.3 m thick. The density of water is 1000 kg/m3, and the density of oil is 800 kg/m3. Find the force on a flat door at the bottom of the vessel that has a cross-sectional area of 0.5 m2. The acceleration due to gravity is 9.81 m/s2.
A vertical dam on a large lake is 30 ft tall and 60 ft wide, and the water level is 3 ft below the top of the dam. In the middle of the dam at the very bottom is a gate in the shape of an equilateral triangle 8 ft on a side as shown in the figure below. (Assume a density of water p = 62.4 lb/ft³.) 8 ft 27 ft Find the hydrostatic force (in lb) on the gate. (Round your answer to the nearest integer.) 1 24579 X lb